ページ1に含まれる内容の要旨
3-856-227-12(1)
Mini Hi-Fi
Component System
Operating Instructions
CHC-P33D
© 1996 by Sony Corporation
ページ2に含まれる内容の要旨
Õ Õ Õ Ô Ô L R Ô AM loop aerial connection Chapter 1: Connect the supplied loop aerial to the AM Connecting the and the y terminals. Stereo Setting Use the illustrations below to connect your stereo. If you want to connect any optional Up components to the stereo, see “Connecting Optional Equipment” in Chapter 6. To improve the FM reception Connect an outdoor FM aerial to the FM STEP 1 Connecting the Connecting the Stereo 75Ω terminal, using a 75-ohm coaxial cable Speakers and IEC standard soc
ページ3に含まれる内容の要旨
+ Right satellite speaker Superwoofer AM loop aerial Left satellite speaker FM lead aerial STEP 2 STEP 1 STEP 3 to a wall outlet Do this connection last! Note STEP 3 Connecting the Do not install the woofer close to the unit, and do not place the woofer above or below Power the unit. Otherwise, the vibration from the woofer may cause mechanical noise or Connect the mains lead to a wall outlet “skipping”. after you have made all the above connections. When installing the speakers on either si
ページ4に含まれる内容の要旨
S + continued 2 Use a screw driver to attach the stands display. You need to set the clock to utilise to the wall with four wood screws (not the timer-activated features of your stereo supplied). system. Fastening the speaker DISPLAY stands 1 Fasten the four screws loosely using the supplied wrench. 3,5 1 Wrench 2,4 3 Re-attach the caps and plates to the speaker stands. 1 Press CLOCK SET. Note The hour indication begins flashing. Screw Before attaching the speakers, check the strength of t
ページ5に含まれる内容の要旨
Precautions Troubleshooting For Your Guide If you have any questions or problems concerning your stereo system, please Information If you run into any problem using the consult your nearest Sony dealer. stereo, use the following check list and first check the following points: On safety • The mains lead is connected firmly. •The unit is not disconnected from the AC • The speakers are connected correctly and power source (mains) as long as it is firmly. connected to the wall outlet, even if the S
ページ6に含まれる内容の要旨
To clean the CD CD Player Restoring the Factory When a CD is dirty, clean it with a cleaning cloth. Wipe the CD from the centre out. Settings The disc tray does not close. The CD is not placed correctly. Notes on CD Unplug the mains lead and then plug it •Do not use solvents such as benzene, back into the wall outlet. The CD will not play. thinner, commercially available cleaners, Keep DISPLAY and FUNCTION pressed The CD is dirty. or anti-static spray intended for vinyl LPs. and press TAPE.
ページ7に含まれる内容の要旨
+ Tape player section Mass Approx. 4.8 kg (10 lb 9 oz) !Á CLOCK SET button (6) Recording system !ª TIMER SET button (18) 4-track 2-channel stereo Supplied accessories !£ PLAY MODE button (8, 14) Frequency response AM loop aerial (1) !¢ REPEAT button (9) (DOLBY NR OFF) Remote (1) !° HI-SPEED DUBBING button (15) 40 – 13,000 Hz (±3 dB), Sony SUM-3 (NS) batteries (2) !¤¤ OPEN/CLOSE CD button (7) using Sony TYPE I cassette FM lead aerial (1) 40 – 14,000 Hz (±3 dB), Speaker cords (3) using Sony TYPE
ページ8に含まれる内容の要旨
continued 5 Tape operating buttons 9/( (reverse side/front side) play Index Note buttons A or B lights up when you operate CD p (stop) button Adjusting player or tuner. However, you can ignore 0/) buttons the sound 17 it. DECK SELECT button Aerials 4 6 SYSTEM POWER switch AMS 7 7 SELECT 1 – 5 button (17) CD player 7 8 VOLUME +/– buttons Clock setting 6 Rear Panel Connecting optional equipment 20 Display Window the aerials 4 the power 5 the speakers 4 14 23 56 7 8 the stereo 4 DBFB
