ページ1に含まれる内容の要旨
Thank you for purchasing this SHARP product.
MD COMPACT COMPONENT
To obtain the best performance from this product, please read this
manual carefully. It will guide you in operating your SHARP product.
SYSTEM
MD-E9000H MD Compact Component System consisting of MD-E9000H
(main unit) and CP-E9000H (speaker system).
MODEL
MD-E9000H
OPERATION MANUAL
If you require any advice or assistance regard-
ing your Sharp product, please visit our web-
site www.sharp.co.uk/support.
Customers without internet
ページ2に含まれる内容の要旨
Special Notes WARNINGS NOTES FOR USERS IN THE U.K. AND IRELAND When the ON/STAND-BY button is set at STAND-BY position, mains voltage is The mains lead of this product is fitted with a non-rewireable (moulded) plug incorpo- still present inside the unit. When the ON/STAND-BY button is set at STAND-BY rating a 3A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS position, the unit may be brought into operation by the timer mode or remote 1362 fuse marked or and of the same ra
ページ3に含まれる内容の要旨
Contents MD-E9000H 1 Important Instruction Page Radio Page Special Notes ...................................................................................... 2 Listening to the Radio ......................................................................22 2 Listening to a Memorised Station ...................................................23 General Information Precautions...................................................................................... 4-5 RDS Radio 3 Accessories .......
ページ4に含まれる内容の要旨
Precautions Hold the AC power plug by the head when un- General plugging the unit, as pulling the lead can dam- Please ensure that the equipment is positioned in a well-ventilated area age internal wires. and that there is at least 10 cm (4") of free space along the sides and back. There must also be a minimum of 20 cm (8") of free space on the top of the unit. 10 cm (4”) 10 cm (4”) Do not remove the outer cover, as this may 20 cm (8”) result in electric shock. Refer internal ser- vice to your l
ページ5に含まれる内容の要旨
Precautions (continued) Accessories MD-E9000H 1 Please confirm that the following accessories are included. Care of compact discs Compact discs are fairly resistant to damage, however mistracking can oc- 2 cur due to an accumulation of dirt on the disc surface. Follow the guidelines below for maximum enjoyment from your CD collec- tion and player. 3 Do not write on either side of the disc, particularly the non-label side from which signals are read. Do not mark this surface. 4 Keep your discs aw
ページ6に含まれる内容の要旨
Controls and Indicators Front panel Reference page 01. CD Compartment ......................................................................12, 15 02. Timer Set Indicator ......................................................................... 41 1 03. Remote Sensor ............................................................................... 11 04. MD Compartment ............................................................................17 05. On/Stand-by Button ............................
ページ7に含まれる内容の要旨
Controls and Indicators (continued) MD-E9000H 1 Display 01. Record Indicator24, 41-43 2 02. Record Pause Indicator 03. High Speed Record Indicator 04. CD/MD Repeat Indicator 3 05. RDS Indicator 1 2 3 4 5 6 7 8 9 1011121314 15 16 06. Programme Type Indicator 4 07. Traffic Programme Indicator 08. Traffic Announcement Indicator 09. EON Indicator 5 10. Traffic Information Indicator 11. FM Stereo Mode Indicator 17 18 19 20 21 22 23 24 25 12. FM Stereo Receiving Indicator 6 13. TOC Indicator 14. Over
ページ8に含まれる内容の要旨
Controls and Indicators (continued) Remote Control Reference page 01. Remote Control Transmitter .......................................................... 11 02. On/Stand-by Button 03. Extra Bass Button 04. Video/Auxiliary Button 05. Timer Button....................................................................................41 06. Clock Button ...................................................................................14 07. Tuning Up and Down Buttons ................................
ページ9に含まれる内容の要旨
Controls and Indicators (continued) MD-E9000H 1 Placing the speaker system: There is no distinction between the right and the left speakers. Left speaker Right speaker 2 1 3 4 2 4 5 Speaker connection Connect the black wire to the minus (-) terminal and the red wire to the plus (+) terminal. 6 3 7 Speaker System 01. Tweeter Red 8 02. Woofer Black 03. Bass Reflex Duct Caution: 9 04. Speaker Terminals Connect the speaker wires to the speakers first, then to the unit. Use speakers with an impedance
ページ10に含まれる内容の要旨
System Connections Aerial connection Supplied FM aerial: Connect the FM aerial wire to the FM 75 OHMS socket and position it in the direction where the strongest signal can be received. Supplied AM loop aerial: Connect the AM loop aerial wire to the AM LOOP socket. Position the AM loop aerial for optimum reception. Place the AM loop aerial on a shelf, etc., or attach it to a stand AM loop aerial FM aerial or a wall with screws (not supplied). Note: Placing the aerial on the unit or near the AC p
ページ11に含まれる内容の要旨
Remote Control MD-E9000H 1 Battery installation Test of the remote control 1. Remove the battery cover. Face the remote control directly to the remote sensor on the unit. 2 2. Insert the batteries according to the direction indicated in the bat- tery compartment. The remote control can be used within the range shown below: When inserting or removing the batteries, push them towards the ter- Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy the 3 minals. music. 3. Replace
ページ12に含まれる内容の要旨
General Control Demonstration mode The first time the unit is plugged in, the unit will enter the demonstration mode. You will see words scroll. To cancel the demonstration mode: When the unit is in the power stand-by mode (demonstration mode), press the DIS- PLAY (DEMO) button. The unit will enter the low power consumption mode. To return to the demonstration mode: When the unit is in the power stand-by mode, press the DISPLAY (DEMO) button again. To turn the power on Press the ON/STAND-BY butt
ページ13に含まれる内容の要旨
Sound Control MD-E9000H 1 Adjusting the volume W X Press the VOLUME button to increase the volume and the VOLUME button for 2 decreasing. 0 1 239 MAXIMUM 3 Bass control 4 When the power is first turned on, the unit will enter the extra bass mode which emphasises the bass frequencies, and “BASS” will appear. To cancel the extra bass mode, press the X-BASS button. 5 Bass is emphasised. Cancelled. The “X-BASS” function is only accessible with the equaliser set to “FLAT”. 6 Equaliser 7 When the EQ
ページ14に含まれる内容の要旨
Setting the Clock 5/3 5/3 5/3 5/3 5/3 2/4 2/4 2/4 2/4 2/4 3 Press the or button to adjust the hour and then press the MEMORY/ENTER button. When the 12-hour display is selected, “AM” will change automatically to “PM”. 4 Press the 5/3 5/3 5/3 5/3 5/3 or 2/4 2/4 2/4 2/4 2/4 button to adjust the minutes and then press the MEMORY/ENTER button. The hour will not advance even if minutes advance from “59” to “00”. The clock starts from “0” second. (Seconds are not displayed.) To check the time when t
ページ15に含まれる内容の要旨
Listening to a CD MD-E9000H 1 1 Press the ON/STAND-BY button to turn the power on. 2 2 Press the CD button. If no disc is loaded, “CD NO DISC” will appear. 3 3 Press the CD 7 7 7 7 7 (OPEN/CLOSE) button to open the CD compart- ment. 4 4 Place a CD on the spindle, label side up. 5 6 7 7 7 7 7 7 5 Press the CD (OPEN/CLOSE) button to close the CD compart- 8 ment. 9 Total number of tracks Total playing time 06 06 06 06 06 6 Press the CD button to start playback from track 1. 10 When the last
ページ16に含まれる内容の要旨
Listening to a CD (continued) To remove the CD: To locate the beginning of a track 7 Whilst in the stop mode, press the CD (OPEN/CLOSE) button. Press the CD eject button and remove the CD. To move to the beginning of the next track: Press the 4 button for less than 0.5 seconds during playback. You can skip to any track by pressing the 4 button repeatedly until the de- sired track number appears. PUSH To restart the track being played: Press the 5 button for less than 0.5 seconds during playback
ページ17に含まれる内容の要旨
Listening to a MiniDisc MD-E9000H 1 1 Press the ON/STAND-BY button to turn the power on. 2 2 Press the MD button. 3 3 Load a MiniDisc into the MD compartment, label side up. 4 5 6 7 8 9 Disc name 10 Total number of tracks Total playing time The disc name will be displayed only when it has been programmed, and then the total number of tracks and the total playing time on the MiniDisc 11 will be displayed. 06 06 06 06 06 4 Press the MD button to start playback. 12 If the MiniDisc has track name
ページ18に含まれる内容の要旨
Listening to a MiniDisc (continued) To interrupt playback: To locate the beginning of a track 06 Press the MD button. 06 To resume playback from the same point, press the MD button again. To move to the beginning of the next track: Press the 4 4 4 4 4 button for less than 0.5 seconds during playback. To stop playback: Press the MD button. You can skip to any track by pressing the 4 button repeatedly until the de- sired track number appears. To remove a MiniDisc: To restart the track being
ページ19に含まれる内容の要旨
Programmed Play MD-E9000H 1 You can choose up to 20 out of 99 tracks for playback in the order you like. H H H H H H H H H H 5 Press the CD or MD button. 2 Total number of tracks Total playback time 3 06 06 06 06 06 06 06 06 06 06 6 Press the CD or MD button to start playback of the pro- grammed selections. 4 After all of the programmed tracks have finished, the unit will automatically stop. 5 To clear the programmed selections: Press the CLEAR/DELETE button on the remote control whilst the
ページ20に含まれる内容の要旨
Direct Play Repeat or Random Play You can select the CD or MD playback mode; “Repeat play”, “Random play” and “Normal play”. 1 When in the CD or MD mode, press the P-MODE button on the remote control repeatedly to select the playback mode. Normal playback mode Repeat playback mode Random playback mode 2 Press the CD 06 06 06 06 06 or MD 06 06 06 06 06 button to start playback. To repeat a programmed sequence: Perform steps 1 - 5 in the “Programmed Play” section and then select the repeat playbac
