ページ1に含まれる内容の要旨
AUDIO/VIDEO CONTROL RECEIVER
AUDIO/VIDEO-RECEIVER MIT STEUEREINHEIT
AMPLI/TUNER DE COMMANDE AUDIO/VIDEO
GEINTEGREERDE AUDIO/VIDEO-VERSTERKER
RECEPTOR DE CONTROL DE AUDIO/VÍDEO
RICEVITORE DI CONTROLLO AUDIO/VIDEO
RX-530RBK
TV
/I
TV VCR AUDIO
/VIDEO
PRESET SEA MODE
CH+ 12 3
TEST DELAY SURR MODE
CH– 45 6
–+ REAR
CD 7/P 8 9
MASTER VOLUME
–+ CENTER
TAPE CD-DISC 10 +10
RX-530R AUDIO/VIDEO CONTROL RECEIVER TUNER/BAND PRESET SEA SOURCE SURROUND ADJUST SETTING
AUDIO
SEA
SURROUND
FM/AM CONTROL ON/
ページ2に含まれる内容の要旨
Warnings, Cautions and Others/Warnung, Achtung und sonstige Hinweise/ Mises en garde, précautions et indications diverses/Waarschuwingen, voorzorgen en andere mededelingen/Avisos, precauciones y otras notas/ Avvertenze e precauzioni da osservare IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or
ページ3に含まれる内容の要旨
CAUTION VOORZICHTIG To reduce the risk of electrical shocks, fire, etc.: Ter vermindering van gevaar voor brand, elektrische schokken, enz.: 1. Do not remove screws, covers or cabinet. 1. Verwijder geen schroeven, panelen of de behuizing. 2. Do not expose this appliance to rain or moisture. 2. Stel dit toestel niet bloot aan regen of vocht. ACHTUNG PRECAUCIÓN Zur Verhinderung von elektrischen Schlägen, Brandgefahr, usw: Para reducir riesgos de choques eléctricos, incendio, etc.: 1. Keine Schraub
ページ4に含まれる内容の要旨
Caution –– POWER switch and STANDBY/ON button! Voorzichtig –– POWER en STANDBY/ON schakelaars! Dit apparaat is voorzien van een POWER hoofdschakelaar om het This apparatus is provided with a POWER switch to be able to apparaat gebruiksklaar te zetten, maar te zorgen dat het stroomverbruik minimize power consumption for safe use. Therefore, minimaal blijft. Neem in verband hiermee het volgende in acht: 1. When doing initial setting, complete all the connections required, 1. Bij de eerste ingebrui
ページ5に含まれる内容の要旨
Caution: Proper Ventilation Voorzichtig: Zorg Voor Goede Ventilatie To avoide risk of electric shock and fire and to protect from damage. Om gevaar voor brand of een elektrische schok te voorkomen, dient u Locate the apparatus as follows: bij opstelling van het apparaat op de volgende punten te letten: Front: No obstructions open spacing. Voorkant: Voldoende ruimte vrij houden. Sides: No obstructions in 10 cm from the sides. Zijkanten: Minstens 10 cm aan weerszijden vrij houden. Top: No obstruct
ページ6に含まれる内容の要旨
Table of Contents Switches, Buttons and Controls................................................................................................ 2 Getting Started........................................................................................................................... 3 Before Installation .................................................................................................................... 3 Checking the Supplied Accessories .......................................
ページ7に含まれる内容の要旨
Switches, Buttons and Controls Become familiar with the buttons and controls on the receiver before use. 1 2 3 4 56 7 8 9 p q w e r MASTER VOLUME RX-530R AUDIO/VIDEO CONTROL RECEIVER TUNER/BAND PRESET SEA SOURCE SURROUND ADJUST SETTING –+ MEMORY ONE TOUCH OPERATION DISPLAY MODE TA/ NEWS /INFO EON PTY SEARCH STANDBY POWER PHONES SPEAKERS 12 ENHANCED COMPULINK CONTROL SYSTEM _ON ÑOFF _ON ÑOFF STANDBY/ON ty o ; u i Refer to the pages in parentheses for details. Front Panel Remote Control 1
ページ8に含まれる内容の要旨
Getting Started This section explains how to connect stereo components and speakers to the receiver, and how to connect the power supply. Before Installation General • Be sure your hands are dry. • Turn the power off to all components. • Read the manuals supplied with the components you are going to connect. Locations • Install the receiver in a location that is level and protected from moisture. • The temperature around the receiver must be between –5˚ and 35˚ C (23˚ and 95˚ F). • Make sure the
ページ9に含まれる内容の要旨
Connecting the FM and AM (MW/LW) Antennas FM Antenna Connections A Using the Supplied FM Antenna A B The FM antenna provided can be connected to the FM 75- ohm COAXIAL terminal as temporary measure. B Using the Standard Type Connector (Not Supplied) A standard type connector (IEC or DIN45325) should be connected to the FM 75-ohm COAXIAL terminal. Note: Make sure the antenna conductors do not touch any other terminals, connecting cords or power cord. This could cause poor reception. Extend the su
ページ10に含まれる内容の要旨
Connecting the Speakers You can connect the following speakers: • Two sets of front speakers to produce normal stereo sound • One set of rear speakers to enjoy the surround effect • One center speaker to produce more effective surround effect (to make human voices outstanding) • One subwoofer to enhance the bass For each speaker (except for subwoofer), connect one end of the speaker signal cable (not supplied) to the speaker terminal on the rear panel and the other end to the speaker. (For conn
ページ11に含まれる内容の要旨
About the speaker impedance of the speakers CAUTION: When connecting speakers, use speakers with the same SPEAKER IMPEDANCE indicated by the speaker terminals. Notes: • The required speaker impedance of the front speakers does not differ depending on whether both the FRONT SPEAKERS 1 and FRONT SPEAKERS 2 terminals are used or only one of them is used. • The required speaker impedance of the front speakers differs depending on whether or not a center and/ or rear speakers are connected at the sam
ページ12に含まれる内容の要旨
Connecting the subwoofer speaker Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cable with RCA pin plugs. SUBWOOFER
OUT Powered subwoofer Connecting Audio/Video Components You can connect the following components to the receiver using cables with RCA pin plugs. Audio Components Video Components • Turntable • VCR • CD player • Video disc player • Cassette deck • TV Note: Any turntables incorporating a small-output cartridge such as an MC (mo
ページ13に含まれる内容の要旨
Video component connections MONITOR
OUT To video input VIDEO OUT
IN
(REC) (PLAY) VCR VIDEO PHONO CD TAPE OUT
IN
OUT
IN
(REC) (PLAY) (REC) (PLAY) LEFT TV AUDIO RIGHT To audio/video input VHS To audio/video output VCR To audio/video output Video disc player CAUTION: If you connect a sound-increasing device such as a graphic equalizer between the source components and the receiver, the sound output through the receiver may be distorted. Connecting Audio Components for the COMPU LINK-3 Remot
ページ14に含まれる内容の要旨
Connecting the Power Cord Before plugging the receiver into an AC outlet, make sure that all connections have been made. 1. Plug the power cord into an AC outlet. POWER 2. Press POWER to set it in the _____ON position. The STANDBY lamp lights up. A small amount of power is always consumed. _ON ÑOFF To shut off the power completely: Press POWER to set it in the ÑOFF position. Keep the power cord away from the connecting cables for the TV, VCR, and antenna. The power cord may cause noise or scre
ページ15に含まれる内容の要旨
Basic Operations The following operations are commonly used when you play any sound source. Turning the Power On and Off (Standby) On the front panel: STANDBY To turn on the power, press STANDBY/ON . The STANDBY lamp goes off. The name of the current source (or station frequency) appears on the display. STANDBY/ON L R MUTE TUNED SLEEP SEA AUTO STEREO PRO LOGIC 3CH LOGIC HALL LOUDNESS VOLUME TA NEWS MHz CH- kHz INFO Current source name appears Current volume level is shown here STANDBY T
ページ16に含まれる内容の要旨
Selecting the Front Speakers When you have connected two sets of front speakers, you can select which to use. Pressing SPEAKERS 1 or SPEAKERS 2 activates the respective set of speakers. SPEAKERS To use the set of speakers connected to the FRONT SPEAKERS 1 terminals, press SPEAKERS 1 to set 12 it in the _ON position, and press SPEAKERS 2 to set it in the ÑOFF position. To use the set of speakers connected to the FRONT SPEAKERS 2 terminals, press SPEAKERS 2 to set _ON ÑOFF it in the _ON position
ページ17に含まれる内容の要旨
Recording a Source You can record any source playing through the receiver to a cassette deck connected to the TAPE jacks and VCR connected to the VCR jacks at the same time. While recording, you can listen to the selected sound source at whatever sound level you like, without affecting the sound levels of the recording. Note: The output volume level, preset SEA, and surround modes cannot affect the recording. Listening with Headphones A standard pair of headphones can be connected to the PHONES
ページ18に含まれる内容の要旨
Basic Settings Some of the following settings are required after connecting and positioning your speakers in your listening room, while others will make operations easier. Adjusting the Front Speaker Output Balance SETTING If the sounds you hear from the front right and left speakers are unequal, you can adjust the speaker output balance. On the front panel only: 1. Press SETTING so that the Control %%% / ÞÞÞ / @@@ / ### buttons work for adjusting the balance. %% ÞÞ @@ ## The lamp above the butt
ページ19に含まれる内容の要旨
When the shut-off time comes, the receiver turns off (into standby mode) automatically. SETTING To check or change the time remaining until the shut-off time: 1. Press SETTING if necessary, so that the Control % / Þ / @ / # buttons work for setting the Sleep Timer. 2. Press Control % / Þ if necessary, until “” appears on the display. 3. Press Control @ / #. The remaining time until the shut-off time appears in minutes. • To change the shut-off time, press Control @ / # repeatedly. To canc
ページ20に含まれる内容の要旨
One Touch Operation This receiver can memorize the optimum sound setting for each playing source. About the One Touch Operation JVC’s One Touch Operation function is used to assign and store different sound settings for each different playing source. By using this function, you do not have to change the settings every time you change the source. The stored settings for the newly selected source are automatically recalled. The following can be stored for each source: • Volume level (see page 11)
