ページ1に含まれる内容の要旨
UCA
RX-V3000
Natural Sound AV Receiver
Ampli-Tuner Audio-Video
VOLUME
INPUT
INPUT MODE
NATURAL SOUND AV RECEIVER RX–V3000
STANDBY
/ON
SPEAKERS SOURCE PRESET TUNING
A B /REMOTE EFFECT /TUNING FM/AM MEMORY MODE
DVD MD/TAPE
SILENT D-TV/LD CD-R
MAN'L/AUTO FM AUTO/NAN'L MONO
CABLE TUNER EDIT
SAT CD S VIDEO VIDEO L AUDIO R OPTICAL
BASS 6CH DSP
PROCESSOR
EXTENSION DIRECT VCR 1 PHONO INPUT PROGRAM
PHONES VCR 2/DVR
VIDEO AUX
BASS TREBLE REC OUT/ZONE 2 VIDEO AUX
OWNER'S MANUAL
MODE D'EMPLOI
ページ2に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS 8 Ventilation – The unit should be situated so that its location or position does not interfere with its proper ventilation. For CAUTION example, the unit should not be situated on a bed, sofa, rug, or RISK OF ELECTRIC SHOCK similar surface, that may block the ventilation openings; or DO NOT OPEN placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation CAUTION: TO REDUCE THE RISK OF openings. ELECTRIC
ページ3に含まれる内容の要旨
EXAMPLE OF ANTENNA GROUNDING Note to CATV system installer: This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable MAST ANTENNA ground shall be connected to the grounding system of the LEAD IN WIRE building, as close to the point of cable entry as practical. GROUND CLAMP ANTENNA DISCHARGE UNIT (NEC SECTION 810–20) ELECTRIC SERVICE EQUIPMENT GROUNDING CONDUCTOR
ページ4に含まれる内容の要旨
CAUTION: READ THIS BEFORE OPERATING THIS UNIT. 1 To assure the finest performance, please read this manual 18 Before moving this unit, press STANDBY/ON to set this unit carefully. Keep it in a safe place for future reference. in the standby mode, and disconnect the AC power plug from the wall outlet. 2 Install this unit in a well ventilated, cool, dry, clean place with at least 30 cm on the top, 20 cm on the right and left, and 10 cm at the back of this unit for ventilation space — away from Thi
ページ5に含まれる内容の要旨
English Contents Introduction 2 Getting Started.......................................................................................................... 3 Controls and Functions............................................................................................. 4 Preparations 8 Speaker System Configurations ............................................................................... 9 Hookups ...........................................................................................
ページ6に含まれる内容の要旨
Introduction Welcome to the exciting world of digital home entertainment. This unit is the most complete and advanced AV receiver available. Though some of the more advanced features of this unit may not be familiar to you, they are easy to use. Incorporated state-of-the-art technology such as Dolby Digital and DTS can bring the same audio experience to your home as they have brought to feature films in quality theaters around the world. To make the listening experience even more enjoyable, this
ページ7に含まれる内容の要旨
English Getting Started Checking the Package Contents Check your package to make sure it has the following items. RL FM Antenna Alkaline Batteries (3) (LR6) (Australia and Singapore Side Panel Sticker AM Loop Antenna models only) Quick Reference Card n Remote Control n TUNER button (TUNER area) n CD button (CD area) Infrared window POWER CLEAR LEARN RE-NAME MACRO (Set 10KEY) DISPLAY TRANSMIT MACRO ON/OFF SEARCH STANDBY Skip Search SYSTEM POWER A button POWER STOP Input buttons PLAY PAUSE (/Stop
ページ8に含まれる内容の要旨
Controls and Functions Front Panel When you are not operating the controls behind the front panel door, close the door. To open the door, press gently on the lower part of the panel. 1 q 0 w e MEMORY TUNED STEREO AUTO BASS P.DIRECT 4 ZONE 2 SLEEP 2 3 8 7r9 2 5 6 3 5 1 4 VOLUME INPUT INPUT MODE NATURAL SOUND AV RECEIVER RX–V3000 MEMORY TUNED D-TV/LD DVD CABLE MD/TAPE STEREO AUTO SAT CD-R STANDBY VCR 1 TUNER /ON VCR2/DVR CD BASS P.DIRECT V-AUX PHONO ZONE 2 SLEEP SP
ページ9に含まれる内容の要旨
English Controls and Functions q TREBLE t VIDEO AUX Adjusts the high frequency response for the left and right Main Inputs audio and video signals from a portable external source channels. Turn the control to the right to increase the high such as a video camera. To reproduce source signals from these frequency response. jacks, select V-AUX as the input source. To direct this source to the VCR 1 and VCR 2/DVR output jacks, select VIDEO w REC OUT/ZONE 2 AUX using REC OUT. Selects the source you w
ページ10に含まれる内容の要旨
Controls and Functions Rear panel 3 71 2e 5 0 TUNER R L R L CAUTION SEE INSTRUCTION MANUAL FOR CORRECT SETTING. AM OPTICAL MD/TAPE ANT – GND L R FM ANT 75Ω UNBAL. R L REMOTE IMPEDANCE SELECTOR SET BEFORE POWER ON FRONT : 6ΩMIN./SPEAKER REAR : 4ΩMIN./SPEAKER REAR CENTER : 4ΩMIN./SPEAKER CENTER : 4ΩMIN./SPEAKER MAIN A OR B : 4ΩMIN./SPEAKER A + B : 8ΩMIN./SPEAKER FRONT : 8ΩMIN./SPEAKER REAR : 8ΩMIN./SPEAKER CENTER REAR CENTER : 8ΩMIN./SPEAKER CENTER : 8ΩMIN./SPEAKER MAIN A OR B : 8ΩMIN.
ページ11に含まれる内容の要旨
English Controls and Functions Remote Control g 9 Operational buttons Performs the operation selected by input selector. 4 1 2 5 0 Sound program selector/Numeric buttons 3 6 Selects the sound program. y u k q MUTE 7 Mutes the sound. Press again to restore audio output at the previous volume level. 8 w VOLUME +/– i Increases or decreases the volume level. o e EFFECT h Switches the effect speakers (Center, Front, Rear, and Rear Center) on and off. r PARAMETER/SET MENU p Selects the PARAMETER mode
ページ12に含まれる内容の要旨
Preparations Speaker System Configurations 9 Hookups 10 Connecting Audio Components ............................................................................. 10 Connecting Video Components ............................................................................. 12 Connecting Speakers .............................................................................................. 14 Connecting Subwoofers ......................................................................................
ページ13に含まれる内容の要旨
English Speaker System Configurations The most complete speaker configuration consists of eight speakers: the left and right Main speakers, a Center speaker, the left and right Rear speakers, the left and right Front Effect speakers, and a Rear Center speaker. If you do not use eight speakers, you can direct the signals for speakers that are not in your system to other speakers in your configuration. A Subwoofer can be used with any of these configurations to produce a fuller sound. Front Effect
ページ14に含まれる内容の要旨
Hookups Connecting Audio Components Before you connect any components, disconnect the power supply to all the components you plan to connect including this unit and determine which jacks are for the left and right channels and for input and output. When you connect other YAMAHA audio component (such as a CD player or changer, MD deck, or tape deck), connect to terminals with the same number labels. Yamaha applies this labelling system to all its products. In the hookup illustrations on the follo
ページ15に含まれる内容の要旨
English L R L R L R L R Hookups OPTICAL MD/TAPE INPUT recorder INPUT OUTPUT R L L R OUTPUT (Singapore model) CD recorder INPUT OPTICAL OPTICAL OPTICAL INPUT OUTPUT OUT (REC) OUT (REC) OPTICAL OPTICAL OUTPUT OUTPUT CD player COAXIAL OUTPUT CENTER ZONE 2 OUT CTRL OUT +5V 100Ω 20mA OUTPUT Turntable to/from External GROUND Amplifier to/from External Controller from External Decoder 11
ページ16に含まれる内容の要旨
Hookups Connecting Video Components Before you connect any components, disconnect the power supply to all the components you plan to connect including this unit and determine which jacks are for the left and right channels and for input and output. After you finish all hookups, check them again to make sure they are correct. n About the video jacks There are three types of video jacks. Video signals input through the VIDEO jacks are the conventional composite video signals. Video signals input t
ページ17に含まれる内容の要旨
English L R L R Hookups COMPONENT OUTPUT S VIDEO OPTICAL OUTPUT OUTPUT DVD player VIDEO OUTPUT AUDIO OUTPUT L R COMPONENT
ページ18に含まれる内容の要旨
Hookups Connecting Speakers This section explains how to connect speakers to this unit. After you finish connecting your speakers, use the SET MENU to change the signal output settings according to the number and size of the speakers in your configuration. Before connecting any speaker cords, identify which terminals are for the right and left channels and also the + and – polarities. If you connect speakers with the wrong polarity (+ to –), this unit will not reproduce clear sound. n Using spea
ページ19に含まれる内容の要旨
English Hookups Right Front Left Front Speaker Speaker Right Rear Left Rear Speaker Speaker Rear Center Speaker (Singapore model) TUNER CAUTION SEE INSTRUCTION MANUAL FOR CORRECT SETTING. AM ANT – GND FM ANT 75Ω UNBAL. To other component IMPEDANCE SELECTOR SET BEFORE POWER ON FRONT : 6ΩMIN./SPEAKER REAR : 4ΩMIN./SPEAKER REAR CENTER : 4ΩMIN./SPEAKER CENTER : 4ΩMIN./SPEAKER MAIN A OR B : 4ΩMIN./SPEAKER A + B : 8ΩMIN./SPEAKER FRONT : 8ΩMIN./SPEAKER REAR : 8ΩMIN./SPEAKER REAR CENTER : 8Ω
ページ20に含まれる内容の要旨
Hookups Connecting Subwoofers n Connecting a front subwoofer L R Connect the signal input jack on your subwoofer to one of the PRE OUT/ MAIN IN SUBWOOFER jacks. Notes: • The SUBWOOFER jacks (output) have a built-in high cut-off filter (90 Hz). When CENTER using a powered subwoofer, set the high cut-off frequency to “MAX” on your Subwoofer. R L • Both SUBWOOFER jacks output the same signal. Subwoofer system n Connecting a rear subwoofer Subwoofer system By using both Front and Rear Subwoofers, t
