ページ1に含まれる内容の要旨
RX-V2090
Natural Sound Stereo Receiver
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
OWNER’S MANUAL
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO
Contents
QUALIFIED SERVICE PERSONNEL.
IMPORTANT!
PROFILE OF THIS UNIT ............................ 6
Please record the serial number of this
unit in the space below.
• Explanation of Graphical Symbols
SPEAKER SETUP FOR THIS UNIT ........... 7
Model:
CONNECTIONS ....
ページ2に含まれる内容の要旨
SAFETY INSTRUCTIONS 1 Read Instructions — All the safety and operating A. The power-supply cord or the plug has been damaged; or instructions should be read before the unit is operated. B. Objects have fallen, or liquid has been spilled into the 2 Retain Instructions — The safety and operating unit; or instructions should be retained for future reference. C. The unit has been exposed to rain; or 3 Heed Warnings — All warnings on the unit and in the D. The unit does not appear to operate normally
ページ3に含まれる内容の要旨
CAUTION: READ THIS BEFORE OPERATING YOUR UNIT 1 To ensure the finest performance, please read this 6 Do not attempt to clean the unit with chemical solvents; manual carefully. Keep it in a safe place for future this might damage the finish. Use a clean, dry cloth. reference. 7 Always set the volume control to “– ¥ ” before starting 2 Install your unit in a cool, dry, clean place – away from the audio source play: increase the volume gradually to windows, heat sources, and too much vibration, dus
ページ4に含まれる内容の要旨
SUPPLIED ACCESSORIES After unpacking, check that the following parts are contained. • Remote Control Transmitter • Indoor FM Antenna Main Remote Room 2 Remote SKIP PHONO TRANSMIT USER /LEARN YPC LEARN CD DISC SKIP PAUSE/STOP PLAY POWER SLEEP TV VCR AUX — TUNER PRESET + A B C D E SKIP PHONO DISC SKIP TAPE 1 DIR A DIR B PLAY SEARCH PAUSE/STOP PLAY CD STOP TAPE 2 DECK A/B PRESET A B C D E TUNER — + SEARCH STOP PLAY TAPE 1 DECK A/B PAUSE/STOP PLAY LD/TV REC MUTE REC/PAUSE DIR A DIR B TAPE 2
ページ5に含まれる内容の要旨
Features • Seven Speaker Configuration Main: 100 W + 100 W (8W ) RMS Output Power, 0.015% THD, 20-20,000 Hz 120 W + 120 W (6W ) RMS Output Power, 0.04% THD, 20-20,000 Hz (USA Model Only) Center: 100 W (8W ) RMS Output Power, 0.015% THD, 1 kHz Front: 35 W + 35 W (8W ) RMS Output Power, 0.08% THD, 1 kHz Rear: 35 W + 35 W (8W ) RMS Output Power, 0.08% THD, 1 kHz • Multi-Room Capability Multi-Room and Multi-Source with two Remote Control Units • Digital Sound Field Processor 10 Programs including “C
ページ6に含まれる内容の要旨
PROFILE OF THIS UNIT You are the proud owner of a Yamaha stereo receiver –an extremely sophisticated audio component. The Digital Sound Field Processor (DSP) built into this unit takes full advantage of Yamaha’s undisputed leadership in the field of digital audio processing to bring you a whole new world of listening experiences. Follow the instructions in this manual carefully when setting up your system, and this unit will sonically transform your room into a totally new listening environment
ページ7に含まれる内容の要旨
SPEAKER SETUP FOR THIS UNIT SPEAKERS TO BE USED This unit is designed to provide the best sound-field quality with a seven speaker configuration. The speakers to be used with this unit will be main speakers, front speakers, rear speakers, and a center speaker. The main speakers are used for the main source sound. These are usually a much larger, high-quality loudspeaker than you will use for the surround sound effects. The center speaker is used for the center sound (dialog, etc.) encoded with t
ページ8に含まれる内容の要旨
SPEAKER PLACEMENT The recommended speaker configuration, the seven-speaker configuration, will require three speaker pairs: main speakers, front speakers, and rear speakers, plus a center speaker. When you place these speakers, refer to the following: Front R Main: In normal position. (The position of a standard stereo speaker setup) Front: Placed much further apart than the Main speakers, Front L Main R facing slightly inwards. Nearly six feet (approx. 1.8 m) up from the floor. Center Center:
ページ9に含まれる内容の要旨
CONNECTIONS CAUTION Before attempting to make any connections to or from this unit, be sure to first switch OFF the power to this unit and to any other components to which connections are being made. CONNECTIONS WITH OTHER COMPONENTS When making connections between this unit and other components, be sure all connections are made correctly, that is to say L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. Also, refer to the owner’s manual for each component to be connected to this unit. Tu
ページ10に含まれる内容の要旨
CONNECTING SPEAKERS Connect the respective speakers to this unit as shown below: Front speakers Main speakers A Right Left Rear speakers Right Left Right Left SPEAKERS FRONT REAR OUTPUT FRONT OUT LOW CENTER PASS OUT 8W MIN. /SPEAKER 8W MIN. /SPEAKER REAR fo:200Hz OUT CENTER A CC B DD C C+D A OR B: 5W MIN. /SPEAKER C: 8W MIN. /SPEAKER A+B:l2W MIN. /SPEAKER C+D: 4W MIN. /SPEAKER Right Left Center speaker(s) Main speakers B Note on main speaker connection: Note: One or two speaker systems can be co
ページ11に含まれる内容の要旨
ABOUT THE ACCESSORY TERMINALS OUTPUT FRONT OUT LOW CENTER 3 PASS OUT 4 1 REAR fo:200Hz OUT 2 1LOW PASS terminal 3FRONT OUTPUT terminals This terminal is for output to a monaural amplifier These terminals are for front channel line output. driving a subwoofer. Frequencies above 200␣ Hz are There is no connection to these terminals when filtered out so that only the bass range remains. you use the built-in amplifier. The output signal is from the main and center However, if you drive front speaker
ページ12に含まれる内容の要旨
A TAPE 2 REC LD/TV MONITOR OUT MAIN OUT ON 5ch 5CH MAIN LD/TV FRONT DISCRT 5 0 IN CENTER MIX INPUT OFF7ch MAIN CH PRE LD/TV 9 6 OUT SURROUND 0dB MAIN AUDIO VIDEO IN OUT 7 LEVEL PRE OUT OUT -10dB ROOM 2 OUT REMOTE CONTROL 8 5MAIN␣ CH — MAIN␣ IN terminals 9REMOTE CONTROL — IN, OUT terminals These terminals are for line input to the built-in IN This terminal receives the commands from main channel amplifier. Leave the jumper bars the Room 2 Remote transmitter. connected to the PRE␣ OUT terminals wh
ページ13に含まれる内容の要旨
CONNECTING S␣ VIDEO TERMINALS If your video cassette recorder, video disc player, monitor, etc., is equipped with “S” (high-resolution) video terminals, connect them to this unit’s S␣ VIDEO terminals. Otherwise, use the composite video terminals of the unit. Note: • If video signals are sent to both the S␣ VIDEO input and composite input terminals, the input signals will be sent to the respective S␣ VIDEO output and composite output terminals independently. VIDEO SIGNAL VIDEO S VIDEO IN VCR 1 OU
ページ14に含まれる内容の要旨
CONNECTING TO ROOM 2 EQUIPMENT With the Room 2 Remote transmitter you can select a different sound and video source for a second room. To use the multi-room functions of this unit you need the following additional,optional products: • An infrared signal receiver for the second room. (WCX-10) • Master Zone Controller (MCX-10) • An infrared emitter in the main room. (IRX-10/20) This emitter transmits the infrared signals from the Room 2 Remote transmitter in the second room to the other components
ページ15に含まれる内容の要旨
ANTENNA CONNECTIONS • Each antenna should be connected to the designated terminals correctly, referring to the following diagram. • Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signal strength. Nevertheless, a properly installed outdoor antenna will give clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may result in improvement. Outdoor AM antenna Outdoor FM antenna AM loo
ページ16に含まれる内容の要旨
ADJUSTMENT BEFORE OPERATION SPEAKER BALANCE ADJUSTMENT This procedure lets you adjust the sound output level balance between the main, front, center, and rear speakers using the built-in test tone generator. With this adjustment, the sound output level heard at the listening position will be the same from each speaker. This is important for the best performance of the digital sound field processor. The adjustment of each speaker output level should be done at your listening position with the rem
ページ17に含まれる内容の要旨
CHAPTER/CH DISPLAY STOP VCR 1 — + 7 70mm TV PRO LOGIC ENHANCED MOVIE THEATER VCR 2 THEATER 1234 SURROUND V–AUX SPORTS STADIUM ROCK JAZZ CLUB 5678 CHURCH HALL EFFECT MASTER 910 DSP ON/OFF VOLUME FRONT LEVEL — + + + CENTER LEVEL TEST DELAY — + TIME 9 REAR LEVEL MUTING — + — — RESET CLEAR 8 Select the center channel output mode according to your Press the TEST button again to run the DSP test. 7 speaker configuration. • DSP test: (Refer to “SPEAKER CONFIGURATION” on page 7.) CENTER MODE NORMAL WI
ページ18に含まれる内容の要旨
CHAPTER/CH DISPLAY STOP VCR 1 — + 13 70mm TV PRO LOGIC ENHANCED MOVIE THEATER VCR 2 THEATER 1234 SURROUND V–AUX SPORTS STADIUM ROCK JAZZ CLUB 5678 CHURCH HALL EFFECT MASTER 910 DSP ON/OFF VOLUME 13 FRONT LEVEL — + + + 11 CENTER LEVEL TEST 11 DELAY — + TIME REAR LEVEL MUTING — + — — 12 RESET CLEAR 14 10 12 Adjust the BALANCE control so that the test tone sound Adjust the test tone sound output level of the front 10 13 output level of the left front speaker and the right front speakers to be at t
ページ19に含まれる内容の要旨
BASIC OPERATIONS 2 3 1,6 4 To play a source 1 Set to the “ ” position. 5 Play the source. (For detailed information on the tuning ¥ operation, refer to page 22.) VOLUME l6 l8 l4 20 l2 24 l0 28 8 34 6 6 Adjust to the desired output level. 4 40 VOLUME 50 3 l6 l8 l4 2 20 l2 60 24 l0 l 70 28 0 8 –dB 34 6 4 40 50 3 POWER 2 60 2 Press the POWER switch l 70 to turn on the power. 0 –dB If desired, adjust the BASS, TREBLE, BALANCE controls, etc. (refer to page 21) and use the digital sound field proce
ページ20に含まれる内容の要旨
2 1 To record a source to tape (or dub from tape to tape) Notes: • When the REC OUT selector is set to “SOURCE”, the 1 Select the source to be recorded. source selected by the input selector buttons is output REC OUT SOURCE through the TAPE 1-REC OUT, the TAPE 2-REC LD/TV TAPE 1 VCR 1 TUNER OUT , the VCR 1-OUT, and the VCR 2-OUT VCR 2 CD VIDEO AUX PHONO terminals. • When the REC OUT selector is set to something other than “SOURCE” and you press an input selector 2 Play the source and press the
