ページ1に含まれる内容の要旨
AV Receiver
DTR-7.7
Instruction Manual
ページ2に含まれる内容の要旨
WARNING: WARNING AVIS RISK OF ELECTRIC SHOCK RISQUE DE CHOC ELECTRIQUE TO REDUCE THE RISK OF FIRE OR ELECTRIC DO NOT OPEN NE PAS OUVRIR SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within CAUTION: the product’s enclosure that may be of sufficient TO REDUCE THE RISK OF ELECTRIC SHOCK, magnitude to constitute a risk of electr
ページ3に含まれる内容の要旨
Precautions 1. Recording Copyright—Unless it’s for personal use For U.S. models only, recording copyrighted material is illegal with- FCC Information for User out the permission of the copyright holder. CAUTION: 2. AC Fuse—The AC fuse inside the unit is not user- The user changes or modifications not expressly serviceable. If you cannot turn on the unit, contact approved by the party responsible for compliance could the dealer from whom you purchased this unit. void the user’s authority to op
ページ4に含まれる内容の要旨
Supplied Accessories Thank you for purchasing an Integra AV Receiver. Please read this manual thor- Make sure you have the following accessories: oughly before making connections and plugging in the unit. Following the instructions in this manual will enable you to obtain optimum perfor- mance and listening enjoyment from your new AV Receiver. Remote controller and three batteries (AA/R6) Please retain this manual for future refer- ence. Speaker setup microphone Indoor FM antenna AM loop an
ページ5に含まれる内容の要旨
Contents Introduction Basic Operation Important Safety Instructions ....................2 Playing Your AV Components ................ 46 Precautions .................................................3 Listening to the Radio.............................. 47 Listening to AM/FM Stations....................... 47 Supplied Accessories.................................4 ® Listening to XM Satellite Radio ................. 48 Features .......................................................6 Presetting AM,
ページ6に含まれる内容の要旨
Features *1 THX and Select2 are trademarks of THX Ltd. THX may be Amplifier registered in some jurisdictions. All rights reserved. Sur- • 7-channel amplifier round EX is a trademark of Dolby Laboratories. Used with • 105 watts per channel into 8 ohms, 20 Hz to 20 kHz, permission. *2 Manufactured under license from Dolby Laboratories. less than 0.08% total harmonic distortion (FTC rating) “Dolby”, “Pro Logic”, “Surround EX” and the double-D • Optimum Gain Volume Circuitry symbol are trademarks
ページ7に含まれる内容の要旨
Before Using the AV receiver Installing the Batteries Using the Remote Controller To use the remote controller, point it at the AV receiver’s To open the battery compartment, press remote control sensor, as shown below. 1 the small hollow and slide open the cover. Remote control sensor Standby indicator AV receiver 30˚ 30˚ Insert the three supplied batteries (AA/R6) 2 in accordance with the polarity diagram Approx. 16 ft. inside the battery compartment. (5 m) Notes: • The remote controller
ページ8に含まれる内容の要旨
Getting to Know the AV Receiver Front Panel 12 3 4 5 6 78 9 JK L M N O P QR ST U V For detailed information, see the pages in parentheses. A Standby/On button (37) M Arrow/Tuning/Preset and Enter buttons Sets the AV receiver to On or Standby. When AM, FM, or XM is selected, the Tuning [ ] [] buttons are used for radio tuning, and the Pre- B Standby indicator (37) Lights up when the AV receiver is on Standby and set [ ] [ ] buttons are used to select radio presets flashes while a signal is being
ページ9に含まれる内容の要旨
Getting to Know the AV Receiver—Continued T Input selector buttons (46) U Setup Mic (38) Select the following input sources: Multi CH, DVD, The automatic speaker setup microphone connects Video 1, Video 2, Video 3, Video 4, Tape, Tuner, here. CD, or Phono. V Video 4 Input (32, 60) The [Multi CH] button selects the multichannel Used to connect a camcorder, game console, and so DVD input. on. There are jacks for optical digital audio, S-Video, composite video, and analog audio. Display 13 2 4
ページ10に含まれる内容の要旨
Getting to Know the AV Receiver—Continued Rear Panel Only on the North American model 6 789 J KL M N 12 3 4 5 O PQR S T U VXWY Z A OPTICAL DIGITAL H MONITOR OUT These optical digital audio inputs are for connecting The S-Video or composite video jack should be components with optical digital audio outputs, such connected to a video input on your TV or projector. as CD players and DVD players. I FM ANTENNA The optical digital audio output is for connecting a This jack is for connecting an FM an
ページ11に含まれる内容の要旨
Getting to Know the AV Receiver—Continued Z AC OUTLETS O REMOTE CONTROL These switched AC outlets can be used to supply This (Remote Interactive) jack can be con- power to other AV components. The type and num- nected to the jack on another -capable Inte- ber of outlets depends on the country in which you gra/Onkyo component, for remote and system purchased your AV receiver. control. To use , you must make an analog audio connec- tion (RCA) between the AV receiver and the other component,
ページ12に含まれる内容の要旨
Remote Controller About the Remote Controller Modes Receiver/Tape Mode Including the AV receiver, the remote controller can be Receiver/Tape mode is used to control the AV receiver. used to control up to nine different components. The It can also be used to control an Onkyo cassette recorder remote controller has a specific operating mode for use connected via . with each type of component. Modes are selected by To set the remote controller to Receiver/Tape mode, using the eight Remote Mode
ページ13に含まれる内容の要旨
Remote Controller—Continued For detailed information, see the pages in parentheses. T Muting button (54) Mutes or unmutes the AV receiver. A Standby button (37) U Re-EQ button (62) Sets the AV receiver to Standby. Turns the Re-EQ function on or off. B On button (37) V L Night button (64) Turns on the AV receiver. Turns the Late Night function on or off. C Input Selector buttons (46) Used to select the input sources. D Multi CH button (53) ■ Tape mode Selects the multichannel DVD input. On twin c
ページ14に含まれる内容の要旨
Remote Controller—Continued A Standby button DVD Mode Sets the DVD player to Standby. To set the remote controller to DVD mode, press the B On button [DVD] Remote Mode button. Turns on the DVD player. C Number buttons Used to enter title, chapter, and track numbers, and to enter times for locating specific points. D Top Menu button Selects a DVD’s top menu. E Arrow [ ]/[ ]/[ ]/[ ] and Enter buttons A Used to navigate menus and select items. B F Disc +/– button Selects discs on a DVD changer. C
ページ15に含まれる内容の要旨
Remote Controller—Continued A Standby button CD, MD, and CDR Modes Sets the CD player or MD/CD recorder to Standby. To control an Integra/Onkyo CD player or an Onkyo B On button CD/MD recorder made by another manufacturer, Set the CD player or MD/CD recorder to On or press the [CD] Remote Mode button to select the CD Standby. remote controller mode. C Number buttons To control an Onkyo MD recorder or CD recorder, Used to enter track numbers and times for locating press the [MD] or [CDR] Re
ページ16に含まれる内容の要旨
Remote Controller—Continued A Standby button HDD Mode Turns off the HDD-compatible component. HDD mode is for controlling Onkyo’s next generation B On button* HDD-compatible components. As of 2006, it can be used Turns on the HDD-compatible component. with the Onkyo RI Dock (Remote Interactive Dock) and C Arrow [ ]/[ ] and Enter buttons* Apple iPod connected via . Used to navigate menus and select items. When Using the RI Dock: • Connect the RI Dock to the TAPE IN or VIDEO 3 IN D Album +/– bu
ページ17に含まれる内容の要旨
Connecting Your Speakers Enjoying Home Theater Thanks to the AV receiver’s superb capabilities, you can enjoy surround sound with a real sense of movement in your own home—just like being in a movie theater or concert hall. You can enjoy DVDs featuring DTS and Dolby Digital. With analog and digital TV, you can enjoy Dolby Pro Logic IIx and Onkyo’s own DSP surround listening modes. You can also enjoy THX Surround EX (THX-certified THX speaker system recommended). Front left and right speakers S
ページ18に含まれる内容の要旨
Connecting Your Speakers—Continued Connecting a Powered Subwoofer Connecting Your Speakers Using a suitable cable, connect the AV receiver’s SUB- Speaker Configuration WOOFER PRE OUT to the input on your powered sub- woofer. If your subwoofer is unpowered and you’re For the best surround-sound experience, you should con- using an external amplifier, connect the SUBWOOFER nect seven speakers and a powered subwoofer. PRE OUT to the amp’s input. The following table shows which channels you should
ページ19に含まれる内容の要旨
Connecting Your Speakers—Continued Speaker Connection Precautions Connecting the Speaker Cables Read the following before connecting your speakers: •You can connect speakers with an impedance of Strip about 5/8" (15 5/8" (15 mm) 1 between 4 and 16 ohms. If the impedance of any of the mm) of insulation from connected speakers is 4 ohms or more but less than 6, the ends of the be sure to set the minimum speaker impedance to 4 speaker cables, and ohms (see page 44). If you use speakers with
ページ20に含まれる内容の要旨
Connecting Antenna This section explains how to connect the supplied indoor Connecting the AM Loop Antenna FM antenna and AM loop antenna, and how to connect commercially available outdoor FM and AM antennas. The supplied indoor AM loop antenna is for indoor use only. The AV receiver won’t pick up any radio signals without any antenna connected, so you must connect the antenna to use the tuner. Assemble the AM loop antenna, inserting 1 AM antenna push terminals the tabs into the base, as s
