ページ1に含まれる内容の要旨
HTSSOSPA
Power Amplifier
ページ2に含まれる内容の要旨
HTSSOSPA SIGNAL PROCESSING STEREO POWER AMPLIFIER INTRODUCTION HTSSOSPA is tailored to correspond to the parti- respectively with the HTSSOLRS and HTSSOCF Congratulations! You have chosen the Shure cular Shure HTS loudspeaker system selected in Loudspeakers when the HTS system does not HTSSOSPA Signal Processing Stereo Power each of its HTSspeaker-correlated switch- include a subwoofer. In these two Modes, Amplitier, specially made as an integral part of selectable Operational Modes. Through
ページ3に含まれる内容の要旨
tion of the HTS5OSPA with highest quality components used throughout. The power amplifier circuit of each channel uses a hybrid audio power module construction. This compact assembly techque combines semiconductor chips, normally used in amplifiers as separate dwrete devices, into a tightly coupled unit on a multilayer high-thermal-conductivity substrate. The high thermal conductivity of the base substrate results in a close thermal match of the amplifier output circuits to the voltage
ページ4に含まれる内容の要旨
emphasis in either alternate level setting can provide exceptional excitement and even greater enjoy- ment in home theater sound. These slotted control knobs are intended to require insertion of a coin to change their settings; they resist accidental changes of position. @ OPERATIONAL MODE: The Operational Mode switches select the signal process- ing characteristics of each amplifier channel independently to complement the response characteristics and excur- sion limits of the HTS L
ページ5に含まれる内容の要旨
binding posts that will accept any of the following methods of connection: bare wire wrapped around the post, bare wire inserted through the hole in the post, spade lug around the post, pin connector through the hole in the post, or banana plug inserted in the jack These output connectors will accommodate most high- performance audio cables. (Gold ,080- inch diameter pins soldered to the loud- speaker cables and inserted under the binding post hex caps [fastened finger- tight] are th
ページ6に含まれる内容の要旨
BRIDGED CONNECTION If the amplifier is used in the Bridged MtKie, to prevent the risk of electric shock the following instructions describe the only acceptable method of connection (see illustration). Voltages in the Bridged Connection ate hazardous to life. Make all amplifier-to- speaker connections with AC power discon- nected. Refer senicing to qualitied senice ~ewnnel. 1. Thread the speaker lead through the hole in the supplied connector cover plate. 2. Loosen the insulated red l
ページ7に含まれる内容の要旨
TYPICAL SYSTEM ARRANGEMENT TYPICAL SYSTEM CONNECI'IONS
ページ8に含まれる内容の要旨
SHURE HTS The Home Theater Sound Division of Shure Brothers Inc. 222 Hartrey Avenue Evanston, l L 60202-3696 Copyr~aht 1983. Shore BI-others Inc Pr~nted In U.S.A. 27A8165 (IA)
