ページ1に含まれる内容の要旨
ooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooo
ooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooo
C 306
Reference Preamplifi er
NOTE: Before installing your new component, please read this manual carefully
as it will inform you of the product specifi cations, proper installation and correct
operating procedures for your unit. Also included in this manual are guidelines
on how to service and care for your new Cary Audio Design product.
OWNER’S M
ページ2に含まれる内容の要旨
C 306 REFERENCE PREAMPLIFIER C 306 PREAMPLIFIER SETUP MUTE POWER ENTER POLARITY DISPLAY SELECT VOLUME RECORD OUTPUTS RECORD OUTPUTS AC MAINS CARY AUDIO DESIGN, INC., 1 Trigger output 2 1 2 IR input C 306 PREAMPLIFIER RS 232 S/N: [ ] 117V 50~60Hz [ ] 220V 50~60Hz RIGHT CHANNEL INPUTS LEFT CHANNEL INPUTS MAIN OUTPUTS 1 2 3 4 5 6 RIGHT CHANNEL LEFT CHANNEL 6 5 4 3 2 1 Front Panel, Rear Panel & Remote Control P4-9 Specificat
ページ3に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of un-insulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove the cover. There are
ページ4に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS 14. LIGHTNING: For added protection for the unit during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the unit due to lightning and power line surges. 15. POWER LINES: An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fa
ページ5に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS 26. FCC INFORMATION FOR USER: CAUTION: ANY changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This eq
ページ6に含まれる内容の要旨
Front Panel 11 10 9 8 C 306 PREAMPLIFIER SETUP MUTE POWER ENTER POLARITY DISPLAY SELECT VOLUME 1 2 3 4 5 6 7 1 POWER button: * Press once to turn the power on. * Press again to set to the"OFF" position and turn the power off. 2 SELECT knob: * This knob is normally used to select among the various inputs of the C 306, with the resulting selections being shown in the display window, immediately to the right of the select knob. * The select knob is also used during setup to select amon
ページ7に含まれる内容の要旨
Front Panel 5 POLARITY button: * Press this button to invert the polarity ( sometimes called "absolute phase"of the outputs of the C 306. 6 VOLUME knob: * This control is normally used to adjust the listening volume. When in BALANCE mode, this knob is used to vary the relative output of the Left and Right channels. It is also used during setup for various adjustments. 7 DISPLAY button: * Press this button to select four levels brightness (including "off" ) for the display, allowin
ページ8に含まれる内容の要旨
Rear Panel 1 2 3 4 5 1 RECORD OUTPUTS RECORD OUTPUTS AC MAINS CARY AUDIO DESIGN, INC., 1 2 IR input Trigger output 2 1 C 306 PREAMPLIFIER RS 232 S/N: [ ] 117V 50~60Hz [ ] 220V 50~60Hz RIGHT CHANNEL INPUTS LEFT CHANNEL INPUTS MAIN OUTPUTS 1 2 3 5 6 6 3 4 RIGHT CHANNEL LEFT CHANNEL 5 4 2 1 6 7 8 9 9 8 7 6 1 ANALOG RECORD OUTPUT JACK (RCA UNBALANCED): * Use these jacks for connection to the right-channel and left-channel tape inputs of your r
ページ9に含まれる内容の要旨
Rear Panel 6 BALANCED INPUTS 1-3: * Accepts right-channel and left-channel balanced signals from source equipment with balanced outputs. The pin assignments of these XLR-type female input are: * Pin 1: Signal ground 2 1 Pin 2: Signal + (non-inverting) 3 Pin 3: Signal - (inverting) Connector ground lug: chassis ground Refer to the operating manuals of your balanced-output line-level sources to verify that the pin assignments of their output connectors correspond to the C 306. If not, wire
ページ10に含まれる内容の要旨
Remote Control Switching the power on and off. Muting sound. Resuming sound. ENTER Use the left or right Navigation buttons to move through menu options shown on the DISPLAY SETUP C 306 Display. < SELECTOR > - VOLUME + Use the up or down Navigation buttons to 1--> 2 ABC 3 DEF 4 GHI move through menu options shown on the C 306 Display. 5 JKL 6 MNO 7 PQRS 8 TUV 9 WXYZ 0 a/A + 10 CLEAR ENTER Use this button to save changes to menu items in the C 306 from your listening L BALAN
ページ11に含まれる内容の要旨
Remote Control 1--> 2 ABC 3 DEF 4 GHI 5 JKL 6 MNO 7 PQRS 8 TUVI MU TE POWER 9 WXYZ 0 a/A VOLUME + Use the ten buttons to create a name of your own choosing, up to twenty BALANCE < characters long. INPUT SELECTOR < L BALANCE R Use the two buttons to fine-tune the relative balance of the Left and Right channel from your listening position using the VOLUME buttons, in 0.1 dB increments. C 306 sub-R/C _ POLARITY + * All the same name buttons Use the two buttons to invert the
ページ12に含まれる内容の要旨
Specifications_________________________________________ Operating the C 306 Preamplifier is a simple procedure, since each unit is designed for long term stability in virtually any home operating situation. However, if the unit is operated outside the parameters outlined in this owner’s manual, damage may result. Please read this manual carefully before putting your new Cary Audio Design C 306 in operation. The following definitions are applicable to this manual. Please follow these defin
ページ13に含まれる内容の要旨
Installation_____________________________________________ This section describes the unpacking and installation procedures for the C 306 Preamplifier. WARNING MAKE NO ATTEMPT TO PUT THE C 306 PREAMPLIFIER IN SERVICE WITH THE TOP COVER REMOVED. CONTACT WITH HIGH VOLTAGE INSIDE THE C 306 PREAMPLIFIER CAN BE FATAL !!!!! 2.1 Unpacking All shipping containers have been specifically designed to protect their contents and special care has been taken to prevent
ページ14に含まれる内容の要旨
Customizing Your C 306 3.1 SETUP OVERVIEW: The C 306 Preamplifier has many provisions for custom-tailoring the system's operation to match your preferences. The method for modifying any of these settings is to: * press the SETUP button on either the front panel or the remote control to enter the setup mode, accessing the C 306 menu system: * navigate among different menu items using SELECT knob or the remote control's NAVIGATE buttons; * change
ページ15に含まれる内容の要旨
Customizing Your C 306 Equalizer 1-3 Digital Audio Tape 1-3 VCR 1-3 Cassette 1-3 Mine-Dise Player 1-3 CD Recorder 1-3 Phono 1-3 Tuner 1-3 Auxiliary Input 1-3 DA Converter 1-3 CARY CD player 1-3 CARY DVD player 1-3 CARY DA Converter 1-3 CARY Tuner 1-3 Input a new name....._ 3.4 CHANGING INPUT NAMES: To change an input name, use the SETUP menu: * press SETUP to enter the setup menu * turn the SELECT knob (or use the up or down NAVIGATE buttons on the remote) to mov
ページ16に含まれる内容の要旨
Customizing Your C 306 To change the mute level: * press SETUP to enter the setup menu * turn the SELECT knob (or use the up or down NAVIGATE buttons on the remote) to move to "MUTE LEVEL" mode * turn the VOLUME knob (or use the left or right NAVIGATE buttons on the remote) to choose the mute mode you want * press ENTER to save change the menu items * press SETUP to exit the setup menu 3.6 SETTING A VOLUME LEVEL MODE: You may also set a volume level for the C 306,
ページ17に含まれる内容の要旨
Operation C 306 PREAMPLIFIER SETUP MUTE POWER ENTER POLARITY DISPLAY SELECT VOLUME 3 1 1 1 NORMAL OPERATION: The majority of time you spend with your C 306 will be spent in normal operation. During normal operation, the display indicates the name of the input you have selected and listening volume. The VOLUME knob increases or decreases the volume in 0.1dB increments above 50 ( and in 1.0 dB steps below this low level). The SELECT knob selects the source to be listened to
ページ18に含まれる内容の要旨
Service and Care 5.1 C 306 Preampfilier Care and Cleaning The cabinet housing and front panel of the C 306 may be cleaned with a soft cloth and Windex® or a mild window cleaner. The frequency of cleaning will be governed by the operating environment cleanliness. Do not use benzene, harsh or abrasive chemicals to clean the front or rear panel as they may remove or damage the labels. 5.2 Factory Service Careful consideration has been given to the desi
ページ19に含まれる内容の要旨
UNITED STATES LIMITED WARRANTY Cary Audio Design warrants to the original United States purchaser for use in the United States that Cary Audio Design vacuum tube or solid state power amplifiers, surround sound processors or preamplifiers shall be free from defects in parts or workmanship for three (3) years from the date of the original purchase. Vacuum tubes, if any are used in the component, are offered a 90 day from purchase date exchange policy against defects with the exception of th
ページ20に含まれる内容の要旨
ooooooooooooooooooo CARY AUDIO DESIGN 1020 Goodworth Drive, Apex, NC 27539 phone 919-355-0010 fax 919-355-0013 w w w .car yaudio .c om ooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooo
