ページ1に含まれる内容の要旨
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 1
Radio Frequency
Wireless
900
MHz
Speakers
with 900 MHz Transmitter
Freedom From Wires
listen anywhere in your home
WSP200
ページ2に含まれる内容の要旨
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 2 INTRODUCTION Congratulations on the purchase of your new WSP200 Wireless Stereo Speaker System. This System uses the latest 900 MHz High Frequency Radio Signal that can easily travel through walls, floors, ceilings or partitions to allow the finest stereo sound reproduction. You can use your Speakers almost anywhere in and around your home or, for outdoor activities, just place them in the location of your choice. There is no need to worry about
ページ3に含まれる内容の要旨
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 3 CONTROL LOCATIONS TRANSMITTER 1) LED Indicator (Power ON) 2) Power OFF Switch and Channel Selector 3) AUDIO IN Jack (L) - Connect to Music Source 4) AUDIO IN Jack (R) - Connect to Music Source 5) DC Input Jack 2 1 5 4 3 SPEAKER 6) Frequency Channel Selector 7) Tone Control Knob 8) Power OFF and Volume Control Knob 9) DC Input Jack 10) MODE Switch (To Select Left/Mono or Right Channel) 11) Battery Compartment 9 6 10 11 7 8 3 DC IN WS-91 WIRELESS SP
ページ4に含まれる内容の要旨
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 4 INSTALLING THE TRANSMITTER You need to properly set up the Transmitter to send a wireless signal to the Speakers. There are two things you must do. First, provide power to the Transmitter, and second, connect the Transmitter to the Audio Source. 1) CONNECTING POWER (A) DC OPERATION Your Transmitter is supplied with a Battery SIZE "AA" x 4 PCS. Tray. Insert four (4) x AA Alkaline batteries (not supplied) to the battery slot as indicat- ed. Attach
ページ5に含まれる内容の要旨
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 5 INSTALLING A SPEAKER CONNECTING POWER (A) DC OPERATION (with optional BP200SP Battery Pack sold on page 11) Speaker • Open the battery cover located at the back of Unit the Speaker unit. Insert the battery making DC IN MODE L - MONO - R sure the side with the contacts (located on WSP200 IW MIP RE ED LA EN SS C E SPEAKER SYSTEM P MO AW XIE M R U S MO O UU RT CP EUT POWER AC : 120V 60Hz DC : BATTERIES "D"(1.5V) x 8 M A D E I N C H I N A the top edge
ページ6に含まれる内容の要旨
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 6 OPERATION Follow these steps to obtain maximum listening performance 1) Make sure that your Transmitter and Speakers are set up according to the procedures given in this manual. 2) Turn on your Audio Source. 3) Switch the Transmitter to a Frequency Channel (Channel 1, 2, or 3) that has no interference. Refer to CHANNEL SELECT below for Precision Frequency Lock-In Tuning. 4) Rotate the CHANNEL Knob on the front of the Speakers to select the same c
ページ7に含まれる内容の要旨
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 7 BATTERY OPERATION TRANSMITTER When the Transmitter is operated by fresh Alkaline batteries (four (4) AA cells- not included) the Transmitter will play for approximately 4-6 hours continuously. Once the battery power begins to decrease, you will hear static sound from the Speakers. This indicates that you have to replace the batteries. If left unattended, transmitter signal will be decreased until the Speaker NOISE MUTE function activates and shut
ページ8に含まれる内容の要旨
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 8 TROUBLESHOOTING If you follow all the instructions in this manual, you should have no problems with your WSP200 Wireless Speaker System. However, in case you can not make the system work, please read the TROUBLESHOOTING section carefully. Do not return to your dealer immediately! Check and follow these guides - you probably can resolve your problems without much difficulty. PROBLEMS SOLUTIONS No Sound Be sure that both Speakers and the Transmitter
ページ9に含まれる内容の要旨
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 9 SPECIFICATIONS TRANSMITTER Operating Frequency 912 - 914MHz Channel 1: 911.950 MHz Channel 2: 912.925 MHz Channel 3: 913.900 MHz Power Sources a) AC Adapter (AC 120/60 Hz~DC 6V 600mA) Supplied b) DC four (4) x AA 6V Alkaline Batteries (Not Included) Transmitter Dimensions 6" (H) x 3 1/4" (W) x 4 3/8" (D) RECEIVER SPEAKER(S) Output Power 16 Watts RMS (8 Watts per Channel) Receiving Frequency 911.9 - 9.13.9 MHz Signal to Noise Ratio 55 dB Channel
ページ10に含まれる内容の要旨
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 10 RCA ACCESSORIES The following RCA accessories are available through your RCA dealer or: ORDER BY PHONE: ORDER BY MAIL: Have your Visa, MasterCard or Complete order form on page 11 Discover Card ready and call the and mail to: toll-free number listed below. RCA Accessories This number should only be PO Box 8419 used to place orders. Ronks, PA 17573 1-800-338-0376 D918 SURGE PROTECTOR PLUS Power surges can enter and destroy your valuable equipm
ページ11に含まれる内容の要旨
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 11 BP200SP OPTIONAL BATTERY PACK The BP200SP Battery Pack allows up to 10 hours of continuous play without the need for AC Power. Great for using your Speakers in your yard or on your balcony or patio - where AC power may not be readily available. Features Include: - May be charged hundreds of times - 12V, 4.5 Amp - hour Nominal - Maintenance-free - No “memory effect” BP200SP † $ 95 39 per unit ORDER FORM Name Address City State Zip Day Time Phone
ページ12に含まれる内容の要旨
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 12 ONE YEAR LIMITED WARRANTY Thomson Consumer Electronics, Inc. warrants that for one year from the date of purchase this product is free from defects in material and workmanship. If the item is defective within that period, return it at your expense to the dealer from whom it was purchased together with proof of purchase for replacement. The exchange unit is under warranty for the remainder of the original product’s warranty period. This warranty
