ページ1に含まれる内容の要旨
MICRO COMPONENT MD SYSTEM
UX-J99DVD
—Consists of CA-UXJ99DVD and SP-UXJ99DVD
—
CA-UXJ99DVD SP-UXJ99DVD
INSTRUCTIONS
GVT0123-002A
[UB]
Cover_UX-J99DVD[UB].p65 3 03.11.4, 11:31 AM
English
ページ2に含まれる内容の要旨
Warnings, Cautions and Others CAUTION— button! Disconnect the mains plug to shut the power off completely (the STANDBY/ON lamp goes off). The button in any position does not disconnect the mains line. • When the unit is on standby, the STANDBY/ON lamp lights red. • When the unit is turned on, the STANDBY/ON lamp lights green. The power can be remote controlled. CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. 2. Do not expose this applianc
ページ3に含まれる内容の要旨
Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1 Front: No obstructions and open spacing. 2 Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below. 3 Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more. Front view Side view 15 cm 15 cm 1 cm 1 cm 15 cm 15 cm 15 cm UX-J99DVD 10 cm UX-J99DVD IMPORTANT
ページ4に含まれる内容の要旨
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging the unit from the wall outlet, always pull on the This manual is organized as follows: plug, not the AC power cord. • This manual mainly explains operations using the buttons on the remote control. D
ページ5に含まれる内容の要旨
Contents Location of the Buttons and Controls ....................... 3 Recording on an MD ................................................ 45 Remote Control ............................................................................. 3 Before You Start Recording on an MD ....................................... 45 Front Panel .................................................................................... 4 Setting MD Recording Modes .................................................... 46 R
ページ6に含まれる内容の要旨
1 2 3 4 5 6 7 8 9 +10 +10 Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Remote Control Remote Control See pages in parentheses for details. i 1 1 FADE MUTING button (11) 2 VIRTUAL SURROUND button (31) o 2 3 AHB PRO (Active Hyper Bass Pro) button (11) 3 4 DVD 8 (pause) button (17, 32, 35, 52) ; 5 Source selection buttons 4 a • DVD 3 (play) button 5 (10, 17, 18, 20 – 22, 32, 35, 36, 47, 51 – 53) • MD (play/pause) button (10, 37, 39 – 41, 51, 52)
ページ7に含まれる内容の要旨
f MENU button (20) / REV.MODE (reverse mode) button (43, 48, 51) g Multi control buttons z MD editing buttons • Cursor (2/3/5/∞) (10, 22, 26 – 33, 36) • TITLE SEARCH button (41) • ENTER button • TITLE EDIT button (64 – 68) h ON SCREEN button (24 – 28, 30) • GROUP TITLE EDIT button (56 – 62, 68) j DIMMER button (12) • TR. (track) MARK SELECT button (49) k BASS/TREBLE button (12) • LP: button (46) l Number buttons x DVD operation buttons • 1 – 10, 0 and +10 buttons • AUDIO button (29) • 100+ butto
ページ8に含まれる内容の要旨
Location of the Buttons and Controls (Continued) Display window on the front panel 1 23 4 5678 9 V C D V D REC DAILY SP 1 DISC PRGM SURROUND PBC MD TAPE 1 2 3 4 5 ALL A - B RANDOM AHBPRO SLEEP STEREO REC LP24 REC GROUP TITLE SEARCH AUTO STANDBY MONO x1 5 PROGRESSIVE GROUP 0 -= ~ Display window See pages in parentheses for details. 1 PROGRESSIVE indicator (12) 5 Play mode indicators (21 – 23, 27, 36, 39 – 41) 2 Disc operation indicators (17) • Repeat mode indicators • Disc type indicator 1, DIS
ページ9に含まれる内容の要旨
Getting Started About the AUDIO-TV switch Unpacking With the remote control supplied with this unit, you can also operate After unpacking, be sure that you have all the following items. a JVC or other manufacturer’s TV. The number in parentheses indicates the quantity of each piece supplied. • FM antenna (1) • AM loop antenna (1) • Speaker cords (2) • Composite video cord (1) • Remote control (1) • Batteries (2) If any item is missing, consult your dealer immediately. Putting the Batteries into
ページ10に含まれる内容の要旨
Getting Started (Continued) To connect an outdoor FM antenna 1 If the cords are covered with insulation, remove a short section of insulation at the end of each cord Before connecting it, disconnect the supplied FM antenna. by twisting and pulling it off. 2 Connect the AM loop antenna to the AM LOOP Outdoor FM antenna (not supplied) terminals as illustrated. 3 Turn the AM loop antenna until you have the best reception. Coaxial cable (not supplied) To connect an outdoor AM antenna When reception
ページ11に含まれる内容の要旨
1 If the cords are covered with insulation, remove a Connecting a TV short section of insulation at the end of each cord Connect your TV and this unit using the composite video cord by twisting and pulling it off. (supplied), an S-video cord (not supplied) or component video cord (not supplied). 2 Hold the clamp of the speaker terminal. • You can also connect a JVC’s TV through the AV COMPU LINK control system. (See page 84.) 3 Insert the end of the speaker cord into the terminal. Match the pola
ページ12に含まれる内容の要旨
Getting Started (Continued) To select the color system AUDIO You need to select the color system setting of this unit to match to PCM OPTICAL your TV. DIGITAL IN Set the NTSC/PAL switch on the rear correctly while in standby mode by referring to the table below. DVD OPTICAL PCM/ STREAM DIGITAL OUT AUDIO COMPONENT ANTENNA PR PB Y PCM OPTICAL DIGITAL IN RIGHT LEFT PCM/ DVD OPTICAL S-VIDEO VIDEO STREAM VIDEO DIGITAL NTSC OUT OUT RIGHT LEFT Before connecting an optical PAL SPEAKERS SPEAKER digital c
ページ13に含まれる内容の要旨
Basic and Common Operations To turn off the clock indication (Power Save) Setting the Clock On the remote control ONLY: Before operating the unit any further, first set the built-in clock. Press DISP/CHARA while the unit is on When you plug in the power cord, “0:00” starts flashing on the standby (off). display. “DISPLAY OFF” appears on the display for a while, You can set the clock when the unit is either turned on or on standby then the clock indication goes off. (off). You cannot set the cloc
ページ14に含まれる内容の要旨
Basic and Common Operations (Continued) To turn off the unit automatically (Auto Standby) Using Auto Standby, the unit automatically turns itself off (on • If “CANNOT LISTEN” appears on the display standby) if no operation is done for about 3 minutes except when During high-speed recording, you cannot listen to any source, and playing back and when FM or AM is selected as the source. therefore, cannot adjust the volume level. If an operation is done within this 3-minute period, Auto Standby is •
ページ15に含まれる内容の要旨
Adjusting the Tone When you turn off (on standby) the unit The display brightness sets back to “DIMMER OFF.” You can adjust the bass level (low frequency range) and the treble level (high frequency range) within a range of “–5” to “+5” only while the unit is turned on. • This function only affects the playback sound, and does not affect Changing the Scanning Mode your recording. • This function also affects the sound from headphones. This unit supports the NTSC progressive scanning system (525p*
ページ16に含まれる内容の要旨
Listening to FM and AM Broadcasts Setting the AM Tuner Interval Spacing 2 Press and hold UP ¢ or DOWN 4 for more than 1 second. Some countries AM channel intervals are set to 9 kHz apart, and some countries use 10 kHz apart. 4 DOWN ¢ UP When shipped, the built-in AM tuner is set to 9 kHz spacing. You can change the channel interval to 9 kHz or 10 kHz spacing. (On the remote control) (On the unit) • The last selected source must be “AM” in order to perform the following operation. • UP ¢: Increa
ページ17に含まれる内容の要旨
Presetting Stations Tuning in to a Preset Station You can preset 30 FM and 15 AM stations manually. On the remote control ONLY: In some cases, test frequencies have been already stored for the tuner since the factory examined the tuner preset 1 Press FM/AM/AUX to select either function before shipment. This is not a malfunction. You can “FM” or “AM.” preset the stations you want into memory by following the The unit automatically turns on and tunes in to the previously presetting method. receive
ページ18に含まれる内容の要旨
Playing Back Discs on the 5-DVD Changer indicates types of disc available for the operation. (Unavailable disc types are shown in halftone color.) • For MP3 and JPEG disc playback, see pages 35 and 36. (For how to make a program using MP3 discs is explained in this section.) Disc Information On CD-R and CD-RW • User-edited CD-R (Recordable) and CD-RW (ReWritable) can be played Playable disc types back only if they are already “finalized.” This unit has been designed to play back the following d
ページ19に含まれる内容の要旨
Disc structure On a JPEG disc, each still picture is recorded as a file. Files are usually grouped into a folder. Folders can also include other folders, DVD VIDEO consists of “titles,” and each title may be divided into creating hierarchical folder layers. some “chapters.” This unit simplifies the hierarchical construction of a disc and For example, if a DVD VIDEO contains some movies, each manages folders by “groups.” movie may have its own title number and it may be further divided into some
ページ20に含まれる内容の要旨
Playing Back Discs on the 5-DVD Changer (Continued) Loading Discs 2 Press DISC UP or DISC DOWN (or DISC SELECT on the unit) repeatedly to select the disc On the unit ONLY: you want. DISC 1 Press one of the disc eject buttons (DISC10 – SELECT DISC50) for the disc tray you want to load a disc ‹/8 DVD onto. The unit automatically turns on and the selected disc tray comes (On the remote control) (On the unit) out if it is unlocked. For details, see “Prohibiting Disc Playback starts from the first tr
