ページ1に含まれる内容の要旨
COMPACT COMPONENT MD SYSTEM
CA-MXS5RMD
COMPACT
DIGITAL AUDIO
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial
No. which are located either on the rear,
bottom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
LVT0354-001A
[B]
CA-MXS5RMD[B].COVER 1 99.9.14, 1:51 AM
ページ2に含まれる内容の要旨
Warnings, Cautions and Others IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. If nontheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to a
ページ3に含まれる内容の要旨
IMPORTANT FOR LASER PRODUCTS REPRODUCTION OF LABELS 1 CLASSIFICATION LABEL, PLACED ON REAR 2 WARNING LABEL, PLACED INSIDE THE UNIT ENCLOSURE ADVARSEL: Usynlig laser- VARO: Avattaessa ja suo- DANGER: Invisible laser VARNING: Osynlig laser- radiation when open and strålning när denna del är stråling ved åbning, når jalukitus ohitettaessa olet sikkerhedsafbrydere er ude alttiina näkymättömälle interlock failed or defeated. öppnad och spärren är AVOID DIRECT EXPOSURE urkopplad. Betrakta ej af fu
ページ4に含まれる内容の要旨
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging the unit from the wall outlet, always pull the plug, not the AC power cord. This manual is organized as follows: DO NOT handle the AC power cord with wet • The manual mainly explains operations using
ページ5に含まれる内容の要旨
Contents Playing at Random — Random Play ................... 31 Location of the Buttons and Controls ........... 3 Repeating Tracks — Repeat Play ........................ 31 Front Panel ............................................................. 4 Prohibiting Disc Ejection — Disc Lock .............. 31 Remote Control ...................................................... 5 Recording on MDs ........................................ 32 Getting Started..............................................
ページ6に含まれる内容の要旨
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Front Panel Display Window / z l x c t 1 2 y 3 u 4 i 5 o 6 ; 7 a s 8 d 9 p f q g w h e j r k – 3 – EN01-09.CA-MXS5RMD[B]/f 3 99.9.14, 1:52 AM
ページ7に含まれる内容の要旨
Continued f DIMMER/CONTRAST button (13) See pages in the parentheses for details. CHARACTER button (45) g PHONES jack (15) Front Panel h PLAY/REC MODE button (26, 30, 36, 37) j7 (stop) button (25, 29, 34) 1 MD loading slot k Disc trays (25) 2 (Standby/On) button and STANDBY/ON lamp (11) Display window 3 CLOCK/TIMER button (11, 51) l Main display 4 Remote sensor • Shows the source name, track number, and other 5 Recording lamp (34) information. 6 ACTIVE BASS EX. (extension) button and lamp (15) /
ページ8に含まれる内容の要旨
Remote Control Remote Control 1 Disc number buttons (25) • CD 1, CD 2, and CD 3 Pressing one of these buttons also turns on the unit. 2 SOUND button (16) 3 ACTIVE BASS EX. (extension) button (15) 1 4 RDS CONTROL button (20) t 5* PLAY MODE button (26, 30) 2 y 3 EON button (21) 4 u 6 MD TITLE button (47) 5 i 7* CHARACTER button (48) 6 PTY SEARCH button (20) 8* CANCEL button (27, 30, 48) 7 PTY SELECT + button (20) o 8 9* SET button (48) PTY SELECT – button (20) 9 p* ENTER button (48) ; p DISPLAY bu
ページ9に含まれる内容の要旨
Getting Started Continued To connect an outdoor FM antenna Unpacking Before connecting it, disconnect the supplied FM antenna. After unpacking, check to be sure that you have all the following items. The number in the parentheses indicates the quantity of the pieces supplied. • AM loop antenna (1) • FM antenna (1) Outdoor FM antenna • Remote control (1) (not supplied) • Batteries (2) If any is missing, consult your dealer immediately. Connecting Antennas FM antenna FM antenna (supplied) A 75W an
ページ10に含まれる内容の要旨
AM antenna Connecting Speakers You can connect the speakers using the speaker cords. 3 1 2 2 3, 4 1 Vinyl-covered wire (not supplied) Red Red Black Speaker cord AM loop antenna (supplied) Right Left 1 Connect the AM loop antenna to the AM LOOP speaker speaker terminals as illustrated. 2 Turn the AM loop antenna until you have the best 1 Twist the core of the cord at the end of each cord, reception. then remove the insulation. To connect an outdoor AM antenna 2 Open the speaker terminal. When rec
ページ11に含まれる内容の要旨
Continued To connect audio equipment with an optical digital Connecting Other Equipment output terminal You can connect the following equipment to this unit: • Cassette deck — used as a playback and recording device. By using the cassette deck, you can record any source played back on this unit. • Audio equipment with an optical digital output terminal — used only as a digital playback device. When you connect and use these equipment, refer also to the manuals supplied with them. Be sure that th
ページ12に含まれる内容の要旨
NOW, you can plug in the unit and other connected Putting the Batteries into the Remote equipment FINALLY! Control Insert the batteries — R6P(SUM-3)/AA(15F) — into the remote control, by matching the polarity (+ and –) on the batteries with the + and – markings on the battery compartment. When the remote control can no longer operate the unit, replace both batteries at the same time. 1 To a wall outlet When connecting the AC power cord into a wall outlet, the 2 unit automatically starts display
ページ13に含まれる内容の要旨
Basic Settings Continued The buttons and controls enlarged in the illustration below are used and explained in this section (pages 11 to 13). Front panel Remote control – 10 – EN10-16.CA-MXS5RMD[B]/f 10 99.9.14, 1:52 AM
ページ14に含まれる内容の要旨
Before operating the unit any further, first set the clock Setting the Clock built in this unit, then some other basic settings. You can set the clock whether the unit is turned on or in standby mode. Turning On the Power On the unit ONLY: When you press the play button (#/8) for a particular 1 Press CLOCK/TIMER. source or the source selecting buttons such as FM/AM and The hour digit in the main display starts flashing. TAPE/AUX, the unit automatically turns on (and starts playback if the source
ページ15に含まれる内容の要旨
Continued How these settings work Changing the Main Display Screen • When selecting “DEMO”: Display demonstration starts. You can change the screen pattern which appears in the main display. On the unit ONLY: You can do the following procedure while the unit is turned on or in standby mode. If you do not cancel the display demonstration by 1 Press ENTER/DEMO. pressing ENTER/DEMO, display demonstration The DISPLAY MODE screen appears. automatically starts in the following cases: • If “MODE OFF” a
ページ16に含まれる内容の要旨
To store the selected main display screen in backup Changing the Display Brightness and memory Contrast You can store the selected main display screen in back up memory. So, even though the AC power is unplugged or a To change the brightness power failure occurs, the setting is kept in memory and will You can change the display brightness whether the unit is not be reset to the display demonstration. turned on or in standby mode. You can set and memorize the display brightness setting On the uni
ページ17に含まれる内容の要旨
Basic and Common Operations Continued The buttons and controls enlarged in the illustration below are used and explained in this section (pages 15 to 16). Front panel Remote control – 14 – EN10-16.CA-MXS5RMD[B]/f 14 99.9.14, 1:52 AM
ページ18に含まれる内容の要旨
Selecting the Sources and Starting Play Adjusting the Volume You can adjust the volume level only while the unit is To select the tuner as the source, press FM/AM. The unit turned on. automatically turns on, the lamp on the FM/AM button lights, and the last received station is tuned in. Turn VOLUME clockwise to increase the volume or • For more detailed operations, see pages 17 to 23. counterclockwise to decrease it. When using the remote control, press VOLUME + to To select the CD player as the
ページ19に含まれる内容の要旨
Selecting the Sound Modes Creating Your Own Sound Mode — MANUAL Mode You can select one of the 6 preset sound modes (3 surround modes and 3 SEA – Sound Effect Amplifier – modes) and 1 You can create and store your own sound mode. manual mode. The sound modes can be applied only to • There is a time limit in doing the following steps. If the playback sounds, and cannot be used for recording. setting is canceled before you finish, start from step 1 again. To select the sound modes, press SOUND unt
ページ20に含まれる内容の要旨
Listening to FM and AM (MW/LW) Broadcasts The buttons and controls enlarged in the illustration below are used and explained in this section (pages 18 to 23). Front panel Remote control You cannot use the buttons on the front panel to operate the RDS functions. Use only buttons on the remote control. – 17 – EN17-23.CA-MXS5RMD[B]/f 17 99.9.14, 1:52 AM
