ページ1に含まれる内容の要旨
TOTAL SPEAKER SOLUTIONS
TSS-750
Owner’s Guide
(120V)
ページ2に含まれる内容の要旨
IMPORTANT SAFETY PRECAUTIONS Read First! the apparatus.When a cart is used, use caution 18. An outside antenna system should not be when moving the cart/apparatus combination to located in the vicinity of overhead power lines or CAUTION avoid injury from tip-over. other electric light or power circuits, or where it RISK OF ELECTRIC SHOCK can fall into such power lines or circuits.When 13. Unplug this apparatus during lightning storms DO NOT OPEN installing an outside antenna system, extreme care
ページ3に含まれる内容の要旨
TSS-750 OWNER’S GUIDE Table of Contents ii Important Safety Precautions 1 Introduction 1 Unpacking the System 1 Planning Your System 2 Placement 2 Wall-Mounting the Satellites 3 Center and Satellite Speaker Connections 4 Subwoofer Controls 5 Subwoofer Connections 6 Operation 6 Maintenance and Service 7 Specifications iii TSS-750
ページ4に含まれる内容の要旨
INTRODUCTION PLANNING YOUR SYSTEM Before deciding where to best place your speakers, survey your room and Infinity Total Solutions study Figures 1 and 2. Infinity Total Solutions continues Infinity’s longstanding commitment to accurate sound reproduction. Our proprietary Metal Matrix Diaphragm ™ (MMD ) drivers, precision dividing networks and rigid, well-braced Subwoofer enclosures combine to deliver uncompromised performance in any stereo or multichannel home theater system. In addition, these
ページ5に含まれる内容の要旨
WALL-MOUNTING THE SATELLITES PLACEMENT NOTE: The satellite speakers can be placed directly on a shelf, The TSS-750 satellites are designed to be mounted on the wall. or mounted on a wall using the built-in keyhole mount or optional There is a wall bracket for each satellite speaker. Each speaker bracket will require (2) 1-1/2,"#10 wood screws; each screw wall brackets. should be fastened to a wall stud. If a wall stud is unavailable, install an anchor appropriate for a 1-1/2,"#10 screw. Left and
ページ6に含まれる内容の要旨
CENTER AND SATELLITE SPEAKER CONNECTIONS Center Channel Turn Off All Power After placing the speakers, you are ready to connect your system. Observe polarities when making speaker connections, as shown in Figure 5. Connect each + terminal on the back of the amplifier or First, turn off all audio-system power. Use high-quality speaker wire to make your connections. #18-Gauge speaker wire with receiver to the respective + (red) terminal on the speaker. polarity coding is included. For longer dista
ページ7に含まれる内容の要旨
SUBWOOFER CONTROLS Subwoofer-Level Control Rear Panel LFE/Normal Switch Phase Switch Crossover-Frequency Adjustment ¡ LEVEL Line-Level (LFE) Inputs Min Max Power Switch LFE NORMAL ™ £ PHASE 0˚ 180˚ CROSSOVER FREQUENCY ¢ 50Hz 150Hz A Few Suggestions L R ∞ We recommend that you do not operate your speakers or LINE LEVEL IN subwoofer with the bass, treble and loudness controls set to full boost.This will place undue strain on your electronics and For LFE u
ページ8に含まれる内容の要旨
SUBWOOFER CONNECTIONS ® If you have a Dolby* Digital or DTS receiver/ If your receiver/processor does not contain processor with a low-frequency-effects (LFE) a Dolby Digital or DTS processor but has a or subwoofer output: subwoofer output: RECEIVER/PROCESSOR SUBWOOFER OR LFE OUTPUT LEVEL Min Max LFE NORMAL PHASE 0º 180º LEVEL 80Hz Min Max 15' CROSSOVER LFE NORMAL FREQUENCY subwoofer 50Hz 150Hz cable 0º 180º PHASE 80Hz 15' subwoofer included L R CROSSO
ページ9に含まれる内容の要旨
OPERATION Surround Modes Crossover Adjustment When using the TSS-750 in a Dolby Pro Logic* home theater The Crossover Frequency Control determines the highest system, make sure the receiver’s center channel mode is set to frequency at which the subwoofer reproduces sounds. For the “Normal.” When using the system in a Dolby Digital or DTS home TSS-750, it is recommended that this control be set at 120Hz theater system, make sure all speakers are set to “Small” . (approximately the 3 o’clock po
ページ10に含まれる内容の要旨
SPECIFICATIONS TSS-750 Satellites Center Channel Frequency Range: 120Hz – 20,000Hz (±3dB) 120Hz – 20,000Hz (±3dB) Recommended Amplifier Power Range: 10 – 100 watts 10 – 125 watts Sensitivity: 88dB 89dB (2.83V @ 1 meter) Nominal Impedance: 8Ω 8Ω Crossover Frequency: 3500Hz, 24dB/Octave 3500Hz, 24dB/Octave Midrange Driver(s): 3-1/2" MMD, Dual 3-1/2" MMD, magnetically shielded magnetically shielded High-Frequency Driver: 3/4" MMD, 3/4" MMD, magnetically shielded magnetically shielded Dimensions (H
ページ11に含まれる内容の要旨
NOTES TSS-750 8
ページ12に含まれる内容の要旨
© 2003 Harman International Industries, Incorporated Infinity Systems, 250 Crossways Park Drive,Woodbury, NY 11797 USA 516.674.4INF www.infinitysystems.com *Trademarks of Dolby Laboratories. DTS is a registered trademark of Digital Theater Systems, Inc. Infinity is a registered trademark, and MMD is a trademark, of Harman International Industries, Incorporated. Part No.TSS750OM-120 8/03
