ページ1に含まれる内容の要旨
NS-IW360C
HOME CINEMA IN-CEILING SPEAKER
CONTENTS
CONSUMER PRECAUTIONS ............................................................................ 2
UNPACKING ....................................................................................................... 3
TOOLS NEEDED ................................................................................................ 3
SPEAKER PLACEMENT .................................................................................... 3
INSTALLATION ....
ページ2に含まれる内容の要旨
CONSUMER PRECAUTIONS Read these precautions carefully before installing your NS-IW360C speakers. Before you begin installation, read this owner’s manual completely and consult your local building codes. If you have any doubt, contact your dealer or a qualified audio/video installer. YAMAHA recommends installing the speaker only in two-by-four wood frame or similar construction. The instructions provided in this owner’s manual are intended specifically for this type of wall construction.
ページ3に含まれる内容の要旨
UNPACKING After unpacking, check that the following items are contained. 10-9/32” 3-3/4” 9-7/16” TEMPLATE NS-IW360C Speaker Cutout Paint Protective Speaker System x2 Grill x2 template x1 Cover x1 Glue Strips x2 TOOLS NEEDED Pencil Drill Drywall saw Wire strippers Sturdy wire Philips screwdriver Safety goggles Gloves (such as a coat hanger) SPEAKER PLACEMENT These speakers are not magnetically shielded. Avoid installing the speakers too close to your TV. Stereo Home Theater For best stere
ページ4に含まれる内容の要旨
INSTALLATION Before installation, check to ensure that the area you are installing the speaker is free of any ceiling joints, by tapping the ceiling or using a stud finder. If you wish to paint the speaker frame and grill, please refer to page 7 “PAINTING THE SPEAKER FRAME AND GRILL” before proceeding. 1 Position the cutout template where you are 4 Cut the ceiling along the outline you traced. installing the speaker. Then trace around the template with a pencil. TEMPLATE 5 Run high quality
ページ5に含まれる内容の要旨
6 Connect the speaker cable to the speaker and 9 Attach the grill to the frame. your receiver. Please refer to page 6, “CONNECTIONS” section for detailed Glue strips instructions. 7 Place the speaker into the ceiling. Note: For secure grill attachment, application of the supplied glue strips is recommended. Recommended Glue Strip Location 8 Tighten each of the four screws evenly until the clamps at the back of the frame grip the ceiling to secure the speaker. Note: You can swivel the
ページ6に含まれる内容の要旨
CONNECTIONS Connect the screw-type input terminals at the rear of the speakers to the speaker output terminals of the receiver. Connect the (+) terminals on the receiver and speakers using the corresponding side of the cable. Connect the (–) terminals on both components using the other side of the cable. Receiver NS-IW360C +– Notes: Make sure that the bare wires are not touching each other as this could damage the speaker and receiver. Connect one speaker to the left terminals of your
ページ7に含まれる内容の要旨
PAINTING THE SPEAKER FRAME AND GRILL The speaker frame and grill can be painted to match your room décor. Use high quality spray paint and select a well ventilated area before proceeding. Painting the frame Painting the grill 1 Remove the speaker from the ceiling if it is already 1 Carefully remove the grill from the speaker, if installed. Also, remove the grill from the baffle. attached. 2 Mask the speaker components and the baffle with 2 Apply the paint to the grill. Make sure that the g
ページ8に含まれる内容の要旨
YAMAHA Electronics Corporation, USA, is proud of the experienced craftsmanship that goes into each and every YAMAHA Loudspeaker. YAMAHA sells its products only through a network of high quality, specially authorized dealers and is pleased to offer the following Limited Warranty, which applies only to products purchased by consumers directly from our authorized dealers. We suggest that you read the Limited Warranty thoroughly, and invite you to contact your authorized YAMAHA dealer or the YA
