ページ1に含まれる内容の要旨
TANDBERG and Wireless LANs
____________________________________
TANDBERG
D12809, Rev 1.0
This document is not to be reproduced in whole or in
part without the permission in writing from:
TANDBERG
ページ2に含まれる内容の要旨
TANDBERG TANDBERG and Wireless LANs Table of Contents 1. OVERVIEW OF WIRELESS STANDARDS ..............................................................................................3 IRELESS THERNET 1.1 802.11 W E .................................................................................................................... 3 1.1.1 802.11a .............................................................................................................................................
ページ3に含まれる内容の要旨
TANDBERG TANDBERG and Wireless LANs 1. Overview Of Wireless Standards 1.1 802.11 Wireless Ethernet Ethernet was pioneered by Xerox in the 1970’s and was in fact a registered trademark of Xerox Corporation. After further development, the technology was improved and became known as Ethernet II. Xerox, with the help from Digital and Intel began establishing and publishing the standards. Realizing the international community would not recognize the standard, IEEE was charged with formalizi
ページ4に含まれる内容の要旨
TANDBERG TANDBERG and Wireless LANs 2. TANDBERG’s Implementation TANDBERG has implemented the 802.11b standard into the TANDBERG 1000 product, using a standard PC card, to deliver 768kbps of exceptional video and audio quality. This feature allows for ‘hot desk’ applications where a video conferencing unit may be shared from desk to desk without the need for expensive Ethernet cabling. 2.1 Supported PC Cards TANDBERG continues to develop drivers for different wireless cards ba
ページ5に含まれる内容の要旨
TANDBERG TANDBERG and Wireless LANs The Community name, also known as Nickname, can be used to attach a TANDBERG unit to a specific access point when all access points share the same SSID. The feature is not required to function properly.
ページ6に含まれる内容の要旨
TANDBERG TANDBERG and Wireless LANs 2.2.3 Mode Requirement: Mandatory The mode setting allows for two different modes of operation. Also known as peer to peer and IBSS Ad Hoc. This mode is used when Adhoc: communication is required between two units and an access point is not available. Additionally , if there is no need to communicate with a wired unit on a standard LAN, you can use this option. This is similar to a ‘back to back’ Ethernet cable used to connect two IP enabled
ページ7に含まれる内容の要旨
TANDBERG TANDBERG and Wireless LANs the rollout of videoconferencing to be seamless and quick. Wireless LANs offer the following productivity, convenience, and cost advantages over traditional wired networks: : Wireless LAN systems can provide video users with the ability to make • Mobility video calls anywhere in their organization regardless if they have an Ethernet connection in the room. This mobility supports productivity and service opportunities not possible with wired networks.
ページ8に含まれる内容の要旨
TANDBERG TANDBERG and Wireless LANs • Network managers implement wireless LANs to provide backup for mission-critical applications running on wired networks. 4. Glossary Adhoc – A mode used to allow two 802.11b units to communicate without the use of an access point. ESSID – Extended SSID. See SSID. Infrastructure – See Managed Managed – A mode used to communicate to a 802.11b access point. This mode is necessary to communicate to a wire LAN through an access point. NIC –
