ページ1に含まれる内容の要旨
Always there to help you
Register your product and get support at
www.philips.com/welcome
SBT310/37
Question?
Contact
Philips
User manual
ページ2に含まれる内容の要旨
2
ページ3に含まれる内容の要旨
Contents 1 Important 4 Safety 4 Notice 5 2 Your Bluetooth Speaker 7 Introduction 7 What's in the box 7 Overview of the main unit 7 3 Get started 8 Connect power 8 Turn on 9 4 Play 9 Play from a Bluetooth device 9 Play from an external device 10 Control play 10 Adjust brightness 11 Set time 11 5 Product information 11 Specifications 11 6 Troubleshooting 12 EN 3
ページ4に含まれる内容の要旨
e Do not use this apparatus near water. 1 Important f Clean only with dry cloth. g Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. Safety h Do not install near any heat sources such as radiators, heat registers, stoves, or Know these safety symbols other apparatus (including amplifiers) that produce heat. i Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they
ページ5に含まれる内容の要旨
injury, property damage, or damage to of the FCC Rules. Operation is subject to the the unit: following two conditions: • Install all batteries correctly, + and - as (1) this device may not cause harmful marked on the unit. interference, and • Do not mix batteries (old and new or (2) this device must accept any interference carbon and alkaline, etc.). received, including interference that may cause • Remove batteries when the unit is not undesired operation. used for a long time. ( Fren
ページ6に含まれる内容の要旨
FCC Rules. These limits are designed to negativ e consequences on the en vironment and provide reasonable protection against harmful human health. interference in a residential installation. This Please visit www.recycle.philips.com for equipment gener ates, uses and can r adiate additional information on a recycling center in r adio frequency ener gy and, if not installed your area. and used in accordance with the instructions, Environmental information may cause harmful interference to
ページ7に含まれる内容の要旨
2 Your Bluetooth Overview of the main unit a Speaker b c Congratulations on your purchase, and w elcome to Philips! T o full y benefit from the support that Philips offers, register your product f at www.philips.com/welcome. g d e h Introduction a • Switch the speaker between standby With this speaker, you can enjoy audio from the mode and working mode. compatible Bluetooth device or other audio devices. b / • Adjust volume. • Adjust time. What's in the box c • In automatic
ページ8に含まれる内容の要旨
3 Get started Caution • Use of controls, adjustments, or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence . If you contact Philips, you will be asked for the AC power model and serial number of this apparatus. The model number and serial number are on the Caution bottom of the apparatus. Write the numbers here: • Risk of product damage! Make sure that the power
ページ9に含まれる内容の要旨
4 Play Turn on • Slide on the speaker to the right. » The Bluetooth indicator flashes (b lue). Play from a Bluetooth device Switch to standby mode The speaker switches to standby mode You can listen to a Buetooth device through this automatically in the following situations. speaker. • In Bluetooth mode: no audio signal from your Bluetooth device over 15 minutes. Note • In MP3 link mode: no audio signal • The effective operation range between the speaker detected over 15 minutes. and you
ページ10に含まれる内容の要旨
Play from a PC Play from an external device You can also listen to audio through Bluetooth You can also listen to an external audio device in PC. through this speaker. Note Note • Make sure that you have installed Bluetooth driver in your PC before pairing. • Your speaker can play under MP3-LINK audio only • The steps below are only for windows 7 operating when the Bluetooth paused or stopped. system. If you use other OS/IOS , refer to other OS/ IOS help. 1 Connect the MP3-LINK cable to: •
ページ11に含まれる内容の要旨
5 Product Adjust brightness information Note • You can adjust display brightness only when the AC power cord is plugged in. Note • Product information is subject to change without prior Press repeatedly to select different levels of notice. display brightness. Specifications Amplifier Rated Output Power 2 x 2 W RMS Signal to Noise Ratio >67 dB Set time Aux-in Link 600 mV RMS 20 kohm Note • You can set time only when the speaker is in standby mode. Bluetooth Bluetooth version V2.1+ EDR
ページ12に含まれる内容の要旨
6 Troubleshooting Warning • Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting ser vice . If the prob lem remains unsolved, go to the Philips web site (www. philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power • Make sure that the AC powe
ページ13に含まれる内容の要旨
EN 13
ページ14に含まれる内容の要旨
Specifications are subject to change without notice 2014 © WOOX Innovations Limited. All rights reserved. This product was brought to the market by WOOX Innovations Limited or one of its affiliates, further referred to in this document as WOOX Innovations, and is the manufacturer of the product. P&F is the warrantor in relation to the product with which this booklet was packaged. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. SBT310_37_UM_V2.
