ページ1に含まれる内容の要旨
O W N E R ' S M A N U A L
PAL-265 Precision Architectural Loudspeakers
www.parasound.com
1
ページ2に含まれる内容の要旨
PAL-265 Precision Architectural Loudspeakers Owner’s Manual www.parasound.com 2
ページ3に含まれる内容の要旨
Owner’s Manual PA L-265 Precision Architectural Loudspeakers 3
ページ4に含まれる内容の要旨
4
ページ5に含まれる内容の要旨
Introduction Congratulations on your purchase of your PAL-265 Precision Architectural Loudspeaker system and thank you for choosing Parasound. The PAL-265 Precision Architectural Loudspeakers were developed using the finest loudspeaker and crossover components available. Countless hours of computer modeling were spent to insure accurate audio reproduction in a variety of installations where placement compromises must sometimes be made. The PAL-265 Precision Architectural Loudspeakers mounted in
ページ6に含まれる内容の要旨
For best performance and easier troubleshooting, always “home run” wiring when installing multiple speakers rather than connecting from one speaker to the next. When connecting multiple speakers, make sure that the power amplifier is capable of adequately driving the combined impedance of the speakers. If not, you may need additional amplifiers or an impedance protection device that are often built into loudspeaker selection boxes. Installing the PAL-265 Precision Architectural Loudspeakers 1. C
ページ7に含まれる内容の要旨
Fine Tuning the Frequency Response of Your Loudspeakers Three Position Treble Adjustment High The PAL-265 treble adjustment switch allows you to adjust the tweeter level from 0 dB (flat) to -3 dB or + 3 dB. If you are mounting the speaker in a “live” room with many reflective surfaces, you may want to attenuate the treble response and tame sibilance. If you are mounting the speaker in a room with many absorptive surfaces, you may want to boost the treble response. Two Position Mid-Bass Contour A
ページ8に含まれる内容の要旨
Anti-diffraction Ring High Dome Tweeter Tone Adjustment IR Receiver Mid Switches Access Hole Kevlar Woofer with Phase Plug Swing arms in locked Swing arms in and mounted retracted position position Parasound PAL-265 Baffle and Bezel 8
ページ9に含まれる内容の要旨
PAL-265 Precision Architectural Loudspeaker Specifications Frequency Response 42 Hz-22 kHz +/- 2 dB Nominal Impedance 8 Ohms Minimum Impedance 6 Ohms Sensitivity 1 Watt/1Meter 88 dB RMS Power Range 10-80 Watts Woofer Size 6" Cone Material Kevlar Surround Material Polyurethane Tweeter Size 1 " Dome Tweeter Diaphragm Material Aluminum Crossover Frequency 2.4 kHz Crossover Slope 12 dB per octave Dimensions Hole Cut-Out 7 3/8" x 10 3/4" Outer Edge of Frame 8 5/8" x 12" Optional Accessories Rough-I
