ページ1に含まれる内容の要旨
operation
manual
MX-SERIES: MX-150THX
V-SERIES: V-125THX
Miller & Kreisel Sound Corporation
10391 Jefferson Boulevard
Culver City, CA 90232 USA
(310) 204-2854 FAX (310) 202-8782
© 1995 MILLER & KREISEL SOUND CORP.
Manufactured under license from Lucasfilm Ltd.
Lucasfilm and THX are registered trademarks of
Lucasfilm Ltd.
THX®powered subwoofers
ページ2に含まれる内容の要旨
THX subwoofers page 2 TABLE OF CONTENTS 1. SAFETY INSTRUCTIONS ................................................................................................ 3 2. INTRODUCTION ..............................................................................................................4 3. WHERE TO PLACE YOUR SUBWOOFER ..................................................................... 4 4. OPERATION WITH THX COMPONENTS........................................................................
ページ3に含まれる内容の要旨
THX subwoofers page 3 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: The exclamation point within an equi- The lightning flash with arrowhead, lateral triangle is intended to alert the within an equilateral triangle, is in- TO PREVENT THE RISK OF ELECTRIC tended to alert the user of the pres- user of the presence of important op- SHOCK, DO NOT REMOVE COVER (OR ence of uninsulated "dangerous volt- erating and maintenance (servicing) age" wit
ページ4に含まれる内容の要旨
THX subwoofers page 4 2. INTRODUCTION ® Congratulations! Your new M&K THX subwoofer truly represents the state-of-the-art in subwoofer performance. The new dimension of deep and powerful bass it provides will both thrill and excite you. We strongly encourage you to read this owner's manual, as there is a great deal of information provided here to help you get the best possible performance. Audio dealer, If you have any questions about your subwoofer, please contact your M&K Home THX or call
ページ5に含まれる内容の要旨
THX subwoofers page 5 OUTPUT jack on your THX controller to the "LEFT/MONO" "INPUT" jack on the subwoofer's backplate. See Figure 1 below. Some THX controllers have a pair of stereo subwoofer outputs, while others have a single mono output. Your subwoofer is compatible with both types. If your THX controller has stereo subwoofer outputs, use a stereo shielded cable, connecting it to the LEFT and RIGHT "INPUT" terminals on the subwoofer. If
ページ6に含まれる内容の要旨
THX subwoofers page 6 TESTING THE SUBWOOFER (THX MODE) Once all of the interconnect cables are in place, you are just about ready to plug in the subwoofer. Set the "LOW PASS FILTER" toggle switch to the "THX" position and the "BASS LEVEL" toggle switch to the "THX" position. Set the "SUBWOOFER PHASE" switch to the "+" position. If your THX controller has a SUBWOOFER (OFF/ON) switch on its front panel, rear panel, or remote control, set it to ON. (See the controller's manual for details). Plug
ページ7に含まれる内容の要旨
THX subwoofers page 7 For the V-125THX, the "CALIBRATED" level is 4 dB lower than the "THX" level (switch set to "THX"). Set the control to this mark if you have only one subwoofer in the system (such as in a very small room). On both the MX-150THX and V-125THX, the +2 and +4 marks indicate the points where your subwoofer is producing 2 dB and 4 dB more output than the "CALIBRATED" level. SETTING SUBWOOFER LEVEL (THX) The proper method of sett
ページ8に含まれる内容の要旨
THX subwoofers page 8 OPERATION OF THE "BASS LEVEL" SWITCH When using the subwoofer with a non-THX processor, preamp, etc., this switch should be set to the "VARIABLE" position. The subwoofer level can then be set independently to match your speakers. The "CALIBRATED" mark is a reference relative to THX levels. For a discussion of this "CALIBRATED" mark, please see "Operation of the Bass Level Switch" on page 7. WIRING WITH A NON-THX PROCESSOR OR PREAMP The "FROM PREAMP" RCA terminals on t
ページ9に含まれる内容の要旨
THX subwoofers page 9 FIGURE 5 - WIRING ONE SUBWOOFER TO AN AMP OR PREAMP WITH ONE SET OF PREAMP OUTPUTS POWER AMP MAIN IN BASS LEVEL LOW PASS LEFT RIGHT REFERENCE LEFT/MONO RIGHT FILTER + +3 dB VARIABLE 80 Hz 24 dB/OCTAVE +6 dB INPUT THX THX PHASE LEFT RIGHT PREAMP CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS: RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR. use one Y-connector for Manufactured under license from Lucasfilm Ltd. each channel to s
ページ10に含まれる内容の要旨
THX subwoofers page 10 To connect the subwoofer, run shielded RCA - RCA interconnect cables from the outputs on your component to the "INPUT" jacks found on the subwoofer's backplate. See Figure 5 on page 9. If your processor has a single subwoofer output, do not use a Y-connector to connect it to both the Left and Right input terminals of the subwoofer. The subwoofer combines both channels to mono in its amplifier input stage. If you are using two subwoofers, it is not necessary to use both i
ページ11に含まれる内容の要旨
THX subwoofers page 11 DO NOT PLUG THE SUBWOOFER INTO A SWITCHED OUTLET ON ANOTHER COMPONENT. THE SUBWOOFER CAN DRAW UP TO 400 WATTS FROM THE AC LINE. IT MUST BE PLUGGED INTO A SOLID AC LINE. Now, play some music through your system to make sure that the Satellite speakers are working properly. If they are, carefully advance the "BASS LEVEL" control. The subwoofer should begin to play. Set the "BASS LEVEL" control where the subwoofer sounds
ページ12に含まれる内容の要旨
THX subwoofers page 12 Here are two methods of setting the correct phase with your subwoofer. PHASING TEST METHOD ONE Set the switch labelled "SUBWOOFER PHASE" to the "+" position. Then, play a familiar CD, LP, laserdisc or tape with steady, consistent bass content. Listen carefully to the "mid-bass" region of 70 - 125 Hz. This is the part of the spectrum where electric or string basses and drums predominate. Then, reverse the position of the "SUBWOOFER PHASE" switch. If it is set to the "+"
ページ13に含まれる内容の要旨
THX subwoofers page 13 The amount and quality of bass you hear is dependent on the room itself. Low frequencies are affected by a room's size and type of construction. Rooms differ when it comes to reproducing bass, and in every room, bass quality changes when the subwoofer is moved from one location to another. A simple rule to remember is that you get more bass when you move the subwoofer towards any wall or corner. Moving it away from a wa
ページ14に含まれる内容の要旨
THX subwoofers page 14 9. USE OF SPIKED FEET WITH "MX" SUBWOOFERS If your M&K THX subwoofer is an "MX" push-pull dual driver subwoofer, we have enclosed a hardware kit consisting of four black metal spikes, threaded at one end and tapering to a sharp point at the other. Depending on their orientation, they can be used either as carpet spikes or rubber feet. To avoid damage to the floor, do not use the spiked end on hardwood or tile floors. By mounting these spikes into the threaded inserts moun
ページ15に含まれる内容の要旨
THX subwoofers page 15 2. If the midbass range (the area of transition between Subwoofer and Satellite or L/C/R speakers) sounds weak: See Section 7, PHASING TEST, on page 11. Reverse the position of the "SUBWOOFER PHASE" switch on the back panel of the subwoofer. The switch position that gives the most bass is correct. 3. If you hear a thump through the subwoofer every time you turn the rest of your audio system on (and your subwoofer is plu
ページ16に含まれる内容の要旨
THX subwoofers page 16 REPLACEMENT FUSE VALUES 110 VOLT 220 VOLT 220 VOLT (3 AG 1/4" x 1 1/4" slow blow) (5 X 20 mm IEC-127/III) MX-150THX 4 amp 2 amp T 1.6 A (time-lag) V-125THX 2 amp 1 amp T 800 mA (time-lag) 11. IF YOU NEED SERVICE Contact your dealer or M&K with a complete description of the problem. Please have the unit's model and serial numbers (found on the back of the cabinet), date of purchase, and your dealer's name. You can call
ページ17に含まれる内容の要旨
THX subwoofers page 17
