ページ1に含まれる内容の要旨
CS-BB2
ACTIVE SUBWOOFER SYSTEM: INSTRUCTIONS
LVT1544-001A
[J/U]
INFORMATION (For U.S.A.)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause ha
ページ2に含まれる内容の要旨
CONNECTIONS When using speaker input terminal NOTES: � The volume of this unit is set to the maximum when the remote controller is not connected. � If your receiver is equipped with the DSP (Digital Signal Processor), connect this unit to the front speaker output of the receiver. When using LINE IN jacks NOTES: � The volume of this unit is set to the maximum when remote controller is not connected. � If your receiver is equipped with the DSP (Digital Signal Processor), connect this unit to t
ページ3に含まれる内容の要旨
CONNECTIONS When connecting to subwoofer output Set the subwoofer output level to the maximum on your car receiver. � Use the supplied remote controller to adjust the volume. (When sound is distorted, lower the subwoofer output level on your car receiver.) NOTES: � When connecting to the Subwoofer Output jacks, make sure that the output level of the receiver is 2 V or lower; otherwise, sounds will be distorted. � The volume of this unit is set to the maximum when remote controller is not connect
ページ4に含まれる内容の要旨
OPERATIONS Attaching the remote controller • Do not place the remote controller where it will be exposed to direct sunlight. Cautions � When using this unit, deactivate all sound adjustment functions except volume level; otherwise, sound may be distorted. PHASE AND SOUND ADJUSTMENT Use a CD with rich bass sound to test and adjust phase and sound. Main Unit Remote Controller When your car receiver is equipped with Low Pass Filter, switch to “OFF.” Turns on and off the subwoofer ou
