ページ1に含まれる内容の要旨
MP A-201
W A RNING:
Improper installation could result in damage to the amplifi er and/or speakers.
Read all instructions before installation.
ページ2に含まれる内容の要旨
I IM M P PO OR RT TA AN NT T S SA AF FE ET TY Y I IN NS ST TR RU UC CT TI IO ON NS S Englis The light ning flash w it h arrow head The exclamation point within an symbol within an equilateral tri- C CA AU UT TI IO ON N equilateral triangle is intended R RI IS SK K O OF F E EL LE EC CT TR RI IC C S SH HO OC CK K angle, is intended to alert the user to alert the user to the presence D DO O N NO OT T O OP PE EN N to the presence of uninsulated of important operating and ma- C CA AU UT TI
ページ3に含まれる内容の要旨
C o n t en ts: Introduction Page 4 Features: Page 4 Jamo MPA-201 front panel Page 5 Jamo MPA-201 rear panel Page 6 Connection Page 8 Connecting examples Page 9 Passive subwoofer Page 9 Fullrange stereo Page 10 2 x 200W bridged Page 11 Daisy chain Page 12 Specifi cations Page 13 Warranty Page 14
ページ4に含まれる内容の要旨
In tr oduc tion Congratulations on your purchase of your new Jamo Multi-Purpose Amplifi er (MPA-201). It is backed by state-of-the-art engineering and manufacturing techniques to bring you the best quality craftsmanship and reliable performance. The MPA-201 is specifi cally designed for home theatre applications. Because of its ample power and two-channel capacity (stereo), it can f it into virtually any surround application. Narrow width chassis is designed for convenient shelf or system ra
ページ5に含まれる内容の要旨
Jamo MPA-201 front panel 1 Power LED Flashing blue - Standby mode Blue - Amplifi er On Flashing red - Thermal protection Red - Overload protection 2 Level adjustment 5
ページ6に含まれる内容の要旨
Jamo MPA-201 rear panel 120 volt version T5AL/250V 1 Power switch 7 Stereo/mono: Stereo mode - 2 x 100 watt 2 Socket for mains cable stereo output (4 ) Mono mode - 200 watt 3 Fuse/Fuse Jack monooutput (8) 4 Speaker output: Speakers terminals 8 On - AmpliÞ er ON 5 Low pass adjustment: y is adjustable AUTO - auto turn on mode Output frequenc 9 Line in: Line level input from source between 50 - 150 Hz. Only adjustable 10 Line out: Line level output when low pass is selec ted 5 6 Low pas
ページ7に含まれる内容の要旨
Jamo MPA-201 rear panel 220-240 volt version T2.5AL/250V 1 Power switch 7 Stereo/mono: Stereo mode - 2 x 100 watt 2 Socket for mains cable stereo output (4 ) Mono mode - 200 watt 3 Fuse/Fuse Jack monooutput (8) 4 Speaker output: Speakers terminals 8 On - AmpliÞ er ON 5 Low pass adjustment: y is adjustable AUTO - auto turn on mode Output frequenc 9 Line in: Line level input from source between 50 - 150 Hz. Only adjustable 10 Line out: Line level output when low pass is selec ted 5
ページ8に含まれる内容の要旨
Connection The Jamo MPA-201 is equipped with gold-plated push button binding posts which will accept very heavy stripped wire. Ask your local Jamo dealer for advice on the choice of cable. Connect the loudspeakers to your Jamo MPA-201 as follows: 1. Turn of the MPA-201 2. Carefully remove approx. 3/8" /10 mm of the insulating material - beware not to damage the conductors! 3. Twist the conductor ends 4. Push the binding posts so the conductors can easily fit into the holes Note: Make sure t
ページ9に含まれる内容の要旨
Connecting examples Passive subwoofer When Low pass is selec ted, you can adjust the low pass frequency between 50 - 150 Hz. This makes it possible to make the subwoofer match your front speakers. 9
ページ10に含まれる内容の要旨
Fullrange stereo 10
ページ11に含まれる内容の要旨
Connecting examples 2 x 200W bridged 11
ページ12に含まれる内容の要旨
Daisy chain When using this feature you can connect all the MPA-201 in parallel you need. 12
ページ13に含まれる内容の要旨
Specif ications Rated Power Output 100 Watts (Stereo) into 4 ohm Load 200 Watts (BTL) into 8 ohm Load <0.1% Total Harmonic Distortion (THD) Signal-to-Noise Ratio >100dB Crossover Freq. Responce (-3dB): @ Min position 18.5-55.2Hz 40Hz/0dB ref @ Max position 18.2-168.8Hz 40Hz/0dB ref Auto Turn On Sensitivity 5mV+/2mV Full Range 1KHz 5mV+/2mV Sub Input 50 Hz Delay „OFF“ Time 20 minutes Line Out Freq. Response (-3dB) 20Hz +/-5K - 20 KHz +/-5K 1KHz/0dB ref Input Impedance Line In 9.2K ohm,+/-5% Max.
ページ14に含まれる内容の要旨
� � � �� � � � � �� � �� � � �� � � � � � � � � � � �� � � � � � � � �� � � �� � �� ����� � � � ��� � � �� � � � � �� � ��� � � ��� � �� � � � � � � � �� � � � �� � � � � � �� � ��� � ��� � � �� � � � � � � �� � � � � � � � �� ����� � � �� �� � � �� � � �� � ��� � �� � �� � � �� � �� ��� �� � � � � �� � � � � �� � � �� �� � � � � � �� � ��� � � � � �� � � � �� � amplifi �� � � �� � � � � � �� � � � � �� � � �� � � � � �� � � � � ��� � � �� � � � �� � � � � � � �� � �� � � �� � � ��� �� �� � � �
ページ15に含まれる内容の要旨
ページ16に含まれる内容の要旨
MPA-201 / 02.2006
