ページ1に含まれる内容の要旨
PREPARATION
Parts list
(Qty) Component
Preassembled Loose Components
(1) Roto-molded subwoofer enclosure (1) 17’ Wire harness w/ pigtail style connector
(1) 8"; 2 ohm subwoofer (2) Attachment brackets
(1) 100W class "D" amplifier (4) 3/4" Pilot point wafer Phillips head screws
(1) Speaker grille (4) 1" Self taping wafer Phillips head screws
(1) 1/2" Ground screw
(1) Star washer
WIRING:
Note: Installer MUST disconnect speaker-input leads to amplifier when using line-level input
OVERVIEW
The Cla
ページ2に含まれる内容の要旨
Ia. WIRING USING A CLARION “T” HARNESS There are 2 methods to connect this product to the vehicle. Please refer to section Ia and Ib for each. • STEP 1: Remove the Radio. • STEP 2: Connect the "T" Harness. A. Unplug factory wires from radio. B. Plug the "T" harness in line with the radio wiring. SEE DIAGRAM 1. C. Connect the BLACK wire on "T" harness to radio chassis. • STEP 3: Route the wire harness from the radio to the rear passenger side of the vehicle. •STEP 4: Connect the amplifier gr
ページ3に含まれる内容の要旨
Extended Cab Instructions: II. RUN WIRE HARNESS A. Run harness to the rear of the vehicle underneath the rear folding seat on the driver’s side of the truck. III. ATTACH BRACKETS TO ENCLOSURE A. Place enclosure upright so that the rippled surface is down. B. Position brackets so that the vertical slots line up with the angled/lower set of dimples on the enclosure. C. Attached brackets using the supplied pilot point Phillips screws, screwing through the locating dimples on the enclosure (the dimp
ページ4に含まれる内容の要旨
Regular Cab Instructions: II. RUN WIRE HARNESS A. Run harness to the storage tray in the rear of the vehicle behind the passenger seat. III. ATTACH BRACKETS TO ENCLOSURE A. Place enclosure upright so that the rippled surface is down. B. Position brackets so that the vertical slots line up with the verti- cal set of dimples on the enclosure. C. Attached brackets with the supplied pilot point Phillips screws, screwing through the locating dimples on the enclosure (the dimples should be centered in
