Bogen MPS1Bの取扱説明書

ページ1に含まれる内容の要旨

MPS1
Mini Pendant Speaker
Models MPS1B/MPS1W
Installation and Use Manual
© 2010 Bogen Communications, Inc.
All rights reserved.
Specifications subject to change without notice.
54-2194-01A 1010

ページ2に含まれる内容の要旨

Power Tap Selection POWER TAP SELECTOR SWITCH 16-ohm or 70V The Power Tap selector switch is used to set the appropriate power level or impedance for your system. Rotate the switch until the power level you require lines up with arrow. IMPORTANT: When connecting to a 70V amplifier, make sure that the MPS1 Tap Selector switch IS NOT set in the “16Ω” position. MPS1 (Top View) Speaker Connection and Polarity Speaker wiring is terminated at a snap-lock input connector, with a positive and negative t

ページ3に含まれる内容の要旨

TO SPEAKER MPS1 Speaker Cable Connections ANCHOR and Suspension Instructions POINT In addition to the Main suspension Drop Cable, a backup Safety Cable is required for proper installation. Use wire rope or other drop line rated for at least 100 lbs. to ensure a safety margin. The attachment point on the structure from which MAIN the speaker is to be anchored also must be able SAFETY DROP to handle 100 lbs. CABLE CABLE NOTE: If using suspension cables with a cladding, be sure to strip away coati

ページ4に含まれる内容の要旨

Technical Specifications Frequency Response (-10dB)* 50Hz to 14kHz Driver Complement 4-1/2” Dual-Cone Wide-Range Sensitivity (1W/1m) 85dB (Average 100Hz – 10kHz) Impedance Range Low (16 Ohms) / High (70V) Power Input (Maximum) 50W @ 16 Ohms; 32W @ 70V Power Settings (in watts)** 70V: 32, 16, 8, 4, 2, 1 Enclosure Material ABS Plastic Injection-Molded Grille Material Powder-Coated Perforated Steel Terminations 2 Terminal Quick-Disconnect Connector Product Weight 4 lb. 8 oz. Speaker Dimensions 12”