ページ1に含まれる内容の要旨
BeoLab 8002
Guide
ページ2に含まれる内容の要旨
WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. Do not expose this equip ment to dripping or splashing and ensure that no objects filled with liquids, such as vases, are placed on the equipment. To completely disconnect this equipment from the AC Mains, disconnect the mains plug from the wall socket. The disconnect device shall remain readily operable. The lightning flash with arrowhead symbol within an equilateral triangle, is
ページ3に含まれる内容の要旨
Daily use 3 When you have finished setting If the loudspeakers are connected up the louds peakers as described to a non Bang & Olufsen system, on the following pages, connect they switch on when they receive a the entire system to the mains signal from the system (refer to supply. The indicator lights up p. 6). They switch off a few in red, indicating that the loud minutes after the signal has speakers are in standby, ready to disappeared. be used. The loud speakers are designed to be
ページ4に含まれる内容の要旨
Set up the loudspeaker 4 We recommend that you follow this procedure: – Disconnect your system from the mains supply. – Place the loudspeakers in your setup. – Set the switches to the correct setting. This is explained in ‘Adapt the loudspeakers to your setup’ (page 6). – Connect your speaker system. – Connect the entire system to the Cautions Column and base mains again. – Make sure that the loudspeakers It is easiest to assemble the base and are placed and connected in the speaker
ページ5に含まれる内容の要旨
Cable connections 5 The loudspeakers can be used with Bang & Olufsen audio, video and link systems. They may also be used with non Bang & Olufsen systems. For specific information about the sockets on Connection to the your system, refer to the Guide mains supply enclosed with the system. POWER LINK socket Mains cord: The supplied mains cord and plug are specially designed for the product. If you change the SETUP plug or damage the mains cord, L R SETUP switch LINE you must
ページ6に含まれる内容の要旨
Adapt the loudspeakers to your setup 6 SETUP L R LINE The loudspeakers may be placed POSITION SETUP L almost anywhere in your room. R LINE However, the most natural POSITION sound is obtained if they are set up as explained in this section. SETUP switch POSITION switch This switch has three settings: LEFT, When a loud speaker is placed in a RIGHT and LINE. Set the switch to corner or close to a wall, the bass LEFT or RIGHT when connecting level is boosted compared to the the lou
ページ7に含まれる内容の要旨
7 Position zones: The three settings (free, wall and corner) correspond to the position zones marked in different shades of grey. The POSITION switch has three wall settings: free, wall and Use this setting if the louds peaker corner. is placed less than 15 cm (6") from the wall, and no closer to a corner free than 50 cm (20") – shown by the Use this setting if the louds peaker is grey areas along the walls in the placed more than 15 cm (6") from illustration. the wall, and no c
ページ8に含まれる内容の要旨
>> Adapt the loudspeakers to your setup 8 Cable cover: The rubber tube packed with the loud speakers is a cable cover specially designed for the loudspeakers. Use the enclosed tool to “zip up” the cable cover when you have placed both the mains cord and the Power Link cable inside it. The special adaptor, part no. 6270706, can be used to connect additional pairs of loud speakers to your Bang & Olufsen system. The adaptor is available as an optional accessory from your Bang & Olufse
ページ9に含まれる内容の要旨
9 Waste Electrical and Electronic Electrical and electronic equipment, and waste prevents the potential Equipment (WEEE) – parts and batteries marked with contamination of nature with the Environmental protection this symbol must not be disposed hazardous substances which may of with normal household wastage; be present in electrical and elec all electrical and electronic equip tronic products and equipment. ment, parts and batteries must be Your Bang & Olufsen retailer will collected and
ページ10に含まれる内容の要旨
10 For the Canadian market only! This class B digital apparatus meets all require ments of the Canadian Interference Causing Equipment Regulations. For the US-market only! NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harm ful interference in a residential installation. This equipment generates, uses and can radiate rad
ページ11に含まれる内容の要旨
ページ12に含まれる内容の要旨
3510507 1002
