ページ1に含まれる内容の要旨
Box
IP8155/65HP Network Camera
User’s Manual
1.3/2MP • WDR Pro • Remote back Focus
Rev. 1.0
ページ2に含まれる内容の要旨
VIVOTEK Table of Contents Overview ����������������������������������������������������������������������������������������������������������������������������������������������������� 4 Revision History �������������������������������������������������������������������������������������������������������������������������������������� 4 Read Before Use ����������������������������������������������������
ページ3に含まれる内容の要旨
VIVOTEK URL Commands for the Network Camera ������������������������������������������������������������������������������������������������ 133 Technical Specifications ��������������������������������������������������������������������������������������������������������������������������� 226 Technology License Notice �������������������������� ��������������������������������������������������������������������������������������������� 227 Electromagnetic Compatibility (EMC) �������������
ページ4に含まれる内容の要旨
VIVOTEK Overview VIVOTEK IP8155HP and 8165HP is a professional box network camera series offering up to 60 fps @ 1�3- or 2-Megapixel resolution with superb image quality � Featuring the new improved Wide Dynamic Range Technology WDR Pro II, (WDR Pro for IP8165HP), it provides extreme visibility in high light contrast environments with 4-shutter capture method� Combined with 3D Noise Reduction Technology, which enables the IP8155HP to capture clear, polished video under low-light conditions
ページ5に含まれる内容の要旨
VIVOTEK Read Before Use The use of surveillance devices may be prohibited by law in your country� The Network Camera is not only a high-performance web-ready camera but can also be part of a flexible surveillance system� It is the user’s responsibility to ensure that the operation of such devices is legal before installing this unit for its intended use� It is important to first verify that all contents received are complete according to the Package Contents listed below� Take note of the
ページ6に含まれる内容の要旨
VIVOTEK Physical Description Front Panel Light Sensor Lens Rear Panel Recessed Reset Button Microphone In Audio Out SD/SDHC Card Slot Focus Assist Button Ethernet 10/100 RJ45 General I/O Terminal Block Socket Status LED NTSC/PAL Switch BNC Video Out 6 - User's Manual
ページ7に含まれる内容の要旨
VIVOTEK Lens Zoom Controller Focus Controller Mounting the Lens to the Camera 1� Mount the lens by turning it clockwise onto the camera mount until it stops� 2� Connect the P-iris control cable to the socket� 2 1 User's Manual - 7
ページ8に含まれる内容の要旨
VIVOTEK General I/O Terminal Block This Network Camera provides a general I/O terminal block which is used to connect external input / output devices. The pin definitions are described below. The “AC/DC pw” pins can be used to connect both 24V AC and 12V DC power source� DO+ DO- DI1+ DI2+ DI3+ DI- (common GND) RS485- RS485+ AC/DC pw AC/DC pw DI/DO Diagram Please refer to the following illustration for the connection method� 12V +12V Power+12V Digital input Digital output Ground GND GND VDC
ページ9に含まれる内容の要旨
VIVOTEK Hardware Reset Recessed Reset Button The reset button is used to reset the system or restore the factory default settings� Sometimes resetting the system can return the camera to normal operation If � the system problems remain after reset, restore the factory settings and install again� Reset: Press and release the recessed reset button with a straightened paper clip. Wait for the Network Camera to reboot� Restore: Press and hold the recessed reset button until the status LED rapi
ページ10に含まれる内容の要旨
PARTITION LINK RECEIVE POWER COLLISION 1 2 3 4 5 VIVOTEK Network Deployment General Connection (with PoE) 1. If you have external devices such as sensors and alarms, connect them to the general I/O terminal block� 2� Connect the camera to a switch via Ethernet cable� 3� Connect the power cable from the Network Camera to a power outlet� 1 DO+ � 2 DO- � 3� DI1+ 4 DI2+ � 5� DI3+ 6� DI- (common GND) 1 2 7� RS485- 8: RS485+ 9. AC/DC pw 10. AC/DC pw PoE Switch NOTE: 1 � The camera is only
ページ11に含まれる内容の要旨
PARTITION LINK RECEIVE POWER COLLISION 1 2 3 4 5 VIVOTEK Internet connection via a router Before setting up the Network Camera over the Internet, make sure you have a router and follow the steps below� 1 Connect your Network Camera � behind a router, the Internet environment is illustrated below � Regarding how to obtain your IP address, please refer to Software Installation on page 13 for details� IP address : 192.168.0.3 WAN (Wide Area Network ) Subnet mask : 255.255.255.0 Router IP addre
ページ12に含まれる内容の要旨
VIVOTEK Configure the router, virtual server or firewall, so that the router can forward any data com- ing into a preconfigured port number to a network camera on the private network, and allow data from the camera to be transmitted to the outside of the network over the same path � From Forward to 122.146.57.120:8000 192.168.2.10:80 122.146.57.120:8001 192.168.2.11:80 ��� ��� When properly configured, you can access a camera behind the router using the HTTP request as follows: http://122.1
ページ13に含まれる内容の要旨
VIVOTEK Software Installation Installation Wizard 2 (IW2), free-bundled software included on the product CD, helps you set up your Network Camera on the LAN� IW2 1� Install IW2 under the Software Utility directory from the software CD� Installation Double-click the IW2 shortcut on your desktop to launch the program� Wizard 2 2 � The program will conduct an analysis of your network environment� After your network environment is analyzed, please click Next to continue the program� 3�
ページ14に含まれる内容の要旨
∞ VIVOTEK Ready to Use 1� A browser session with the Network Camera should prompt as shown below� 2� You should be able to see live video from your camera � You may also install the 32-channel recording software from the software CD in a deployment consisting of multiple cameras� For its installation details, please refer to its related documents� 3. Unscrew the zoom controller to adjust the zoom factor. Upon completion, tighten the zoom controller� 4� Unscrew the focus controller to adjust
ページ15に含まれる内容の要旨
VIVOTEK NOTE: When choosing the lens for your camera, please notice the specifications as below. The screw mount (distance A-C) must be shorter than 5�2mm; in case that the bottom of screw mount may hit the IR Cut Filter� A C User's Manual - 15
ページ16に含まれる内容の要旨
VIVOTEK Accessing the Network Camera This chapter explains how to access the Network Camera through web browsers, RTSP players, 3GPP-compatible mobile devices, and VIVOTEK recording software� Using Web Browsers Use Installation Wizard 2 (IW2) to access the Network Cameras on LAN. If your network environment is not a LAN, follow these steps to access the Netwotk Camera: ® 1 Launch your web browser (e � g � �, Microsoft Internet Explorer or Mozilla Firefox). 2. Enter the IP address of the Net
ページ17に含まれる内容の要旨
VIVOTEK ► By default, the Network Camera is not password-protected. To prevent unauthorized access, it is highly recommended to set a password for the Network Camera� For more information about how to enable password protection, please refer to Security on page 81� ® ► If you see a dialog box indicating that your security settings prohibit running ActiveX ® Controls, please enable the ActiveX Controls for your browser� 1 Choose � Tools > Internet Options > Security > Custom Level� ® 2. Lo
ページ18に含まれる内容の要旨
VIVOTEK IMPORTANT: 1. Currently the Network Camera utilizes 32-bit ActiveX plugin. You CAN NOT open a management/view session with the camera using a 64-bit IE browser. 2. If you encounter this problem, try execute the Iexplore.exe program from C:\Windows\ SysWOW64� A 32-bit version of IE browser will be installed� 3. On Windows 7, the 32-bit explorer browser can be accessed from here: C:\Program Files (x86)\Internet Explorer\iexplore.exe NOTE: 1. For a megapixel camera, it is recommended
ページ19に含まれる内容の要旨
VIVOTEK Using RTSP Players To view the MPEG-4 streaming media using RTSP players, you can use one of the following players that support RTSP streaming� Quick Time Player VLC media player VLC media player 1 Launch the R � TSP player � mpegable Player 2 Choose File > Open URL � � A URL dialog box will pop up� 3. The address format is rtsp://:/ As mo
ページ20に含まれる内容の要旨
VIVOTEK Using 3GPP-compatible Mobile Devices To view the streaming media through 3GPP-compatible mobile devices, make sure the Network Camera can be accessed over the Internet� For more information on how to set up the Network Camera over the Internet, please refer to Setup the Network Camera over the Internet on page 10� To utilize this feature, please check the following settings on your Network Camera: 1� Because most players on 3GPP mobile phones do not support RTSP authentication, make
