ページ1に含まれる内容の要旨
Scanners
Patch Code Information
A-61599
CAT No. 845 9380
A-61599
October 2006
ページ2に含まれる内容の要旨
Patch Code Information for Kodak Scanners Patch description This document provides information that supports the following scanners. • Kodak Scanners 9XYZ, 5XYZ, 7XYZ, i800/i1800 (with image addressing) Series Scanners and the Kodak Microimager 70—these scanners are equipped with the Patch Reader. The Patch Reader recognizes patches with bars that are parallel to the lead edge of the document. All of these scanners may use patches for image addressing. In addition, the i800/i1800 (with image add
ページ3に含まれる内容の要旨
Patch Types 1, 4 and 6 can be used by the host for post-scan image control for the i800/i1800 (with image addressing) Series Scanners (they are not used for image addressing). The Toggle Patch may be used to switch back and forth from bi-tonal and color/grayscale scanning for the i280, 3590C, i600, i800 and i1800 (without image addressing) Series Scanners. This provides Color on the Fly during capture, with no need for post-scan processing by the host application. NOTE: The patch codes illustrat
ページ4に含まれる内容の要旨
For Kodak Scanners 9XYZ, 5XYZ, 7XYZ, i800/i1800 (with image addressing) Series Scanners and 70 Microimager: The minimum overall length of the patch bars is 2 inches (50 mm). Patch positioning Horizontal placement/positioning • There are five patch sensor locations for the Horizontal and vertical placement of the patch code scanner models listed above, except for the i1800 is critical for proper operation. If the patch code is Series Scanners which have four patch sensor placed improperly on the
ページ5に含まれる内容の要旨
Leading Edge of Document (fed into transport first) A BC Vertical placement/positioning • Patch codes must appear at least 0.25 inches (6 mm) from the right, left, and leading edges of the document. 3.75 inches (94 mm) • Patch codes must appear no more than 3.75 inches (94 mm) from the leading edge of the document [1.6 inches (40 mm) on the 5XYZ and 7XYZ Scanners]. Refer to Figure B. Patch Area Figure B A, B, and C = 0.25 inches (6 mm) Patch Reader Positions for 9XYZ, 5XYZ, 7XYZ, i800 Series Sca
ページ6に含まれる内容の要旨
For i280, 3590C and i600/i1800 (without image addressing) Series Scanners • The Patch Reading Area ends 2.0 inches from the lead edge of the document. At least 0.75 inches of The minimum overall length of the patch bars is the patch code must appear within the Patch 0.75 inches (19 mm). Reading Area. Patch Positioning Horizontal and vertical placement of the patch code is critical for proper operation. If the patch code is placed improperly on the document, the scanner may fail to read the patch
ページ7に含まれる内容の要旨
ページ8に含まれる内容の要旨
A-61599 10/06 Printed in U.S.A. Eastman Kodak Company Document Imaging Rochester, New York 14650 © Kodak,2006. Kodak is a trademark Kodak.