ページ1に含まれる内容の要旨
USER GUIDE
BUSINESS SERIES
10/100 4-Port
VPN Router
Model: RV042
ページ2に含まれる内容の要旨
About This Guide Copyright and Trademarks About This Guide Linksys, Cisco and the Cisco Logo are registered trademarks or Icon Descriptions trademarks of Cisco Systems, Inc. While reading through the User Guide you may see and/or its affiliates in the U.S. and various icons that call attention to specific items. Below is certain other countries. Copyright a description of these icons: © 2008 Cisco Systems, Inc. All rights reserved. Trend Micro, InterScan, and NOTE: This check mark in
ページ3に含まれる内容の要旨
Table of Contents Chapter 1: Introduction 1 Introduction to the Router. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Introduction to VPNs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 VPN Examples. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 VPN Router to VPN Router . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Computer (using VPN client s
ページ4に含まれる内容の要旨
Table of Contents One-to-One NAT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16 Setup > MAC Clone . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16 MAC Clone . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17 Setup > DDNS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17 DDNS . .
ページ5に含まれる内容の要旨
Table of Contents VPN > Client to Gateway . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .40 Add a New Tunnel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .41 IPSec Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .44 VPN > VPN Client Access . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .46 VPN Client Access . . . . . . . . . . . . . . . . . . . .
ページ6に含まれる内容の要旨
Table of Contents Configuration of PC 1 and PC 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .63 Configuration when the Remote Gateway Uses a Dynamic IP Address . . . . . . . . . . . .64 Configuration of the RVL200. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .64 Configuration of the RV042 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .64 Configuration of PC 1 and PC 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ7に含まれる内容の要旨
Table of Contents Appendix I: Warranty Information 82 Exclusions and Limitations. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .82 Obtaining Warranty Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .82 Technical Support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .83 Appendix J: Software License Agreement 84 Software in Linksys Products: . . . . . . . . . . . . . . . . . . . . . . . . .
ページ8に含まれる内容の要旨
Introduction Chapter 1 For an IPSec VPN tunnel, the VPN Router and any computer Chapter 1: with the built-in IPSec Security Manager (Windows 2000 and XP) can create a VPN tunnel using IPSec (Windows Introduction Vista uses a similar utility). Other Windows operating systems require additional, third-party VPN client software applications that support IPSec to be installed. Introduction to the Router Thank you for choosing the Linksys 10/100 4-Port VPN NOTE: The 10/100 4-Port VPN Router s
ページ9に含まれる内容の要旨
Introduction Chapter 1 Computer (using VPN client software) to VPN Router The following is an example of a computer-to-VPN Router VPN. In her hotel room, a traveling businesswoman connects to her Internet Service Provider (ISP). Her notebook computer has VPN client software that is configured with her office’s VPN settings. She accesses the VPN client software and connects to the VPN Router at the central office. As VPNs use the Internet, distance is not a factor. Using the VPN, the bus
ページ10に含まれる内容の要旨
Product Overview Chapter 2 Reset The Reset button can be used for a warm Chapter 2: reset or a reset to factory defaults. Product Overview • Warm Reset If the Router is having problems connecting to the Internet, press and hold in the Reset button for a Front Panel second using the tip of a pen. This is similar to pressing the power button on your computer to reboot it. • Reset to Factory Defaults If you are experiencing extreme problems with the Router and have tried all other troub
ページ11に含まれる内容の要旨
Installation Chapter 3 Follow these instructions: Chapter 3: 1. Determine where you want to mount the Router. Make sure that the wall you use is smooth, flat, dry, and Installation sturdy. Also make sure the location is within reach of an electrical outlet. Physical Installation 2. Drill two holes into the wall. Make sure the holes are 57 mm (2.24 inches) apart. There are two ways to place the Router. The first way is to place the Router horizontally on a surface. The second 3. Insert
ページ12に含まれる内容の要旨
Installation Chapter 3 2. Connect one end of an Ethernet network cable to 5. Connect the included power adapter to the Router’s one of the numbered ports on the back of the Router. Power port, and then plug the power adapter into an Connect the other end to an Ethernet port on a electrical outlet. network device, such as a computer or switch. Repeat this step to connect more computers or other network devices to the Router. Connect the Power 6. The System LED on the front panel will light up
ページ13に含まれる内容の要旨
Advanced Configuration Chapter 4 System Summary Chapter 4: The first screen that appears is the System Summary Advanced Configuration screen, which displays the Router’s current status and settings. This information is read-only. Underlined text is hyperlinked to related setup pages, so if you click a Overview hyperlink, the related setup screen will appear. On the The Router’s web-based utility allows you to set up right-hand side of this screen and all other screens of the the Router a
ページ14に含まれる内容の要旨
Advanced Configuration Chapter 4 System Up Time This is the length of time in days, hours, and minutes that the Router has been active. The current time and date are also displayed. Trend Micro™ ProtectLink Gateway The optional Trend Micro ProtectLink Gateway service provides security for your network. It checks e-mail messages, filters website addresses (URLs), and blocks potentially malicious websites. NOTE: If the Trend Micro ProtectLink Gateway options are not displayed on the System
ページ15に含まれる内容の要旨
Advanced Configuration Chapter 4 DDNS It shows the DDNS settings of the Router’s WAN port(s) and hyperlinks to the Setup > DDNS screen. DMZ Host It shows the DMZ private IP address and hyperlinks to the Setup > DMZ Host screen. The default is Disabled. Firewall Setting Status SPI (Stateful Packet Inspection) It shows the status (On/Off) of the SPI setting and hyperlinks to the Firewall > General screen. DoS (Denial of Service) It shows the status (On/Off) of the DoS setting and hyperlinks
ページ16に含まれる内容の要旨
Advanced Configuration Chapter 4 be sent out, probably use incorrect settings,” will be displayed. Setup Tab > Network The Network screen shows all of the Router’s basic setup functions. The Router can be used in most network setups without changing any of the default values; however, you may need to enter additional information in order to connect to the Internet through an ISP (Internet Service Provider) or broadband (DSL or cable) carrier. The setup information is provided by your ISP.
ページ17に含まれる内容の要旨
Advanced Configuration Chapter 4 If you want to modify a subnet you have created, select Dual-WAN/DMZ Setting it and make changes. Click Save Settings to save your Before configuring the WAN Connection Type settings, changes, or click Cancel Changes to undo them. Click select Dual WAN or DMZ. The Dual WAN setting allows you Exit to return to the Network screen. to simultaneously connect two broadband connections to If you want to delete a subnet you have created, select it the Router. On
ページ18に含まれる内容の要旨
Advanced Configuration Chapter 4 Service Name Enter the Service Name, if provided by your ISP. Connect on Demand If you select the Connect on Demand option, the connection will be disconnected after a specified period of inactivity (Max Idle Time). If you have been disconnected due to inactivity, Connect on Demand enables the Router to automatically re-establish your connection as soon as you attempt to access the Internet again. Enter the number of minutes you want to have elapsed befor
ページ19に含まれる内容の要旨
Advanced Configuration Chapter 4 Default Gateway Address Enter the IP address of the default gateway. User Name and Password Enter your account’s User Name and Password. The maximum number of characters is 60. Connect on Demand If you select the Connect on Demand option, the connection will be disconnected DMZ (Subnet) after a specified period of inactivity (Max Idle Time). If you Subnet To specify a subnet, select this option and have been disconnected due to inactivity, Connect on conf
ページ20に含まれる内容の要旨
Advanced Configuration Chapter 4 Daylight Saving To use the daylight saving feature, select Enabled. Enter the Month and Day of the start date, and then enter the Month and Day of the end date. NTP Server Enter the URL or IP address of the NTP server. The default is time.nist.gov. Manual Setup > Password Password The User Name is admin; it cannot be changed. Old Password Enter the old password. The default is admin when you first power up the Router. New Password Enter a new password for th
