ページ1に含まれる内容の要旨
OPERATING INSTRUCTIONS
-
-
KEYLESS ENTRY SYSTEM the following features may not be available depending on the type of input used to
• Y RUN MODE
This device complies with FCC Rules part 15. Operation is subject to the following
two conditions: 1) This device may not cause interference, and (2) this device must
accept any interference that may be received, including interference that may
cause undesired operation. The manufacturer is not responsi
ページ2に含まれる内容の要旨
WARNINGS TO: a) Understand the operation of this system and its safety features. b) Check for proper operation of these safety features prior to against accident and theft. DO NOT remote start the vehicle in a closed garage. Make sure that the Failure to observe this rule could result in injury or death from poisonous Carbon Monoxide fumes. DO NOT install the Remote Engine Starting System on MANUAL TRANSMISSION vehicles or vehicles which ca n not be vehicle. These vehicles
ページ3に含まれる内容の要旨
• - Engine will remain running for programmed run time until reset with Brake pedal or turned off with remote SOLID 6 THEN SOLID - UN SUCCESSFUL START: In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, then nd rd nd rd If Third attempt fails to start engine, the system will turn off and doors will remain locked. NO FURTHER ATTEMPTS WILL BE MADE AUTOMATICALLY - lock/re - arm if applicabl
ページ4に含まれる内容の要旨
IDLE DOWN MODE the vehicle. The vehicle is put into a remote running condition before you exit and it will remain running for the • • IDLE DOWN MODE - EXITING THE VEHICLE: Engine will remain running for programmed run time. 6) en remote lock doors if desired. Exit vehicle th 5) Turn Ignition switch OFF. Engine will remain running. 4) Doors will unlock, or if brake pedal is being depressed doors will unlock when it is released. 3) Parking Ligh
ページ5に含まれる内容の要旨
IDLE DOWN MODE - EXITING THE VEHICLE: IGN OFF UNLOCK - DOWN” or “INFINITY RUN” MODES: With engine running in "IDLE DOWN" (parking lights ON), unlo ck door or (Remote unlock or disarm alarm if START INDEFINITELY after the programmed run time elapses . This mode is especially desirable for protecting poli emergency, or work vehicles that need to be left running unattended. This mode will allow the vehicle to be left the ignition key in the switch preventing
ページ6に含まれる内容の要旨
– NG THE VEHICLE: ll unlock. IGN OFF 2X REMOTE LOCK / UNLOCK: - grind is enabled/disabled Doors lock automatically when vehicle is Remote Started. Starter Disable/Anti NOTES: ne is still being controlled by the remote starter. and lights will flash but return to solid indicating engi Parking lights will flash twice for unlock and once for lock. If vehicle is remote started, engine will remain running 2) s the Lock or Unlock transmitter button as yo
ページ7に含まれる内容の要旨
- - REMOTE TRUNK RELEASE: n valet mode. In the event of a lost or broken transmitter, the - With the key in the ON position, press and hold Program/Valet switch for 6 seconds. LED will turn on - start and keyless entry (if needed). This feature will maintain the original integrity and security of your vehicle’s - Prevents User from accidentally grinding the starter if the Ignition key is turned too far to the start position while Starter Power Fu
ページ8に含まれる内容の要旨
TRANSMITTER PROGRAMMING: START CRIM ESTOPPER , INC. 1770 SOUTH TAPO ST. SIMI VALLEY, CA. 93063 CRIMESTOPPER SECURITY PRODUCTS FLASH PRESS 4X's 4 FLASHES WAIT FOR OFF IGN TRANSMITTER PROGRAMMING: locations are learned, the unit will automatically exit code learning mode, otherwise turn key off and close hood. to be coded. You should get light flashes with each code learned. If all 4 code Press button #1 of the transmitter 4. Press Programming button 4 ti
ページ9に含まれる内容の要旨
RS900I OP REVA