ページ1に含まれる内容の要旨
O N E - WA Y A U T O MA T I C / M A N U A L
TR ANS MIS S I O N RE M O TE S T AR T E R
WI T H FUL L AL A R M S Y STEM
AS-6250v
User Guide
WARNING
It is the responsibility of the vehicle operator to ensure their vehicle
is parked in a safe and responsible manner.
1. a) Manual transmission: When leaving the vehicle, it is the user’s
responsibility to ensure that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in order to avoid a
ページ2に含まれる内容の要旨
Table of Contents Transmitter Part Number and Module Serial User-selectable Options................................... 9 Number............................................................... 3 Safe Start..................................................... 9 Introduction ....................................................... 3 Remote Door Locks................................... 10 Basic Remote Operation .................................. 4 Passive or Active Arming........................
ページ3に含まれる内容の要旨
Transmitter Part Number and Module Serial Number Transmitter Part Number: The installer is to write in the boxes below the Module’s serial number and the location of the Valet Switch. Module Serial Number: Valet Switch is located (if installed): Introduction This Module is a state-of-the-art combination of an Alarm system and a remote car starter. It represents a major breakthrough in vehicle security technology and remote starter systems. This unit is distributed wi
ページ4に含まれる内容の要旨
Basic Remote Operation This system is equipped with a 5-button multi-channel transmitter. It can operate two in- dependent identically-equipped vehicles (see Multi-Car Operation for second-car transmitter functions). The functions of the transmitter are as follows: UNLOCK: Unlocks the doors LOCK: Locks the doors and arms and disarms the STARTER the STARTER KILL. Triggers Panic KILL. Activates the AUX 2 if pressed more than 3 seconds output if priority door access is configured. Trigg
ページ5に含まれる内容の要旨
quickly and remain lit. Skip to step 4. 3. Within 20 sec. of engaging the parking brake, press and hold LOCK, UNLOCK or START/STOP on the transmitter. - The parking lights will flash 3 times quickly and remain lit. 4. Remove the key: the engine will continue running. 5. Exit the vehicle and close all doors, hood and trunk. 6. Press for approx. 1 second either: LOCK to lock the doors and shut down the engine; UNLOCK to unlock the doors and shut down the engine; START/STOP to shut down
ページ6に含まれる内容の要旨
delivery or at a convenience store, lock your vehicle and leave it running for the length of a run cycle while you are away. To leave the vehicle in Idle Mode if your vehicle has an automatic transmission: 1. With the engine running, press the LOCK or UNLOCK button (to unlock the doors) or the START button on the remote control until the parking lights come on. 2. Remove the key and exit the vehicle. The engine will go on running. 3. Lock the doors if needed. The engine will go on running
ページ7に含まれる内容の要旨
Ignition Valet The system can be placed in Valet Mode to disable the remote starting capabilities. If the vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine from being accidentally started by remote control. To ENTER Valet Mode 1. With the key in the Ignition switch, turn the key to the ON (RUN/IGNITION) and then OFF positions 5 times within 10 seconds. 2. The Parking Light will flash 3 times indicating the Module is now in Valet Mode. The LED wi
ページ8に含まれる内容の要旨
4. Flash twice again. Panic Mode Safety feature: Activate Panic Mode in an emergency situation. In an emergency situation, you can activate Panic Mode using the LOCK or UNLOCK or STOP button. This will: Shut down the engine, Disarm the Starter Kill and Unlock the doors (if UNLOCK is Activate the siren for 1 minute. pressed) (See below for a description of the Starter Or lock the door (if LOCK is pressed), Kill.) To activate Panic Mode Press and hold the STOP button for approximately 3
ページ9に含まれる内容の要旨
Priority Door Access This safety feature lets you unlock only the driver’s door when you press the UNLOCK button on the transmitter, and then UNLOCK the rest of the vehicle doors if the UNLOCK button is pressed for a second time within 3 seconds. Chirp Delete To temporarily disable the siren’s chirp confirmations upon arming and disarming (e.g. in a quiet neighbourhood): 1. Press the TRUNK button, the Parking Light will flash once 2. Within 3 seconds, press the LOCK or UNLOCK button to
ページ10に含まれる内容の要旨
Remote Door Locks If your system was installed with the Remote Door Locks option, you will have the convenience of remote keyless entry. To UNLOCK your doors and DISARM the system: 1. Press and hold the UNLOCK button for approx. 1 sec. 2. The parking lights will flash twice and the LED will go out to confirm that the doors have been unlocked, that the Starter Kill feature is disarmed (if it was installed) and that the Alarm is disabled. To LOCK your doors and ARM the system: 1. Press an
ページ11に含まれる内容の要旨
Open Zone Notification (the system will warn for doors opened up to 10 seconds after arming). No Chirp (the vehicle will not chirp under any circumstance). Open Zone Notification (Off by default.) This feature will warn the user when a Door is left open: upon the arming of the Module, a 10-sec. notification delay will take place, after which the Siren will chirp 3 times if an open door is detected. Ignition-Controlled Door Locks This is an added security feature. If your system was insta
ページ12に含まれる内容の要旨
If your vehicle has an automatic transmission, proceed as follows to set the system in Turbo Mode: 1. With the engine already running, press the LOCK button on the transmitter until the parking lights come ON. 2. Remove the ignition key from the ignition switch. The engine will go on running. 3. Exit the vehicle and close the door. 4. Press the TRUNK button to lock the doors; the engine will shut down after 60 seconds of Turbo Mode. If your vehicle has a manual transmission, follow all
ページ13に含まれる内容の要旨
Multi-Car Operation This option allows the owner of two vehicles, both equipped with identical systems, to control both systems with only one remote transmitter. To control the second vehicle, simultaneously press the TRUNK button and the button of the function you wish to use: Press TRUNK + LOCK button simultaneously: LOCK Press TRUNK + UNLOCK: UNLOCK Press TRUNK + START: START Press TRUNK + STOP: STOP Press TRUNK + LOCK + UNLOCK: AUX 3 (TRUNK) Press TRUNK + START for 3 sec: COLD WEA
ページ14に含まれる内容の要旨
Parking Lights Flash Rate (Normal Operation) Flashes Description • Doors locked, Alarm and starter kill armed. • Start signal received by the module. 1 • Run time has expired. • Cold weather mode cancelled. • TRUNK button pressed. • Remote start attempt cancelled by remote. • Exiting remote valet • Doors unlocked, starter kill disarmed. • Power-up reset. 2 • Exiting ignition valet • Board set from manual to automatic; • Power ON to OFF(Automatic power ON transmission) 2 slow flas
ページ15に含まれる内容の要旨
LIMITED LIFETIME WARRANTY REMOTE STARTERS: As the manufacturer, 4366859 Canada Inc. (“Autostart”) warrants to the original consumer purchaser only (nontransferable) that the remote starter module (control box) shall be free from defects in materials and workmanship for as long as the original consumer purchaser continuously owns the vehicle in which the remote starter was originally installed, as specified below: 1) For the first two years after the date of manufacture, as specified by t