ページ1に含まれる内容の要旨
CM4200 Alarm/Starter Control Module
This manual is for professional installers. Please read and understand this manual before you start to install.
If you have any questions, please do not hesitate to call the tech support (888)820-3690. ( 8 am to 5 pm Pacific Time)
I. Wiring Chart and Notes
1 Red 2 Gr/Wht 1: ( + ) 12v Constant 2: ( + ) Parking Light
Note 5: If the vehicle uses a
3 Red/Wht 4 White 3: ( + ) 12v Constant 4: ( + ) Accessory negative parking lig
ページ2に含まれる内容の要旨
2-2 Turbo mode. Off 2 Min 1Min 4 Min V V 2-3 Diesel timer. Wire 3~99sec (10sec Default) V V Note 12: Updating Controller Module 2-4 Trigger Start Off Single Pulse Double Pulse V V Look at the wiring chart of the module. If it is marked “V”, you have Version 12. If you have any other version, it will show the version 2-5 Cold Start with Thermistor Assembly Off On V V number. Please check www.compustar.com to find out if there are any new updates. If there is any, we r
ページ3に含まれる内容の要旨
Disarm Out[7], Horn Out[8], Dome Light[9], 3 POC #3 2nd IG1 V V 3-3 Dome Light Delay: This setting gives the control module the ability to ignore the door trigger for the set amount of time. Without this option set, if the dome light is still on when the vehicle is armed, Aux1 Out[10], Aux2 Out[11], Defrost[12] 4 POC #4 2nd ACC V V the remote will show the door open on the LCD display. On options 2 and 3, if the door trigger is still active after the set time, the car
ページ4に含まれる内容の要旨
1. Selecting the Option Menu Select the option menu that contains the option you would like to adjust. Be aware, the special option groups are not available when programming options with a remote. To select a menu, use the following button combinations: (The corresponding buttons for I, II, III, IV should be listed as I = Lock, 2 = Unlock, 3 = Trunk, 4 = Start) I+II for 2.5 sec. then I+II for 2.5 sec. Menu 1 I+II for 2.5 sec. then I+IV for 2.5 sec. Menu 2 I+IV for 2.5 sec. then I+II for
