ページ1に含まれる内容の要旨
PROFESSIONAL
SERIES
ca 5550SST
Owner’s Guide
Deluxe Vehicle Remote Start
System with 900Mhz 2 Way
Confirming LCD Remote Control
IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is
applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR
SAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information.
ca5550SST rev B. 2011 Audiovox Electronics Corporation. All rights reserved.
ページ2に含まれる内容の要旨
Table of Contents Using Your Remote Control ............................................................... 3 Using the Keyless Entry ................................................................... 3 Two Stage Door Unlock (optional) ................................................... 3 Activating Trunk Release (optional) ................................................ 3 Using the Progressive Car Finder Feature ...................................... 3 Using the Personal Protection Alarm ....
ページ3に含まれる内容の要旨
Using Your Remote Control Using the Keyless Entry The button is used to lock the vehicle's doors, the button is used to unlock the vehicle's doors. To lock or unlock the doors simply press and release the desired function button one time. For your convenience, the parking lights will flash once when the doors are unlocked and twice when the door are locked. NOTE: The system is equipped with a feature called Silent Choice. If enabled, the system requires a second press of the or button to ac
ページ4に含まれる内容の要旨
Valet Mode Valet Mode is used to disable the system from remote starting. To enter or exit valet mode simply follow the 4 steps outlined below: 1. Turn the vehicle’s ignition ON. 2. Push and hold the programming/valet button. 3. The LED will turn on solid when valet mode is active 4. Release the programming/valet button. Eliminating Lock / Unlock Notification Chirps System lock and unlock notification chirps can be toggled ON or OFF without entering the programming feature banks. 1. Turn the
ページ5に含まれる内容の要旨
Preheating or Precooling the Vehicle’s interior Before exiting the vehicle, set the temperature controls to the desired setting and operation. After the system starts the vehicle, the heater or air conditioner will activate and heat or cool the vehicle’s interior to your setting. User Programmable Run Time / Run Time Extension The system has the ability to allow the user to extend the time the vehicle will be running under control of the remote start. This will only extend the run time back
ページ6に含まれる内容の要旨
To begin the 2 / 3 hour start up timer mode: 1. Turn the vehicle’s ignition ON then OFF. 2. Press and hold the valet button. 3. Press the button 4 times, the system will; a. When set for 3 Hour (default) - chirp 2 times and flash the parking lights 4 times. b. When set for 2 Hour - chirp 1 time and flash the parking lights 2 times. To exit the 2 / 3 hour start up timer mode: 1. Turn the vehicle’s Ignition ON. OR 1. Activate the remote vehicle start feature using the remote co
ページ7に含まれる内容の要旨
Remote Start Safety Features For safety and security reasons, the system will shutdown or prevent the remote vehicle starter from activating if any of the following occur: 1. The vehicle hood is open. 2. The brake pedal is pressed prior to turning the ignition key to the ON position. 3. The engine is over-revved (tach checking only). 4. Valet mode is active. ca5550SST rev B. 2011 Audiovox Electronics Corporation. All rights reserved. 7
ページ8に含まれる内容の要旨
Additional 2-Way LCD Remote Control Functions Check Vehicle Status Press and release 2 times then press within 3 seconds, the transmitter will respond with one melody sound and display the current status of the vehicle. Display Illumination Press and hold the button for 1 second. The display will illuminate for 5 seconds. Melody / Vibration Mode To have the remote control vibrate, play a melody tone or both each time it receives a response from the vehicle press and release then pr
ページ9に含まれる内容の要旨
2 Car Mode To control a second security system enter 2 car mode by pressing then press and together for 3 seconds. When the icon appears on the transmitter’s LCD screen it will control the second security system. Use the same method to exit 2 car mode and resume control of the original vehicle’s security system. NOTE: A second security system must be installed and the LCD transmitter must be learned to it before this feature will operate the additional system. Parking Meter Countdown The
ページ10に含まれる内容の要旨
LCD Remote Control ICON’s UNLOCK LOCK TRUNK RELEASE VALET MODE TRANSMITTING PANIC TIME DISPLAY ENGINE RUNNING BATTERY INDICATOR BATTERY SAVE MODE TIMER / TEMP TIME COUNT DOWN START MODES MELODY MODE VIBRATE/SILENT MODE 2 CAR MODE ALARM CLOCK 10 ca5550SST rev B. 2011 Audiovox Electronics Corporation. All rights reserved.
ページ11に含まれる内容の要旨
Transmitter Button Functions 1 Way Car Find / Lock Unlock Start N/A Operation Method Transmitter Panic Lock X Press and Release Unlock X Press and Release Trunk X Push and Hold (3 Sec) Car Finder X Press and Release Panic X Push and Hold (3 Sec) Press and Release (1 or 2 times depending Remote Start X on selectable option) Remote Start X Push and Hold (3 Sec) Shut Down Run Time X Press and Release 4 times. Extention Ignition ON/OFF, Press and Hold Valet 2 / 3 Hour Start X Button, Press
ページ12に含まれる内容の要旨
Replacing Remote Control Batteries 1 Way Remote Control The battery (model CR2032) inside each remote control should last approximately 1 year under normal use. When the batteries become weak you will notice the remote control range (the distance from the vehicle the remote control will work) deteriorate and the small LED on the remote control will dim. To replace the remote control batteries: 1. Remove 3 screws and disassemble the halves of the remote control. 2. Remove the old battery, obs
ページ13に含まれる内容の要旨
Code Systems, Inc. Limited Lifetime Warranty Code Systems Inc. (“CODE”) warrants to the ORIGINAL PURCHASER of this CODE vehicle security product (the “Product”), purchased from an authorized CODE dealer, that (except as provided below) should this Product under normal use and conditions, be proven defective in material or workmanship DURING THE LIFETIME OF THE VEHICLE IN WHICH IT WAS ORIGI- NALLY INSTALLED, such defect(s) will be repaired or replaced (at CODE’s option) without charge for parts d
ページ14に含まれる内容の要旨
Audiovox Electronics Corporation. Customer Service 1-800-421-3209 WWW.CODE-ALARM.COM FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including any interference that may cause undesired operation. Warning! Changes or modifications not expressly approved by the party responsible for
