ページ1に含まれる内容の要旨
INSTALLATION INSTRUCTIONS
30" (76.2 CM) FREESTANDING GAS RANGES
INSTRUCTIONS D’INSTALLATION DES CUISINIÈRES À GAZ
AUTOPORTANTES DE 30" (76,2 CM)
Table of Contents/Table des matières
RANGE SAFETY .............................................................................2 SÉCURITÉ DE LA CUISINIÈRE...................................................20
INSTALLATION REQUIREMENTS ................................................3 EXIGENCES D’INSTALLATION..............................................
ページ2に含まれる内容の要旨
RANGE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.” These words mean: You can be killed or seriously injured if you don't immediately DANG
ページ3に含まれる内容の要旨
In the State of Massachusetts, the following installation instructions apply: ■ Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the State of Massachusetts. ■ If using a ball valve, it shall be a T-handle type. ■ A flexible gas connector, when used, must not exceed 3 feet. WARNING Tip Over Hazard A child or adult can tip the range and be killed. Install anti-tip bracket to floor or wall per installation instruct
ページ4に含まれる内容の要旨
Location Requirements IMPORTANT: Observe all governing codes and ordinances. Do not obstruct flow of combustion and ventilation air. Product Dimensions ■ It is the installer’s responsibility to comply with installation clearances specified on the model/serial rating plate. The model/serial rating plate is located on the oven frame behind the top right side of the oven door. ■ Recessed installations must provide complete enclosure of the sides and rear of the range. ■ All openings in the wal
ページ5に含まれる内容の要旨
Cabinet Dimensions Electrical Requirements Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and WARNING 36" (91.4 cm) countertop height. IMPORTANT: If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface. Electrical Shock Hazard D B Plug into a grounded 3 prong outlet. C Do not remove grou
ページ6に含まれる内容の要旨
Gas Supply Requirements Flexible metal appliance connector: WARNING ■ If local codes permit, a new CSA design-certified, 4 to 5 ft (122 to 152.4 cm) long, ½" (1.3 cm) or ¾" (1.9 cm) I.D., flexible metal appliance connector may be used for connecting range to the gas supply line. ■ A ½" (1.3 cm) male pipe thread is needed for connection Explosion Hazard to the female pipe threads of the inlet to the appliance Use a new CSA International approved gas supply line. pressure regulator. ■ Do not
ページ7に含まれる内容の要旨
Burner Input Requirements Gas Supply Pressure Testing Input ratings shown on the model/serial rating plate are for Gas supply pressure for testing regulator must be at least elevations up to 2,000 ft (609.6 m). 1" water column pressure above the manifold pressure shown on the model/serial rating plate. For elevations above 2,000 ft (609.6 m), ratings are reduced at a rate of 4% for each 1,000 ft (304.8 m) above sea level (not Line pressure testing above ½ psi gauge (14" WCP) applicable for Ca
ページ8に含まれる内容の要旨
Wall Mounting Install Anti-Tip Bracket WARNING 5. Using the Phillips screwdriver, mount anti-tip bracket to the wall or floor with the two #12 x 1⁵⁄₈" screws provided. 6. Move range close enough to opening to allow for final gas Tip Over Hazard and electrical connections. Remove shipping base, A child or adult can tip the range and be killed. cardboard or hardboard from under range. 7. Move range into its final location, making sure rear leveling Install anti-tip bracket to floor or wall per
ページ9に含まれる内容の要旨
2. Using a pipe wrench to tighten, connect the gas supply to the Complete Connection range. 1. Check that the gas pressure regulator shutoff valve is in the “on” position. B C D A F A E A. Gas pressure regulator shutoff valve shown in the “on” position J 2. Open the manual shutoff valve in the gas supply line. The I H valve is open when the handle is parallel to the gas pipe. G A. Gas pressure regulator F. Manual gas shutoff valve A B. 90° elbow (must have G. ½" or ¾" gas pipe B ½" male pipe
ページ10に含まれる内容の要旨
5. Slide range back so the rear range foot is inserted into the slot of the anti-tip bracket. Verify Anti-Tip Bracket Is Installed and IMPORTANT: If the back of the range is more than 2" (5.1 cm) from Engaged the mounting wall, the rear range foot may not engage the bracket. On Ranges with a Storage Drawer: Slide the range forward and determine if there is an obstruction 1. Remove the storage drawer. See “Storage Drawer” section. between the range and the mounting wall. Changes to the gas
ページ11に含まれる内容の要旨
Electronic Ignition System 1. Light 1 burner and turn to lowest setting. Initial lighting and gas flame adjustments Cooktop and oven burners use electronic igniters in place of 2. Remove the control knob. standing pilots. When the cooktop control knob is turned to the Hold the knob stem with a pair of pliers. Use a small flat- “LITE” position, the system creates a spark to light the burner. blade screwdriver to turn the screw located in the center of This sparking continues, as long as the c
ページ12に含まれる内容の要旨
3. If the oven bake flame needs to be adjusted, locate the air shutter near the center rear of the range. Loosen the locking Warming Drawer or Premium Storage screw and rotate the air shutter until the proper flame Drawer appears. Tighten locking screw. (on some models) Remove all items from inside the warming drawer or premium storage drawer, and allow the range to cool completely before A attempting to remove the drawer. B To Remove: 1. Open the warming drawer or premium storage drawer t
ページ13に含まれる内容の要旨
4. Lift the oven door while holding both sides. Continue to push the oven door closed and pull it away from Storage Drawer the oven door frame. (on some models) The storage drawer can be removed. Before removing, make sure drawer is cool and empty. To Remove: 1. Pull the storage drawer straight back to the drawer stop. To Replace: 1. Insert both hanger arms into the door. A A. Drawer stop notch 2. Lift up the front of the drawer and pull the drawer out. To Replace: 1. Lift up the front of the
ページ14に含まれる内容の要旨
GAS CONVERSIONS Gas conversions from Natural gas to LP gas or from LP gas to Natural gas must be done by a qualified installer. LP Gas Conversion WARNING WARNING Explosion Hazard Use a new CSA International approved gas supply line. Tip Over Hazard Install a shut-off valve. A child or adult can tip the range and be killed. Securely tighten all gas connections. Install anti-tip bracket to floor or wall per installation If connected to LP, have a qualified person make sure instructions. gas pre
ページ15に含まれる内容の要旨
LP NG LP NG 3. Remove plastic cover from gas pressure regulator cap. 3. Apply masking tape to the end of a 7 mm (⁹⁄₃₂") nut driver to help hold the gas orifice spud in the nut driver while changing 4. Turn gas pressure regulator cap counterclockwise with a it. Press nut driver down onto the gas orifice spud and ⁵⁄₈" combination wrench to remove. remove by turning it counterclockwise and lifting out. Set gas NOTE: Do not remove the spring beneath the cap. orifice spud aside. Side view befor
ページ16に含まれる内容の要旨
x.xx 8. Position the back of the bake burner over the oven orifice, To Convert Oven Bake Burner (Natural Gas to LP Gas) and slide the tab on front of the bake burner into the front of the oven. 1. Remove the oven racks. 9. Reattach the bake burner with 1 screw. 2. Remove 2 screws at the rear of the oven bottom. 10. Position the front of the oven bottom panel toward the front 3. Lift the rear of the oven bottom up and back until the front of frame and lower the rear of the oven bottom panel
ページ17に含まれる内容の要旨
LP LP NG NG Complete Installation (Natural Gas to LP Gas) To Convert Gas Pressure Regulator (LP Gas to Natural Gas) 1. Refer to the “Make Gas Connection” section for properly connecting the range to the gas supply. 1. Remove storage drawer or warming drawer. See the “Storage Drawer” or “Warming Drawer or Premium Storage Drawer” 2. Refer to the “Electronic Ignition System” section for proper section. burner ignition, operation, and burner flame adjustments. 2. Locate gas pressure regulator a
ページ18に含まれる内容の要旨
3. Apply masking tape to the end of a 7 mm (⁹⁄₃₂") nut driver to help hold the gas orifice spud in the nut driver while changing To Convert Oven Bake Burner (LP Gas to Natural Gas) it. Press nut driver down onto the gas orifice spud and remove by turning it counterclockwise and lifting out. Set gas 1. Remove the oven racks. orifice spud aside. 2. Remove 2 screws at the rear of the oven bottom. 3. Lift the rear of the oven bottom up and back until the front of C the panel is away from the f
ページ19に含まれる内容の要旨
x.xx 8. Position the back of the bake burner over the oven orifice, 4. Replace the “100” hood with a “155” hood. Install the Natural and slide the tab on front of the bake burner into the front of gas broiler burner orifice hood, turning it clockwise until snug. the oven. IMPORTANT: Do not overtighten. 9. Reattach the bake burner with 1 screw. A 10. Position the front of the oven bottom panel toward the front frame and lower the rear of the oven bottom panel into the oven. 11. Reattach the o
ページ20に含まれる内容の要旨
SÉCURITÉ DE LA CUISINIÈRE Votre sécurité et celle des autres est très importante. Nous donnons de nombreux messages de sécurité importants dans ce manuel et sur votre appareil ménager. Assurez-vous de toujours lire tous les messages de sécurité et de vous y conformer. Voici le symbole d’alerte de sécurité. Ce symbole d’alerte de sécurité vous signale les dangers potentiels de décès et de blessures graves à vous et à d’autres. Tous les messages de sécurité suivront le symbole d’alerte de sécur