ページ1に含まれる内容の要旨
Contents
1. INSTRUCTIONS FOR SAFE AND PROPER USE_______________ 42
2. INSTALLATION OF THE APPLIANCE________________________ 44
3. ADAPTATION TO DIFFERENT TYPES OF GAS _______________ 47
4. FINAL OPERATIONS_____________________________________ 49
5. DESCRIPTION OF CONTROLS ____________________________ 51
6. USE OF THE COOKING HOB ______________________________ 58
7. USE OF THE OVENS_____________________________________ 59
8. ACCESSORIES _________________________________________ 61
9.
ページ2に含まれる内容の要旨
Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKER. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE COOKER. ALSO KEEP THE SERIES OF NOZZLES SUPPLIED. INSTALLATION MUST BE CARRIED OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTI
ページ3に含まれる内容の要旨
Introduction DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NOT TO TOUCH THE HEATING ELEMENTS INSIDE THE OVEN. DO NOT INSTALL THIS APPLIANCE ON A RAISED PLATFORM DO NOT PUT PANS WITHOUT PERFECTLY SMOOTH AND FLAT BOTTOMS ON THE COOKING HOB GRIDS. DO NOT USE CONTAINERS OR BROILERS THAT EXTEND BEYOND THE OUTER PERIMETER OF THE HOB. THE APPLIANCE IS DESIGNED FOR USE BY ADULTS. DO NOT ALLOW CHILDREN TO GO NEAR OR PLAY WITH IT. THIS APPLIANCE IS MARKED
ページ4に含まれる内容の要旨
Instructions for the installer 2. INSTALLATION OF THE APPLIANCE It is the law that all gas appliances are installed by competent persons. Corgi gas installers are approved to work to safe and satisfactory standards. All gas installation, servicing and repair work must be in accordance with the gas safety regulations 1984 (installation and use) as amended 1990. It can be placed against walls higher than the hob, at a distance of at least 50 mm from the side of the appliance, as
ページ5に含まれる内容の要旨
Instructions for the installer The connection to the mains shall be done conforming to the regulations in force. Check that the power line is adequately grounded. Do not use reducers, adapters or shunts. On the power line, install an omnipolar cut- off device with contact cut-off distance greater than or equal to 3 mm, located in an easily accessible position near the unit. The connection terminals are located at the rear of the appliance. For electrical connections see follo
ページ6に含まれる内容の要旨
Instructions for the installer 2.3 Ventilation requirements The room containing the appliance should have an air supply in accordance with B.S. 5440 part 2 1989. 1. All rooms require an opening window or equivalent, and some rooms will require a permanent vent as well. 3 2 2. For room volumes up to 5 m an air vent of 100 cm is required. 3. If the room has a door that opens directly to the outside, and the room 3 exceeds 1 m no air vent is required. 3 3 2 4. For room volumes be
ページ7に含まれる内容の要旨
Instructions for the installer 3. ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, switch off the power supply to the appliance. The cooking hob of the cooker is preset for G20 natural gas at a pressure of 20 mbar. In the case of functioning with other types of gas the burner nozzles must be changed and the minimum flame adjusted on the gas taps. Replace the burner nozzles as indicated in the table of the gas to be used. 3.1 Ch
ページ8に含まれる内容の要旨
Instructions for the installer 3.2 Burner and nozzle characteristics table Rated Burner heating LPG – G30/G31 28/37 mbar capacity (drawing ref. X238) (kW) Nozzle By-pass Reduced Flowrate Flowrate diameter Mm flowrate g/h G30 g/h G31 1/100 mm 1/100 (W) Auxiliary 1.05 50 30 360 76 75 Semi rapid 1.8 65 33 450 131 129 Rapid 3.0 85 45 750 218 215 Fish Burner 1.9 68 45 800 138 136 Triple crown 3.3 91 68 1600 218 215 Rated Burner heating NATURAL GAS – G20
ページ9に含まれる内容の要旨
Instructions for the installer 4. FINAL OPERATIONS After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the grids. Following adjustment to a gas other than the preset one, replace the gas adjustment label fixed to the appliance with the one corresponding to the new gas. This label is in the packet together with the nozzles. 4.1 Adjustment of minimum for natural gas Light the burner and turn it to the minimum position . Extract the
ページ10に含まれる内容の要旨
Instructions for the installer 4.3 Mounting the rear top upstand • Position the upstand above the top, taking care to align holes A with holes B. • Secure the upstand to the top by tightening screws C. 50
ページ11に含まれる内容の要旨
Instructions for the user 5. DESCRIPTION OF CONTROLS 5.1 Front control panel All the cooker controls and commands are on the front panel. The user has only to press the central key for 1 - 2 seconds to enable use of the oven on first use or after a power blackout. DESCRIZIONE DEI SIMBOLI FRONT LEFT BURNER BACK LEFT BURNER FRONT CENTRAL BACK CENTRAL BURNER BURNER FRONT RIGHT BURNER BACK RIGHT BURNER BARBECUE ELEMENT MAIN OVEN AUXILIARY OVEN THE
ページ12に含まれる内容の要旨
Instructions for the user FUNCTION SWITCH KNOB Turn the knob to select from the following functions: NO FUNCTION SET GRILL ELEMENT + VENTILATION UPPER AND LOWER HEATING LOWER HEATING ELEMENT + ELEMENT VENTILATION UPPER AND LOWER HEATING LOWER HEATING ELEMENT + ELEMENT + VENTILATION VENTILATED HEATING ELEMENT GRILL ELEMENT VENTILATED HEATING ELEMENT + VENTILATION DEFROSTING COOKING HOB BURNER COMMAND KNOB The flame is lit by pressing the knob
ページ13に含まれる内容の要旨
Instructions for the user AUXILIARY OVEN VARIABLE GRILL KNOB Position the auxiliary oven thermostat knob on the symbol or . Turn the variable grill knob clockwise to the desired position. When the signal light comes on the grill is engaged. AUXILIARY OVEN THERMOSTAT KNOB Selection of cooking temperature is carried out by turning the knob clockwise to the required temperature, between 50° and 220°C. The tell-tale light comes on to indicate that the oven is warming up. When
ページ14に含まれる内容の要旨
Instructions for the user 5.2 Electronic Analogue Clock LIST OF FUNCTIONS MINUTE-MINDER BUTTON AUTOMATIC SWITCH-OFF TIMING BUTTON TIME SETTING AND RESET VALUE DECREASE BUTTON VALUE INCREASE BUTTON 5.2.1 Setting the time When the oven is used for the first time, or after a power blackout, the display flashes on and off at regular intervals. Press the key for 1/2 seconds to stop the display flashing and start setting of the current time.
ページ15に含まれる内容の要旨
Instructions for the user 5.2.2 Minute-minder This function does not stop cooking but just triggers the beeps. - When the key is pressed the display illuminates, appearing as shown in figure 1; - Press the or keys within 6/7 seconds to set the minute-minder. Whenever a key is pressed, 1 outside segment, representing 1 1 cooking minute will light up (figure 2 shows 10 cooking minutes). - The countdown will start 6/7 seconds after the last key is pressed; at the end of it
ページ16に含まれる内容の要旨
Instructions for the user 5.2.3 Programming nd Cooking duration time: the 2 button can be used to set the cooking time. Before setting it, turn the thermostat to the cooking temperature of choice and the function selector knob to any setting. To set the cooking time, proceed as follows: - Press the key for 1/2 seconds; the pointer will move to position 12 (Fig. 1). - Use the and keys to set the cooking time; whenever the key is pressed, 1 minute will be added to the coo
ページ17に含まれる内容の要旨
Instructions for the user Cooking start: as well as setting a cooking duration time, the user can also set the cooking start time (up to 12 hours after the current time). To set the cooking start/end time, proceed as follows. - Set the cooking duration time as described in the previous point. - Within 6/7 seconds after the last time the or keys are pressed, press the key to set the cooking start time. The display will show the current time with the inside segments indicating
ページ18に含まれる内容の要旨
Instructions for the user 6. USE OF THE COOKING HOB 6.1 Lighting of the cooking hob burners Before lighting the cooking hob burners check that the flame cap crowns are properly positioned with their appropriate burner caps: niche A must be centred with pin B. Grid C should be used with Chinese woks. Each knob corresponds to the burner indicated. The appliance is equipped with an electronic lighting device. Just press and turn the knob anticlockwise to the maxi
ページ19に含まれる内容の要旨
Instructions for the user 6.3 Diameter of containers BURNERS Ø min. e max. (in cm) 1 Auxiliary 12-14 2 Semi rapid 16-20 3 Rapid 18-24 4 Ultra rapid 20-24 5 Fish Burner Special oval- shaped vessels 6.4 Using the griddle plate The griddle plate is coated with a thin film of non-stick material (Teflon). This film is very delicate and could be damaged or scratched by any metal cooking tool. Use only wooden or heat resistant plastic tools. 7. USE OF TH
ページ20に含まれる内容の要旨
Instructions for the user 7.2 Oven Light It comes on when the function switch knob is turned to any position. 7.3 Cooling fan The appliance is equipped with a cooling system which comes into operation regardless of the cooking function selected, including the automatic cooking function. The fan, installed in the rear of the appliance, drives the air across the top of the oven and through the vent slits above the door. The noise caused by the air flow will continue even after the
