ページ1に含まれる内容の要旨
JENN-AIR
Use and Care Manual
• Solid Element and Radiant
Ranges with Convection
Models SCE4320 & SCE4340
MODEL SCE4340
ページ2に含まれる内容の要旨
About Your Jenn-Air Congratulations on your choice of a Jenn-Air range. Model SCE4320 - Your range has 4 solid elements with thermalimiters. The elements in the rear, designated by a bullseye, are Ultra Power solid elements. The elements in the front, desig- nated by a dot, are standard elements. Model SCE4340 - Your range has 4 radiant elements with thermalimiters. Your Jenn-Air self-cleaning oven combines the best of two cooking methods, convection and radiant bake (conventional) baking or roa
ページ3に含まれる内容の要旨
SAFETY PRECAUTIONS Read before operating your range All appliances -- regardless of the manufacturer -- have the potential through improper or careless use to create safety prob- lems. Therefore the following safety precautions should be observed: 1. Be sure your appliance is properly installed and grounded by a qualified technician. 2. Never use your appliance for warming or heating the room. 3. Children should not be left alone or unattended in area where appliance is in use. They should never
ページ4に含まれる内容の要旨
11. Glazed cookware -- only certain types of glass, glass-ceramic, ceramic, earthenware, or other glazed cookpots are suitable for range top surface without breaking due to the sudden change in temperature. Use only such cookware as you know have been approved for this purpose. 12. Cookware handles should be turned inward and not extend over adjacent surface heating elements to avoid burns, ignition of flammable materials and spillage due to unintentional contact with the cookware. 13. CAUTION -
ページ5に含まれる内容の要旨
23. Listen for fan. A fan noise should be heard during the cleaning cycle. If not, call a serviceman before self-cleaning again. 24. Do not cook on glass-ceramic cooking surface if the cooktop is broken. Cleaning solutions and spillovers may penetrate the brokencooktop and create a shock hazard. Contact an authorized Jenn-Air Service Contractor. 25. Clean glass-ceramic cooktops with caution. Ifwet sponge or cloth is used to wipe spills on a hot cooking area, be careful to avoid steam burns. Some
ページ6に含まれる内容の要旨
Cooktop & Oven Controls OvenVent ClockControls& mer OvenLight Switch " Oven Surface _ Temperature Knob Ind Light Indicator Light Surface Controls Indicator Oven Light Selector Knob Indicator and Lock DoorLock IndicatorLights Lever Surface Controls • Use to provide variable heat to cooktop heating elements. (See pg.9) Oven Controls • Use to set oven for baking, broiling, convection baking, and self-clean. (See pg. 15) Clock Controls and Minute Timer • Features time of day, minute timer, and oven
ページ7に含まれる内容の要旨
Surface Controls The variable heat controls for the cooktop provide flexibility in heat setting selection. To Set Controls • Sincethe controls area push-turntype, they must bepushed down beforeturning. To set (from the OFF position), push down on control knob and turn in either direction to desired heat setting. • When control is in any position, other than OFF, it may be turned in any direction without pushing down. • A red indicator light will glow when a surface heating element is ON. There a
ページ8に含まれる内容の要旨
Cookware To achieve optimum cooking performance, use heavy gauge, flat, smooth bottom cookpots that conform to the diameter of the solid or radiant element (no more than one inch overhang). Propercookpots will minimize cooking times, use less electricity, cook food more evenly and require less water or oil. Cookpots with thin, uneven bottoms do not adequately conduct heat from the solid or radiant element to the food in the cookpots which results in hot spots, burned or underdone food. Using bad
ページ9に含まれる内容の要旨
Improper Cookware • Do not use cookware that extends more than 1 inch beyond the edge of the element. • Do not use a small cookpot on a large element. Not only can this cause the elementto require moreenergy andtime, but it canalso resultinspillovers burning onto the eJementwhich cause extra effort Jncleaning. • Do not use nonflat specialty items that are oversized, uneven or do not meet propercookware specifications such as round bottom woks with rings, griddles, rippled bottom canners, lobster
ページ10に含まれる内容の要旨
Solid Element Cooktop (Model SCE4320) IMPORTANT BEFORE USINGTHE COOKTOP FORTHE FIRSTTIME, HEAT THE ELEMENTS WITHOUT A PANFOR 3TO 5 MINUTES ON THE HISETTING. The elementsare shipped withacoating (lacquer) whichprotects them againstcorrosion. Heating the elements allows the coating to be hardened and burned into the elements. During the curing process, a non-toxic smoke will be created. Turn on the overhead hood fan ifthe smoke is objectionable. Ifthe elements are not cured, the coating can stick
ページ11に含まれる内容の要旨
Radiant Element Cooktop (Model SCE4340) Cooking Procedures • BEFORE FIRST USE. CLEAN COOKTOP (See pg.39) • For best results, always use recommended cookware. • Differentcookpots and different amounts of food beingprepared will influence the control settings needed for best results. For fastest cooking, start withthe surface control on Hi for one minute; then turn the control to the lower desired setting. Covering pans,whenever possible, speeds cooking and is more energy efficient. • The glass ce
ページ12に含まれる内容の要旨
Avoid Damage to Cooktop • Do not allow plastic objects, sugar, or foods with high sugar content to meltonto the hot cooktop. Melted materials can cause permanent damage to the cooktop. If you accidentally melt anything onto the cooktop, remove it immediately while the cooktop is still hot. Carefully, use a single edge razor blade held with a pot holder to remove melted on material. • Do not use aluminum foil or foil-type containers under any circumstances. Aluminum foil will damage the cooktop i
ページ13に含まれる内容の要旨
Oven Operation Oven Controls (pictured on p. 8 ) Oven Light Switch * The oven light automatically comes on whenever the oven door is opened. When the door is closed, the oven light may be turned on by pushing the switch at the top. To turn oven light off, push on the bottom of the switch. Light cannot be turned on during the self-cleaning process. Clean Indicator Light • Indicateswhen all controls have beenproperly set for the self-cleaning process. Light will remain on during the entire cleanin
ページ14に含まれる内容の要旨
Clock Controls INDICATOR WORDS DISPLAY WINDOW / \ 12 HOUR MINUTE AND SECOND TIME OF DAY CLOCK TIMER Clock Setting IMPORTANT: The clock is a 12hour clock. When oven is first supplied power or power is interrupted, the display will show "00:00". To set time of day on clock: 1. Turn SET dialcounterclockwise until the word TIME appears inthe Display Window. Then, turn the SET dial in eitherdirection until the correct time appears in window. 2. Push ENTER button. To change time of day set on clock: R
ページ15に含まれる内容の要旨
Minute Timer IMPORTANT: This interval timer can be used to remind you when a period, up to 99 minutesand 00seconds, expires, ltcan beused independentlyof anyother oven activity and can be set while another oven function is operating. The timerdoes not control the oven. To set MINUTE TIMER: 1. Turn SET dialclockwise until desired number of minutes and seconds appear inthe Display Window. EXAMPLE: Turn the dial to 5 for 5 seconds or to 5:00 for 5 minutes. .n n DISPLAY .uu 5SECONDS 5MINUTES IMPORTA
ページ16に含まれる内容の要旨
Clock-Controlled Baking or Roasting To set oven to start immediately and shut off automatically: 1. Turn SELECTOR knob to TIME BAKE or TIME CONVECT. 2. Turn TEMPERATURE knob to desired temperature. 3. Hold in STOP TIME button until the indicator words STOP TIME appear in Display Window. 4. Turn SET dial to time you want food to stop cooking. EXAMPLE: If time of day is one o'clock and the roast needs to cook for 3 hours, the stop time would be four o'clock. DISPLAY TIME OF DAY STOP TIME 5. Push E
ページ17に含まれる内容の要旨
To check START TIME before cooking begins: Hold inSTARTTIME button until the words START TIME appear in the Display Window. The start time will be displayed briefly, then Display will return to time of day. To change START TIME before cooking begins: 1. Hold in START TIME button until the words START TIME appear in the Display Window. 2. Turn SET dial to desired time. 3. Push ENTER button twice to enter new start time and stop time previously programmed. To check STOP TIME: Hold in STOP TIME but
ページ18に含まれる内容の要旨
Oven Operation To Bake or Roast 1. Locate oven racks on proper rack positions. 2. Turn TEMPERATURE knob to desired temperature. 3. Turn SELECTOR knob to BAKE or CONVECT setting. When the OVEN INDICATOR LIGHT cycles off, the oven is preheated to the selected temperature. Place the food in the oven. The OVEN INDICATOR LIGHT will cycle on and off throughout the baking process. Preheatonlywhen necessary. Refer to baking and roasting sections as to when preheating is recommended. 4. After baking turn
ページ19に含まれる内容の要旨
Baking General Baking Recommendations • When cooking foods for the first time in your new oven, use recipe cooking times and temperatures as a guide. • Use tested recipes from reliable sources. • Preheat the oven only when necessary. For baked foods that rise and for richer browning, a preheated oven is better. Casseroles can be started ina cold oven. Preheatingtakes from5 to 9minutes; place food inoven after OVEN INDICATOR LIGHT cycles off. • Arrange oven racks before turning on oven. Follow su
ページ20に含まれる内容の要旨
Convection Baking Recommendations • As a general rule, when using recipes or prepared mixes developed for a radiant bake oven, set the oven temperature 25°F lower than the recipe recommended temperature. Times will be similar to or a few minutes less than recipe recom- mended times. The chart on page 23 compares times and temperatures of many baked foods. Use this as a reference. • For better browning, large pans such as cookie sheets or rectangular baking pans should be placed lengthwise, front
