ページ1に含まれる内容の要旨
F30WV SERIES
ECONOMY RANGE HOOD
HOODS
INSTALLATION INSTRUCTIONS
F24WR & F30WR
SERIES HOODS
READ AND SAVE THESE INSTRUCTIONS
! !
INTENDED FOR DOMESTIC COOKING ONLY
WARNING WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
TO REDUCE THE RISK OF INJURY TO PERSONS IN THE
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE
1. Use this unit only in the manner intended by the manufac-
FOLLOWING:*
turer. If you have questions, contact the manufacturer at
ページ2に含まれる内容の要旨
TOOLS AND FIG. A MATERIALS REQUIRED ❏ Drill, electric or ratchet drive WALL CAP ❏ 1/8" Drill bit for drilling pilot holes ❏ 1-1/4" wood bit for drilling electrical wiring access hole ❏ One straight blade and one phillips head screwdriver FIG. B ❏ Pliers WALL CAP ❏ Pencil and ruler and/or tape measure ❏ Saber saw or keyhole saw for cutting 1" x 2" wood strips to 3-1/4" X 10" DUCT length and cutting wall or cabinet openings ❏ Caulking, metal snips, duct tape, duct (with elbows and tran- sition, if
ページ3に含まれる内容の要旨
FIG. 1 PREPARE THE HOOD WIRING BOX COVER 1. Unpack hood and check contents. You should receive: DUCTFREE 1 -Aluminum Filter (F30WV hood only) FILTER KEYHOLE 1 -3-1/4" x 10" Damper/Duct Connector (mounted (F24WR & SLOTS F30WR inside of hood for shipping only) (F30WV HOOD hood only) ) ONLY 1 - Ductree filter (F24WR and F30WR hoods only) 2. Remove wiring box cover. Under cover find: ALUMINUM 1 -Plastic Bag containing loose mounting hard- FILTER (F30WV ware HOOD ONLY) 3. Remove top or rear electric
ページ4に含まれる内容の要旨
FIG. 5A INSTALL THE DUCTWORK (This section for F30WV hoods only. F24WR and F30WR hoods skip this section and go on to “Install Range Hood”.) NOTE FILLER These instructions will follow plans made on Page 2. Start at STRIP the exterior and run ductwork back to the range hood. For best possible performance, use the shortest possible duct run and a minimum number of elbows. Do not vent a range hood into an attic space. A buildup of grease in the attic could become a fire hazard. Use only metal duct
ページ5に含まれる内容の要旨
FIG. 9 USE AND CARE SWITCHES CONNECTOR The fan and light are each controlled by a rocker switch. The light switch has two positions, “ON” and “OFF. The fan switch ” has three positions - “HIGH, “LOW” and “OFF ” .” ( “OFF” is the middle position.) FIG. 10 FILTERS F30WV Hood Only: Remove aluminum filter by turning filter retainer to one side. (FIG. 13) Filter should be washed once a month in a hot deter- gent solution. Aluminum filters are dishwasher safe. When in- stalling filter, make sure that
ページ6に含まれる内容の要旨
FIG. 14 SCREWS SERVICE PARTS F30WV SERIES 3-1/4" X 10" DUCTED HOOD KEY NO. DESCRIPTION 21 1 Outlet Box Cover 2 #8 x 3/8 Sheet Metal Screw* 3 Bulb Holder with Wires 4 Light Lens 5 Screw/Nut Kit (Includes 2 - #10-16 x .500 screws and 2 - #10-16 sheet metal nuts) 6 Fan Blade 7 #6-32 Locking Nuts* (2 Required) 8 Motor Mounting Bracket 9 Motor Assembly (Includes Key Nos. 6, 7, & 8) 10 Aluminum Filter 11 Filter Retainer 12 #8B x 1/4 Hex Head Sheet Metal Screws* (2 Required) 13 Dampe
ページ7に含まれる内容の要旨
SERVICE PARTS F30WR & F24WR SERIES NON-DUCTED HOOD KEY NO. DESCRIPTION 1 Outlet Box Cover 2 #8 x 3/8 Sheet Metal Screw* 3 Bulb Holder with Wires 4 Light Lens 5 Screw/Nut Kit (Includes 2 - #10-16 x .500 screws and 2 - #10-16 sheet metal nuts) 6 Fan Blade 7 #6-32 Locking Nuts* (2 Required) 8 Motor Mounting Bracket 9 Motor Assembly (Includes Key Nos. 6, 7, & 8) 10 Ductfree Filter 11 Filter Retainer 12 Nameplate - Black 17 Nameplate - White Nameplate - Bisque 13 2-Speed Motor Switc
ページ8に含まれる内容の要旨
Major Appliance Warranty Information Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used, and maintained in accordance with the provided instructions. Exclusions This warranty does not cover the following: 1. Products with original serial numbers that have been rem
