ページ1に含まれる内容の要旨
DYNAMO
AM/FM BAND RADIO
94670
ASSEMBLY & OPERATING INSTRUCTIONS
Due to continuing improvement, actual product may differ slightly from the product described herein.
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web Site at www.harborfreight.com
©
®
Copyright 2006 by Harbor Freight Tools . All rights reserved. No portion of this manual or
any artwork contained herein may be reproduced in any shape or form without the
express written consent of Harbor Freight Tools.
For technical ques
ページ2に含まれる内容の要旨
THANK YOU for choosing a HARBOR FREIGHT TOOLS product. For future reference, please complete the owner’s record below: Model______________ Serial No.____________ Purchase Date_______________ SAVE THE RECEIPT, WARRANTY AND THESE INSTRUCTIONS. It is important that you read the entire manual to become familiar with the unit BEFORE you begin assembly. Technical Specifications Batteries: Built-in rechargeable Ni-MH Back up powered by (3) “AA” (not included) Overall Dimensions: 7-3/4” L X 2-1/4” W
ページ3に含まれる内容の要旨
ELECTRICAL SAFETY 3. Grounded products must be plugged into an outlet properly installed and grounded in accordance with all codes and ordinances. Never remove the grounding prong or modify the plug in any way. Do not use any adapter plugs. Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded. If a grounded product should electrically malfunction or break down, grounding provides a low resistance path to carry electricity away from the user. 4.
ページ4に含まれる内容の要旨
14. When servicing the Radio, use only identical replacement parts. Follow instructions in the “Inspection, Maintenance, And Cleaning” section of this manual. Use of unauthorized parts or failure to follow maintenance instructions may create a risk of electric shock or injury. GROUNDING WARNING! Improperly connecting the grounding wire can result in the risk of electric shock. Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded. Do not modify t
ページ5に含まれる内容の要旨
2. Double insulated tools may be used in either of the 120 volt outlets shown in the following illustration. (See Figure B.) Figure B EXTENSION CORDS 1. Grounded appliances require a three wire extension cord. Double Insulated products can use either a two or three wire extension cord. 2. As the distance from the supply outlet increases, you must use a heavier gauge extension cord. Using extension cords with inadequately sized wire causes a serious drop in voltage, resulting in loss of power
ページ6に含まれる内容の要旨
Figure C Figure C SYMBOLOGY 6. Do not use the Radio in places that are extremely hot, extremely cold, abnormally dusty or excessively humid. Avoid using or storing the Radio in parked cars, in direct sunlight, or near heat sources such as heaters. 7. People with pacemakers should consult their physician(s) before using this product. Electromagnetic fields in close proximity to a heart pacemaker could cause interference to or failure of the pacemaker. SKU 94670 For technical questions please cal
ページ7に含まれる内容の要旨
Note: Performance of this tool (if powered by line voltage) may vary depending on variations in local line voltage. Extension cord usage may also affect tool performance. Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. Unpacking When
ページ8に含まれる内容の要旨
Figure 1-Rear View Battery Cover (11) Figure 2-Front View Flashlight Flash Switch (21) Tuning Knob (15) Earphone Jack Power Indicator Lamp Low Power Indicator Battery Volume Knob/ Handle (2) Band Selector Power Switch Selector Knob Using the Flashlight/Lamp 1. Set the Flashlight Switch (21) to FLASH to turn on the Flashlight. 2. To turn on the Lamp, set the Flashlight Switch to TORCH. 3. If neither the Flashlight nor the Lamp are being used, set the Flashlight Switch to OFF. Setting the Band Sel
ページ9に含まれる内容の要旨
Figure 3 Earplug Jack Maintenance and Cleaning 1. Make certain that the On/Off Switch (16) is in the OFF position and that the Radio is unplugged from its power source before performing any inspection, maintenance or cleaning. 2. Use a soft cloth to clean the radio. Use only water or a mild detergent to clean the Radio housing. PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER
ページ10に含まれる内容の要旨
Parts and Assembly Diagram Note: Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts. SKU 94670 For technical questions please call 1-800-444-3353. Page 10
ページ11に含まれる内容の要旨
Wiring Diagram SKU 94670 For technical questions please call 1-800-444-3353. Page 11
