ページ1に含まれる内容の要旨
Installation Instructions
PMD1 PRO & PMD2 PRO:
Universal Projector Mounts
Thank you for purchasing an OmniMount product.
Warranty: Limited Lifetime on manufacturing defects and workmanship.
Specifications are subject to change without prior notice.
Every effort has been made to provide accurate and error-free assembly and installation.
OmniMount Systems disclaims liability for any difficulties arising from the interpretation
of information contained in these instructions. If Omni
ページ2に含まれる内容の要旨
Fig. 12 Models: PMD 1 & PMD 2 Important: Always secure projector plates by installing 3/8” screws (G) into holes on front edge of plates. Additional security can be provided by installing small pad- locks through security slots at the rear of the projector plates. (Fig. 12) Fig. 13 Attach cables to the projector. Turn projector ON, and make pitch and keystone adjustments as per the projector manufacturers instructions. For additional pitch/tilt, use the three adjustment knobs o
ページ3に含まれる内容の要旨
Part Projector Mounting Hard- Qty. Bag Place a large washer (1) over mounting screw, and then in- ware sert screw through grid at marked location. (Fig. 8) 1 Large Washer 8 (a) 2 Metal Spacer: 3/8” 4 (a) 3 Plastic Spacer: 1” 1 (b) Hardware Bags PMD-1 PMD-2 4 Screw: Screw: 4 (c) Fig. 8 5mm x 25mm 6mm x 25mm 5 Screw: Screw: 4 (c) 4mm x 25mm 5mm x 25mm 6 Screw: Screw: 4 (c) Lift the projector mounting plate and place a second large 3mm x 25mm 4mm x 25mm
ページ4に含まれる内容の要旨
Loosely thread top projector mounting plate (A) onto threaded Flush Ceiling Mount portion of pipe drop. Fig. 4 Proceed to step 3. Note: Plastic cover is not used for flush mount. Position top projector mounting plate into desired orientation (horizontal or vertical), and then tighten set screw (F). (Fig. 4) Wall Mount With the addition of the OmniMount PMD-WM wall mount (sold separately); the PMD can be mounted to a wall instead of the ceiling. This is particularly useful for
