ページ1に含まれる内容の要旨
O W N E R ' S M A N U A L
L E D P R O J E CT O R
T D P - F F 1 A
O t h e r s M a i n t enan c e
O p e r a t i o n s
P r e pa r at i o n s B e f o r e U s i ng
ページ2に含まれる内容の要旨
SAFETY PRECAUTIONS The lightning flash with arrowhead symbol, within an equilateral triangle, is in- tended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the app
ページ3に含まれる内容の要旨
- Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. RESPONSIBLE PARTY: TOSHIBA AMERICA INFORMATION SYSTEMS, INC. 9740 Irvine Blvd., Irvine, CA 92618-1697 U.S.A Phone: (949) 583-3000 WARNING: Changes or modifications made to this equipment, not expressly ap
ページ4に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS CAUTION: PLEASE READ AND OBSERVE ALL WARNINGS AND INSTRUC- TIONS GIVEN IN THIS OWNER’S MANUAL AND THOSE MARKED ON THE UNIT. RETAIN THIS BOOKLET FOR FUTURE REFER- ENCE. This set has been designed and manufactured to assure personal safety. Improper use can result in electric shock or fire hazard. The safeguards incorporated in this unit will protect you if you observe the following procedures for installation, use and servicing. This unit is fully transistorized
ページ5に含まれる内容の要旨
5. Heat 8. P ower-Cord Protection The product should be situated Power-supply cords should be away from heat sources such as routed so that they are not likely to radiators, heat registers, stoves, be walked on or pinched by items or other products (including ampli- placed upon or against them, pay- fiers) that produce heat. ing particular attention to cords at plugs, convenience receptacles, and the point where they exit from the product. 6. W ater and Moisture Do not use this product ne
ページ6に含まれる内容の要旨
(continued) IMPORTANT SAFETY INSTRUCTIONS 10. Lightning storms 12. Do not place the pr oduct vertically For added protection for this prod- uct during storm, or when it is left Do not use the product in the unattended and unused for long upright position to project the pic- periods of time, unplug it from the tures at the ceiling, or any other outlet. This will prevent damage to vertical positions. It may fall down the product due to lightning and and be dangerous. power-line surges.
ページ7に含まれる内容の要旨
e) If the product has been dropped 15. Accessories or damaged in any way. Do not place this product on an f) When the product exhibits a dis- unstable cart, stand, tripod, brack- tinct change in performance - this et, or table. The product may fall, indicates a need for service. causing serious injury to a child or adult, and serious damage to 17. If glass components, in- the product. A product and cart cluding lens, should break, combination should be moved with care. Quick stops, ex
ページ8に含まれる内容の要旨
(continued) IMPORTANT SAFETY INSTRUCTIONS 19. Replacement Parts 22. Do not use the pr oduct in a closed installation state. When replacement parts are re- Do not place the product in a box quired, be sure the service techni- or in any other closed installation cian has used replacement parts state. Otherwise it may overheat. specified by the manufacturer or This could result in a risk of fire. have the same characteristics as the original part. Unauthorized substitutions may result in
ページ9に含まれる内容の要旨
IMPORTANT PRECAUTIONS Save Original Packing Materials The original shipping carton and packing materials will come in handy if you ever have to ship your projector. For maximum protection, repack the set as it was originally packed at the factory. Moisture Condensation Never operate this unit immediately after moving it from a cold location to a warm location. When the unit is exposed to such a change in temperature, moisture may condense on the lens and the crucial internal parts. To prevent
ページ10に含まれる内容の要旨
EXEMPTION CLAUSES • Toshiba Corporation bears no responsibility in the case of damages arising from natural disaster such as earthquakes, lightning, etc., fire not liable to Toshiba Corporation, acts by third parties, other accidents, or use under abnormal conditions including erroneous or improper operation and other problems. • Toshiba Corporation bears no responsibility for incidental damages (lost profit, work inter- ruption, corruption or loss of the memory contents, etc.) arising from t
ページ11に含まれる内容の要旨
OTHER CAUTIONS AND INFORMATIONS Copyrights Showing or transmitting commercial imaging software or broadcast or cable-broad cast- ing programs with the purpose of other than the personal and private viewing, including modifying images using the freeze functions, or displaying with the varying aspect ratio of the images, could violate the direct or indirect copyrights of the imaging software or broadcast program, etc., if done without first consulting with the copyright holder. For this reason
ページ12に含まれる内容の要旨
BATTERIES The Battery Type For remote control: Be sure to use the lithium CR2025 battery. For Projector: Be sure to use TLPBP1 battery pack. Caution • Never shock the battery pack by dropping or throwing it. • Never throw the battery pack into a fire, as this could cause the battery pack to explode. • Never disassemble the battery pack, as this could cause leakage of alkaline solution or other electrolytic substance. • Never short-circuit the battery pack by either accidentally or intentionally
ページ13に含まれる内容の要旨
TABLE OF CONTENTS SAFETY PRECAUTIONS 2 IMPORTANT SAFETY INSTRUCTIONS 4 OTHER CAUTIONS AND INFORMATIONS 11 BATTERIES 12 Checking the package contents 15 Main unit components 16 Control keypad and functions 18 Remote control keypad and functions 19 Using the battery pack with the projector 20 Using the remote control 22 Changing the new lithium battery 22 Operating the remote control 22 Placement 23 Connection 24 Turning the power on and off 2
ページ14に含まれる内容の要旨
(continued) TABLE OF CONTENTS How to use the menus 35 Image adjustment menu 36 Display setting menu 37 Default setting menu 38 Displaying Information (Status display) 39 Lens and main unit cleaning 40 Lens cleaning 40 Main unit cleaning 40 Before calling service personnel 41 Indicators 42 Specifications 43 List of general specifications 43 List of supported signals (RGB signals) 44 List of supported signals (Y/PB/PR signals) 45
ページ15に含まれる内容の要旨
Checking the package contents Please make sure that the following items are included in the box, along with the main unit. If any item is missing, please contact the store immediately where you purchased the prod- uct. (1) (4) (7) (2) (5) (8) (3) (6) (9) (See note) (1) Remote control (6) Power cord (2) Battery pack (7) Adaptor (3) CD-ROM (8) Carrying bag (4) Owner’s Manual (9) Screen (5) RGB cable (1.5m) Note The shape and number of supplied power cords vary depending on the product dest
ページ16に含まれる内容の要旨
Main unit components 1 Top 1. Focus Ring Adjusts the focus 2. Control Panel Operates the projector 3. LED indicators Indicates projector status Lights when temperature TEMP too high Display battery condition BATT. POWER Lights when power on 2 3 5 Bottom 4. Battery Protect battery connector connector cover 4 5. Foot adjuster Adjust the vertical projection angle 6 11 Left 6. USB port Plug in USB memory 7. Headphone Outputs audio signals 8. Audio in Inputs audio signals 9. Video in Inputs vi
ページ17に含まれる内容の要旨
16 15 Right 14 12. DC input Connect the AC adaptor 13. Power switch Turn on/off the projector 14. Ventilator Air ventilator for cooling inside 15. Speaker Ouputs sounds from audio 12 in terminals 13 16. Battery pack Li-ion battery TLPBP1 17 Rear 17. Service port For service only 18. Battery For battery connection power in connector 18 Front 19. Lens Projects expanded image 20. Infrared remote Sense commands from sensor the remote control 19 20 17 Preparations
ページ18に含まれる内容の要旨
Control keypad and functions Normal mode: with COMPUTER or VIDEO INPUTS File view mode: with USB INPUT for file/directory selection. Slideshow mode: with USB INPUT. 3 1 2 1. Input/Menu Normal mode: • Change input source when pressing for less than 1 seconds. • Display menu system when pressing for longer than 1 seconds. • Move to upper level in menu system. File view mode: • Same as Normal mode. Slideshow mode: • Changes input source when pushing shorter than 1 seconds. • Exits slideshow and go
ページ19に含まれる内容の要旨
Remote control keypad and functions Remote Control 1 8 7 2 6 3 5 4 1. AUTOSET Auto set Normal mode: 2. • When OSD is not displayed: No action • When OSD is displayed: Confirm screen menu selections File view mode: • When OSD is not displayed: Highlight on a file: Start the slideshow Highlight on a directory: Change the directory • When OSD is displayed: Confirm screen menu selections Slideshow mode: • To pause or re-start the slide show 3. Volume +/- Adjust volume 4. Keystone Correc
ページ20に含まれる内容の要旨
Using the battery pack with the projector The following procedures are for the installation of the battery pack with the projector. Installing the battery Turn off the power switch and disconnect the AC adaptor. Open the battery connector cover. Plug in the battery pack. Press down the battery pack firmly until it clicks into place. Switch the power button to turn on the projector. Remove the battery Turn off the power switch and disconnect the AC adaptor. Move the button to “unloc
