ページ1に含まれる内容の要旨
Quick Start Reference Sheet
Panasonic PT-LB10VU
Revision A
NOTE: This one-page document is intended only as a quick reference for installation – please read
the SP Controls Application Note for a complete description of this projector driver prior to installation.
I. Driver Features
1. Input Selection Mapping
Selection 1: VIDEO
Selection 2: S-VIDEO
Selection 3: RGB
Selection 4: NETWORK
2. Hidden Function Mapping (Default Configuration)
Using the ON button as a shift key, press
ページ2に含まれる内容の要旨
Projector Driver Application Note Panasonic PT-LB10VU Revision A This document describes the SmartPanel Projector Driver for the Panasonic PT-LB10VU projector. This driver is also appropriate for use with the Panasonic PT-LB10VU projector. For more information on configuring and using the Panel see the SmartPanel Configuration and Installation Manual. I. PROJECTOR CONTROL A. Volume and Power Control Volume control on the Panasonic is absolute. B. Input Selection Mapping
ページ3に含まれる内容の要旨
SmartPanel Projector Driver Application Note Panasonic PT-LB10VU The hidden functions available for the Panasonic with this Driver are as follows: MENU ENTER FREEZE ADJUST LEFT AV MUTE SHUTTER ADJUST RIGHT DIGITAL ZOOM UP FUNC1 ADJUST UP DIGITAL ZOOM DOWN AUTO SETUP ADJUST DOWN D. Relays The following table specifies the factory preset settings for the low-current relays found on the rear of the SmartPanel. The Configuration Utility can RELAYS 500mA MAX. CURRENT be use
ページ4に含まれる内容の要旨
SmartPanel Projector Driver Application Note Panasonic PT-LB10VU II. CONTROL WIRING This section specifies wiring for the Panasonic projector. PROJECTOR CONTROL Note: The Panasonic PT-LB10VU projector serial port is a female 8-pin mini-DIN. This document provides instructions RS232 IR/SERIAL for terminating the RS-232 control cable directly onto a male 8-pin mini-DIN connector. If you wish to terminate the control cable on a standard DB9 connector, an adaptor cable may be separately
ページ5に含まれる内容の要旨
SmartPanel Projector Driver Application Note Panasonic PT-LB10VU III. TROUBLESHOOTING Addition tips can be found in the SmartPanel Configuration and Installation Manual. The Panel does not completely control the projector.. Full control of the projector requires wiring of both the infrared emitter and RS-232. Make sure that RS-232 is correctly connected through Panasonic’s SERIAL port. Also be sure that the IR Emitter bud is firmly seated on one of the projector IR windows. The
