ページ1に含まれる内容の要旨
JVC DILA projector Firmware Update Instructions
OUTLINE
This document describes how to update the firmware in the following JVC DILA
projectors:
DLA-X3
DLA-RS40
EQUIPMENT REQUIRED
To carry out the firmware update, you will need:
• The JVC update program installer: “X3_V1_3.exe”
• A Standard PC running Windows XP™ or Later with a USB Port.
• A USB to Mini USB cable.
• A crosshead screwdriver.
INSTALL USB DRIVER
If you are reading this, you should now have the JVC DILA Pro
ページ2に含まれる内容の要旨
JVC DILA projector Firmware Update Instructions In the first Wizard screen, in response to the question “Can Windows connect to Windows Update to search for software?” choose “No, Not this time”, and then click “Next” In the second Wizard screen, in response to the question “What do you want the wizard to do?” choose “Install the software automatically (Recommended)”, and then click “Next”. Page 2 of 6
ページ3に含まれる内容の要旨
JVC DILA projector Firmware Update Instructions The Wizard will install the driver and then display a message to confirm that it has completed the installation *If, for any reason, the driver does not install automatically, you can install it manually. You will find the Driver and .Inf file in the application folder. When the Wizard has finished installing the driver, click “Finish”. After a few seconds, if the driver has installed successfully, you will see this confirmatio
ページ4に含まれる内容の要旨
JVC DILA projector Firmware Update Instructions UPDATE PROJECTOR FIRMWARE With the projector in Standby Mode, remove the mains lead from the projector and wait until the Standby LED goes out. Hold down the Standby/On button on the projector and plug the mains lead back in while still holding the button down. The three LEDs on the projector should all light to show that the projector is in Download Mode. Start the ILA-FPJ Updater.exe program. This will display the following: C
ページ5に含まれる内容の要旨
JVC DILA projector Firmware Update Instructions Choose the model of your projector as appropriate, and then click “OK”. The update program will then ask you to confirm that you want to continue. It will also give a last chance to confirm the model number. If everything is correct, click “Yes” to continue. The program will then start to transfer the new firmware to the projector. The bar will give an indication of progress. The transfer should take 70-80 seconds. Wh
ページ6に含まれる内容の要旨
JVC DILA projector Firmware Update Instructions Click “OK” to continue. The program will then show that the transfer is complete and, after 3-4 seconds, the text in the “Browse” and “Update” buttons will change from grey to black. After this happens, press the Standby/On button on the projector. The three LEDs will flash slowly for around 30-40 seconds. The projector will then go into Standby mode. CHECK FIRMWARE VERSION To check that the firmware has been updated correctly,
