ページ1に含まれる内容の要旨
Projector Service Manual
Model: S5201/S5201B/S5301WB series
Version: Rev1
First Edition (Dec. 2010)
RESTRICTIONS ON USE OF MATERIALS:
1
ページ2に含まれる内容の要旨
Index REVISION LIST ....................................................................................................................3 CHAPTER 1 SYSTEM SPECIFICATION .........................................................................4 Product Specification..................................................................................................................4 Electrical Specification.........................................................................................
ページ3に含まれる内容の要旨
Revision List Vendor Release Version Revision History Model Date Name Rev0 2010.12.21 First Release Add S5201B/S5301WB (1) Ch1-Add SPEC (2) Ch2-Update Firmware Upgrade SOP (3) Ch3-Disassembly process, Module Assembly Key Point Rev1 2011.01.11 (4) Ch4-Add “DMD Image Quality “ section, Change RS232 baud rate default to 9600. (5) Ch5-FRU List (6) App.-DDC data 3
ページ4に含まれる内容の要旨
Chapter 1 System Specification Product Specification 1.0 Optical Performance 2.0 Image Quality 3.0 Mechanical Specification 4.0 Packaging 5.0 Thermal Specification 6.0 Environmental 7.0 Regulatory 8.0 Reliability 9.0 Power Requirements 10.0 Panel Specification 11.0 Compatibility 12.0 Image Interface 13.0 Control Interface 14.0 User Interface 4
ページ5に含まれる内容の要旨
Tested under 60” (diagonal) image size with Wide 1.0 Optical Performance projection lens position unless other specified. 1.1 ANSI Brightness Minimum 2400 Lumens 1.2 Brightness Uniformity 1.2.1 ANSI Uniformity Minimum 45% 1.2.2 JBMA Uniformity Minimum 65% 1.2.3 Upper-Down 0.5~2 unbalance 1.2.4 Left-Right unbalance 0.6~1.67 1.3 Contrast Ratio 1.3.1 ANSI Contrast Minimum 150:1 1.3.2 FOFO Contrast Minimum 1800:1 without APM 1.3.3 FOFO Contrast with Minimum 3200:1 AP
ページ6に含まれる内容の要旨
S5201/S5201B : |A| <= 4.5 mm, |B| <= 4.0 mm, |C| <= 3.5 mm with 81” image size 2.3.3 Screen distortion S5301WB : |A| <= 6.0 mm, |B| <= 5.5 mm, |C| <= 4.0 mm with 95” image size S5201/S5201B : 130% ±5% 2.4 Projection Offset S5301WB : 110% ±5% 2.5 Focus Range 2.5.1 Visible Range 0.5~2m 2.5.2 Clearly Focus 0.75~1.6 m(Spec. defined as item 2.6) Range 2.6 Focus (1) If pattern can be uniformly focused (not worse than 2.6.1区 Pattern Limit Sample), then pass! (2) If it’s dif
ページ7に含まれる内容の要旨
Operating 10~90%RH, without condensation 6.2 Humidity Storage 10~90%RH, without condensation Normal mode: 36dBA @ 23±2°C, CW x2 speed Eco mode: 31dBA @ 23±2°C, CW x2 speed Typical Normal mode: 38dBA @ 23±2°C, CW x3 speed Eco mode: 33dBA @ 23±2°C, CW x3 speed 6.3 Audible Noise Level Normal mode: 38dBA @ 23±2°C, CW x2 speed Eco mode: 33dBA @ 23±2°C, CW x2 speed Maximum Normal mode: 40dBA @ 23±2°C, CW x3 speed Eco mode: 35dBA @ 23±2°C, CW x3 speed Operating: 1. 12,000 feet @ 25°C
ページ8に含まれる内容の要旨
11.4 DDC EDID1.3 Adhere to Appendix A 12.0 Image Interface Adhere to Electrical Specification 15 pin D-Sub (Female) x 2 G(Y): Video amplitude 0.7/1.0 Vp-p : Impedance 75Ω 12.1 Analog RGB Input RB(CbCr): Video amplitude 0.7 Vp-p : Impedance 75Ω HD/VD/CS: TTL Level RCA jack (Yellow) 12.2 Video Input Video amplitude 1.0 V : Impedance 75Ω p-p 4 pin Mini-Din (Female) 12.3 S-Video Input Y: Luminance amplitude 1.0 V : Impedance 75Ω p-p C: Chroma amplitude 0.268 V : Impedance 75Ω p-p 12.
ページ9に含まれる内容の要旨
IEEE 802.3u compliance ANSI X3T12 TP-PMD 1995 S5301WB : USB Type A for Wireless Dongle Compliant to following standards, IEEE 802.11b:up to 11 Mbps,2.4GHz. IEEE 802.11g:up to 54 Mbps,2.4GHz. IEEE 802.11n draft 6.0:up to 150Mbps,2.4GHz. S5201 / S5201B : Mini Type B x 1 Terminal for page up/down 13.4 USB Connector S5301WB : Mini Type B x 1 Terminal for page up/down & USB mouse 14.0 User Interface Adhere to Electrical Specification 9 Keys: 14.1 Operator Keypad Power ; Source ; Resync
ページ10に含まれる内容の要旨
(Only for S5201) 2. SW source Detection：Please see Appendix E Item 9 22.0 Alarm sound (Only for S5201B/ S5301WB) 22.1 Power on Beep sound Frequency follows Acer SW spec 1.19. Only one volume Frequency follows Acer SW spec 1.19. Three kinds of 22.2 Timer volume setting 3D Projection : This function is only for 3D contents and must wear 3D glasses. TI DDP DDP2430 TI DDP DDP2431 • Does not support FRC (Frame Rate • Support FRC (Frame Rate Conversion) Conversion) • Can not su
ページ11に含まれる内容の要旨
If non-3D mode (120Hz), keep normal/same brightness. Not support timing in 3D mode requirement • 3D function can be opened when 50/60/100/120Hz. • Refresh rate change to not supported 3D timings under 3D mode, please show warning message of "Input Not Supported under 3D mode", to enforce user to change back. Reminder screen 11
ページ12に含まれる内容の要旨
Electrical Specification 1. Timing Table The PC timing is as following: (For S5201): Refresh rate H-frequency Clock Resolution Mode (Hz) (kHz) (MHz) VGA_60 59.940 31.469 25.175 VGA_72 72.809 37.861 31.500 640 x 480 VGA_75 75.000 37.500 31.500 VGA_85 85.008 43.269 36.000 VGA_120 119.518 61.910 52.500 SVGA_56 56.250 35.156 36.000 SVGA_60 60.317 37.879 40.000 SVGA_72 72.188 48.077 50.000 800 x 600 SVGA_75 75.000 46.875 49.500 SVGA_85 85.061 53.674 56.250 SV
ページ13に含まれる内容の要旨
(For S5201B/S5301WB): Refresh rate H-frequency Clock Resolution Mode (Hz) (kHz) (MHz) VGA_60 59.940 31.469 25.175 VGA_72 72.809 37.861 31.500 640 x 480 VGA_75 75.000 37.500 31.500 VGA_85 85.008 43.269 36.000 VGA_70 70.087 31.469 28.3221 720 x 400 VGA_85 85.039 37.927 35.500 SVGA_56 56.250 35.156 36.000 SVGA_60 60.317 37.879 40.000 800 x 600 SVGA_72 72.188 48.077 50.000 SVGA_75 75.000 46.875 49.500 SVGA_85 85.061 53.674 56.250 XGA_60 60.004 48.363 65.000
ページ14に含まれる内容の要旨
The DVI_D & HDMI (HDCP) Established timing is as following: (For S5201): Refresh rate H-frequency Clock Resolution Mode (Hz) (kHz) (MHz) VGA_60 59.940 31.469 25.175 VGA_72 72.809 37.861 31.500 640 x 480 VGA_75 75.000 37.500 31.500 VGA_85 85.008 43.269 36.000 VGA_120 119.518 61.910 52.500 SVGA_56 56.250 35.156 36.000 SVGA_60 60.317 37.879 40.000 SVGA_72 72.188 48.077 50.000 800 x 600 SVGA_75 75.000 46.875 49.500 SVGA_85 85.061 53.674 56.250 SVGA_120 119.8
ページ15に含まれる内容の要旨
480i 60 15.73 27.000 480p 60 31.47 27 576i 50 15.63 27.000 576p 50 31.25 27.000 720p_60 60 45.00 74.25 720p_50 50 37.50 74.25 Video(HDMI) 1080i_60 60 33.75 74.25 1080i_50 50 28.13 74.25 1080p 60 67.5 148.5 1080p 50 56.26 148.5 1080p 24 27.00 74.25 1080p 23.98 26.97 74.175 (For S5201B/S5301WB) : Refresh rate H-frequency Clock Resolution Mode (Hz) (kHz) (MHz) VGA_60 59.940 31.469 25.175 VGA_72 72.809 37.861 31.500 640 x 480 VGA_75 75.000 37.500 31.500 VGA_85 85.008
ページ16に含まれる内容の要旨
WXGA_85 84.837 68.633 117.500 1280 x 720 WXGA_60 60.000 45.000 74.250 1280 x 800 WXGA_60 59.810 49.702 83.500 1440 x 900 WXGA+_60 59.887 55.935 106.500 1680 x 1050 1680x1050_60 59.954 65.290 146.250 1920 x1080 1920x1080_RB 60.000 66.587 138.500 1920 x1080 1920x1080_EIA 60.000 67.500 148.500 1366 x 768 acer_16:9 59.790 47.712 85.500 1024 x 600 acer_timing 60.000 37.500 50.400 480p 60 31.47 27 576p 50 31.25 27.000 720p_60 60 45.00 74.25 720p_50 50 37.50 74.25 1080i_60 60 33.75 74.25
ページ17に含まれる内容の要旨
2. Characteristics of inputs/outputs Signal Parameter Min Type Max RDATA Impedance 75 Ohm GDATA Amplitude 0.7 Volts peak-to-peak BDATA Black pedestal 0 Volts Pixel Clock 170 M Hz GDATA_SO Impedance 75 Ohm G Amplitude 1 Volts peak-to-peak Video amplitude 0.7 Volts peak-to-peak Sync amplitude 0.3 Volts peak-to-peak Black pedestal 0 Volts Pixel Clock 170 M Hz HDATA Impedance 1 K ohm Amplitude, low level 0 0.8 volt Amplitude, high level 2.5 5 Volt Frequency
ページ18に含まれる内容の要旨
5 1 6 10 11 15 Pin Definition Pin Definition Pin Definition Pin Definition Red video Green Video Blue Video 1 2 3 4 NC (Pr) (Y) (Pb) Red Video Green Video Blue Video 5 NC 6 7 8 Return Return Return Bi-directional 9 DDCP 5V 10 GND 11 GND 12 data (SDA) Horizontal Data clock 13 14 Vertical Sync 15 Sync (SCL) Video & Component Input 1 11 1 Pin Definition Composite video 1 tt uu pp nn ii tt uu ee tt pp nn ss ii ii oo ee pp tt mm ss oo CC ii oo pp mm oo CC input
ページ19に含まれる内容の要旨
HDMI Input Mini USB TYPE B (for S5201B/S5301WB) Pin Description 1 Vbus 2 D- 3 D+ 4 ID 5 GND 19
ページ20に含まれる内容の要旨
Power Supply Specification 1. Input Power Specification Specification Description The unit shall meet all the operating requirements with the range Input Voltage Range 90 ~ 264 VAC The unit shall meet all the operating requirements with an input Frequency Range frequency range 47 Hz ~ 63 Hz Normal operation: 352W (Max) Power Consumption standby mode: < 1W, at 100 ~ 240VAC, monitor out function off, LAN function off, 12V outlet off Regulation Efficiency 80 % (typical) measuring at 1
