ページ1に含まれる内容の要旨
4-077-171-11(1)
Color Rear Video Projector
Operating Instructions
KP-43T75
KP-48S75
KP-53S75
KP-53N77
KP-61S75
© 2000 Sony Corporation
ページ2に含まれる内容の要旨
equipment generates, uses, and can radiate radio CAUTION WARNING frequency energy and, if not installed and used in When using TV games, computers and similar products accordance with the instructions, may cause harmful with your projection TV, or viewing a TV station whose To prevent fire or shock interference with radio communications. However, logo always stays on the screen, keep the brightness hazard, do not expose the TV there is no guarantee that interference will not occur and contrast f
ページ3に含まれる内容の要旨
ページ4に含まれる内容の要旨
Table of Contents Connecting a DTV (digital television) Welcome! ........................................ 1 Adjusting Your SET UP (menus) ... 25 receiver ............................................. 13 Learning Menu Selection .......................... 25 Using This Manual .......................... 1 Connecting a camcorder ..................... 13 Using the Video Menu ......................... 26 Connecting two VCRs for tape Precautions...................................... 2 editing ........
ページ5に含まれる内容の要旨
Using This Manual Welcome! We recommend that you carefully review Thank you for purchasing the Sony Color Operating Video Equipment ........... 47 the contents of the following four sections in Rear Video Projection TV. the order provided to ensure that you fully Setting the Manufacturer's Code ................ 47 understand the operation of your new This manual is for models KP-43T75, KP- projection TV. 48S75, KP-53S75, KP-53N77, KP-61S75. Operating a Cable Box or Satellite 1 Installing and Con
ページ6に含まれる内容の要旨
Installing and Connecting the Projection TV (continued) Precautions Safety Note on cleaning Installing • Operate the projection TV only on 120 V • To prevent internal heat buildup, do not Clean the cabinet of the projection TV with a AC. block the ventilation openings. dry soft cloth. To remove dust from the • The plug is designed, for safety purposes, screen, wipe it gently with a soft cloth. • Do not install the projection TV in a hot to fit into the wall outlet only one way. If or humid plac
ページ7に含まれる内容の要旨
Important Safeguards For your protection, please read these Grounding or Polarization Overloading instructions completely, and keep this This set is equipped with a polarized AC Do not overload wall manual for future reference. power cord plug (a plug having one blade outlets, extension cords or wider than the other), or with a three-wire convenience receptacles Carefully observe and comply with all grounding type plug (a plug having a third beyond their capacity, warnings, cautions and instruct
ページ8に含まれる内容の要旨
ページ9に含まれる内容の要旨
Power-Cord Section 810 of the National Electrical Code Lightning Protection (NEC) in USA and Section 54 of the For added protection for this television Canadian Electrical Code in Canada provides Do not allow anything to receiver during a lightning storm, or when it information with respect to proper is left unattended and unused for long rest on or roll over the grounding of the mast and supporting power cord, and do not periods of time, unplug it from the wall structure, grounding of the lead-
ページ10に含まれる内容の要旨
Important Safeguards (continued) Installing and Connecting the Projection TV (continued) When the set reaches the - If the set has been Servicing end of its useful life, exposed to rain or water. Do not attempt to service improper disposal could the set yourself since result in a picture tube opening the cabinet may implosion. Ask a expose you to dangerous qualified service voltage or other hazards. - If the set has been technician to dispose of Refer all servicing to subject to excessive shock
ページ11に含まれる内容の要旨
min. 2.4m (approx. 8 ft.) 61" min. 2.1m (approx. 7 ft.) 53" min. 1.8m (approx. 6 ft.) 48" min. 1.5m (approx. 5 ft.) 43" min. 2.4m (approx. 8ft.) 61" min. 2.1m (approx. 7ft.) 53" min. 1.8m (approx. 6ft.) 48" min. 1.5m (approx. 5ft.) 43" Installing and Connecting the Projection TV Recommended viewing area Carrying Your Projection TV Installing the Projection TV (Vertical) Carrying the projection TV requires three or Recommended viewing area more people. (Horizontal) For KP-48S75/53S75/53N77/61S75
ページ12に含まれる内容の要旨
ページ13に含まれる内容の要旨
ページ14に含まれる内容の要旨
ページ15に含まれる内容の要旨
Disconnect all power sources before making any connections. Note: • To view scrambled channels through the cable box, select the video input which the cable box is connected to by pressing TV/ VIDEO. * If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable. ** If you are connecting a monaural VCR, connect only the single audio output to the left (MONO) input on the projection TV. (Rear of projection TV) Connecting a satellite receiver Cable/ (SAT) Satel
ページ16に含まれる内容の要旨
Installing and Connecting the Projection TV (continued) Disconnect all power sources before making any connections. Connecting a satellite receiver (SAT) and a VCR 1 Connect the cable from the satellite (Rear of projection TV) antenna to the satellite receiver. Coaxial cable 3 AUX 2 Attach the coaxial cable from the SAT TO incoming cable connection or antenna to SATELLITE IN CONVERTER VHF/UHF VHF/UHF IN on the VCR. AUDIO R AUDIO L VIDEO S VIDEO OUT IN LINE VIDEO 1 VIDEO 3 IN OUT VHF/UHF 3 Usin
ページ17に含まれる内容の要旨
Disconnect all power sources before making any connections. Connecting a DTV (digital television) receiver Before connecting, be sure to read the Operating Instructions of the DTV receiver. YC-15V/30V (not supplied) S VIDEO (Rear of projection TV) 1 Attach the coaxial cable from the roof 2 antenna to VHF/UHF IN (DTV) on the DTV AUX receiver. DTV receiver TO 2 Using AUDIO and S VIDEO cables, connect CONVERTER VIDEO AUDIO and S VIDEO OUT on the DTV 123 VHF/UHF IN Y IN ACCESS CARD S VIDEO receiver
ページ18に含まれる内容の要旨
Installing and Connecting the Projection TV (continued) Disconnect all power sources before making any connections. Connecting two VCRs for tape editing (Rear of projection TV) By connecting a second VCR to MONITOR OUT, you can record a program being played AUX by the primary VCR to the second VCR or TO CONVERTER perform tape editing and dubbing. IN 1 Connect the VCR intended for playback VIDEO 1 VIDEO 3 VHF/UHF OUT using the connection instructions on page S VIDEO MONITOR AUDIO (VAR/FIX) 10 of
ページ19に含まれる内容の要旨
Disconnect all power sources before making any connections. Connecting a DVD Player (Upper (Rear of projection TV) illustration) AUX Using an AUDIO and S VIDEO cables, TO connect AUDIO and S VIDEO IN on the CONVERTER DVD projection TV to AUDIO and S VIDEO OUT S VIDEO IN LINE OUT S VIDEO OUT S-LINK DIGITAL OUT on the DVD Player (White-AUDIO Left, Red- VIDEO 1 VIDEO 3 R–AUDIO 1–L VIDEO OPTICAL COAXIAL VHF/UHF OUT AUDIO Right). S VIDEO MONITOR AUDIO (VAR/FIX) VIDEO Y VIDEO Connecting a DVD Player w
ページ20に含まれる内容の要旨
Installing and Connecting the Projection TV (continued) Disconnect all power sources before making any connections. Connecting an audio system For more dynamic sound, connect an audio (Rear of projection TV) system to the projection TV. Stereo amplifier 1 Using an AUDIO cable, connect AUDIO (VAR/FIX) OUT on the projection TV to one of the unused Line inputs (e.g. Tape- IN VIDEO 1 VIDEO 3 2, AUX1, etc.) on the stereo. OUT HRD S VIDEO MONITOR AUDIO (VAR/FIX) 2 Set the stereo to the chosen Line inp
