ページ3に含まれる内容の要旨
50HM67_EN.book Page 3 Thursday, March 29, 2007 11:28 AM Important Safety Instructions 15) CAUTION: To reduce the risk of electric shock, do not use the 1) Read these instructions. polarized plug with an extension cord, receptacle, or 2) Keep these instructions. other outlet unless the blades can be inserted completely to prevent blade exposure. 3) Heed all warnings. 4) Follow all instructions. To prevent electric shock, match wide blade of plug to wide slot; fully insert. 5) Do not u
ページ4に含まれる内容の要旨
50HM67_EN.book Page 4 Thursday, March 29, 2007 11:28 AM 24) Never block or cover the slots or openings in the TV 32) WARNING: cabinet back, bottom, and sides. Never place the TV: RISK OF ELECTRIC SHOCK! on a bed, sofa, rug, or similar surface; Never spill liquids or push objects of any kind into the TV too close to drapes, curtains, or walls; or cabinet slots. in a confined space such as a bookcase, built-in cabinet, or any other place with poor ventilation. 33) If the air temperatur
ページ5に含まれる内容の要旨
50HM67_EN.book Page 5 Thursday, March 29, 2007 11:28 AM 39) When the TV reaches the end of its useful life, ask a qualified service technician to properly dispose of the TV. FCC Declaration of Conformity Note: The lamp unit contains mercury. Disposal of mercury may be regulated due to environmental Compliance Statement considerations. Dispose of the used lamp unit by the approved method for your area. (Part 15): For disposal or recycling information, please contact your local authoriti
ページ6に含まれる内容の要旨
50HM67_EN.book Page 6 Thursday, March 29, 2007 11:28 AM “Voice announce” feature Important notes about your When certain non-standard conditions occur, the LEDs on the TV will blink and the TV will play a recorded ® “voice announcement” describing the condition (see the DLP projection TV LED indication table on page 62 for the specific conditions that include a voice announcement). To repeat the voice announcement and hear additional 1) The light source for this TV is a projection lamp
ページ7に含まれる内容の要旨
50HM67_EN.book Page 7 Thursday, March 29, 2007 11:28 AM Contents ® Chapter 1: Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Scrolling the TheaterWide picture Welcome to Toshiba . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 (TheaterWide 2 and 3 only) . . . . . . . . . . . . . . . . . . . . . . 42 Features of your new TV . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Using the auto aspect ratio feature . . . . . . . . . . . . . . . . . .
ページ8に含まれる内容の要旨
03TOC.fm Page 8 Thursday, March 29, 2007 1:51 PM Chapter 9: Appendix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .63 Lamp unit replacement and care. . . . . . . . . . . . . . . . . . . . . . 63 Replacing the lamp unit (User-replaceable component). . . . . . . . . . . . . . . . . 63 When to replace the lamp unit . . . . . . . . . . . . . . . . . . . . 63 How to replace the lamp unit . . . . . . . . . . . . . . . . . . . . . 64 Disposing of the used lamp unit. . . . . . . . . . .
ページ9に含まれる内容の要旨
50HM67_EN.book Page 9 Thursday, March 29, 2007 11:28 AM Chapter 1: Introduction NOTICE OF POSSIBLE TV STAND INSTABILITY Features of your new TV DANGER: RISK OF SERIOUS PERSONAL INJURY OR DEATH! Use this TV only with The following are just a few of the many exciting features of the TOSHIBA TV stand listed in the ® your new Toshiba widescreen, integrated HD, DLP “Specifications” section of this manual. Use with other projection TV: stands may result in instability, causing possible injur
ページ10に含まれる内容の要旨
50HM67_EN.book Page 10 Thursday, March 29, 2007 11:28 AM Chapter 1: Introduction 10 After you plug in the TV power cord, the yellow LED Overview of steps for installing, (on the TV front) will blink 3 times. Wait several seconds until the yellow LED stops blinking and then press p on setting up, and using your new TV the TV or remote control. See “LED indications” (- page 62). Follow these steps to set up your TV and begin using its many 11 See “Menu layout and navigation” for a quick ov
ページ11に含まれる内容の要旨
50HM67_EN.book Page 11 Thursday, March 29, 2007 11:28 AM Chapter 1: Introduction TV front and side panel controls and connections Front of TV Right side of TV 3 1 7 4 10 2 8 5 6 9 Control panel Side panel 1 Remote sensor (behind the screen) — Point the remote 9 EXIT — Press to instantly close an on-screen menu. control toward this area of the TV screen (- “Remote 10 VIDEO-2 IN — The side panel A/V connections are control effective range” on page 22). referred to as “VIDEO 2” and include sta
ページ12に含まれる内容の要旨
50HM67_EN.book Page 12 Thursday, March 29, 2007 11:28 AM Chapter 1: Introduction TV back panel connections For an explanation of cable types and connections, see pages 13–21. 9 12 3 4 5 6 7 8 ® ® 1 ColorStream HD-1 and ColorStream HD-2 — 7 IR OUT — For controlling infrared remote-controlled ® Two sets of ColorStream high-definition component devices through the TV. You can connect up to two video inputs (with standard stereo audio inputs) for devices with an IR blaster cable, and then contr
ページ13に含まれる内容の要旨
50HM67_EN.book Page 13 Thursday, March 29, 2007 11:28 AM Chapter 2: Connecting your TV ™ HDMI cable Overview of cable types Coaxial (F-type) cable HDMI (High-Definition Multimedia Interface) cable is for use with devices with an HDMI output. An HDMI cable delivers digital audio and video in its native format. This cable carries both video and audio information; therefore, separate audio Coaxial (F-type) cable is used for connecting your antenna, cables are not required for a complete HDM
ページ14に含まれる内容の要旨
50HM67_EN.book Page 14 Thursday, March 29, 2007 11:28 AM Chapter 2: Connecting your TV Connecting a VCR and antenna or Cable TV (no Cable box) From Cable TV or antenna TV back panel Stereo VCR VIDEO AUDIO LR IN IN from ANT CH 3 CH 4 OUT OUT to TV L R You will need: To view the antenna or Cable signal: Select the ANT video input source on the TV.* coaxial cables standard A/V cables To view the VCR: – For better picture performance, if your VCR has S-video, Turn ON the VCR. Select the V
ページ15に含まれる内容の要旨
50HM67_EN.book Page 15 Thursday, March 29, 2007 11:28 AM Chapter 2: Connecting your TV Connecting a VCR with S-video and a cable box An S-video connection will provide better picture performance than a standard (composite) video cable. From Cable TV Cable box IN CH 3 CH 4 OUT TV right side panel stereo VCR TV back panel VIDEO AUDIO LR IN IN from ANT CH 3 CH 4 OUT OUT to TV L R You will need: To view basic and premium Cable channels: Turn OFF the VCR. Select the ANT video input source on the
ページ16に含まれる内容の要旨
50HM67_EN.book Page 16 Thursday, March 29, 2007 11:28 AM Chapter 2: Connecting your TV ® Connecting a DVD player with ColorStream (component video), a VCR, and a satellite receiver ® Your TV has two sets of ColorStream (component video) inputs. TV back panel From antenna Stereo VCR AUDIO OUT L Y PR VIDEO AUDIO PB LR IN IN from ANT COMPONENT VIDEO VIDEO R CH 3 S-VIDEO OUT CH 4 OUT OUT OUT to TV DVD player with component video L R From satellite dish AUDIO OUT L Y PB PR R COMPONENT VIDEO VIDE
ページ17に含まれる内容の要旨
50HM67_EN.book Page 17 Thursday, March 29, 2007 11:28 AM Chapter 2: Connecting your TV To connect the IR blaster cable: Connecting a device to the IR OUT 1 Locate the infrared sensor on the front of your device. infrared terminal using the IR This sensor is marked on some devices.* blaster cable for IR pass-through 2 Align one of the IR blaster cable’s wands about 1 inch away from the infrared sensor on the front of the device device control and attach it using double-sided mounting tap
ページ18に含まれる内容の要旨
50HM67_EN.book Page 18 Thursday, March 29, 2007 11:28 AM Chapter 2: Connecting your TV Connecting a camcorder You will need: standard A/V cables – For better picture performance, if your camcorder has S-video, connect an S-video cable (plus the audio cables). Camcorder VIDEO AUDIO OUT L R VIDEO 2 inputs on TV right side panel To view the camcorder video: Select the VIDEO 2 video input source on the TV.* * To select the video input source, press INPUT on the remote control (- page 23).
ページ19に含まれる内容の要旨
50HM67_EN.book Page 19 Thursday, March 29, 2007 11:28 AM Chapter 2: Connecting your TV To connect a DVI device, you will need: ™ Connecting an HDMI or DVI device one HDMI-to-DVI adapter cable (HDMI type A connector) per DVI device to the HDMI input – For proper operation, the length of an HDMI-to-DVI adapter cable should not exceed 9.8 ft (3m). The The HDMI input on your TV receives digital audio and recommended length is 6.6 ft (2m). uncompressed digital video from an HDMI source devi
ページ20に含まれる内容の要旨
50HM67_EN.book Page 20 Thursday, March 29, 2007 11:28 AM Chapter 2: Connecting your TV Note: Connecting a digital audio system Some audio systems may not be compatible with Dolby Digital bitstream signals. Older audio systems that are not compatible with standard optical out signals may not work ® The TV’s DIGITAL AUDIO OUT terminal outputs a Dolby * properly, creating a high noise level that may damage Digital g or 2-channel down-mixed PCM (pulse-code speakers or headphones. THIS DA
ページ1に含まれる内容の要旨
50HM67_EN.book Page 1 Thursday, March 29, 2007 11:28 AM
Integrated High Definition
®
DLP Projection Television
HIGH-DEFINITION TELEVISION
50HM67
57HM167
65HM167
For an overview of steps for setting up your new TV, see page 10.
Note: To display a High Definition picture, the TV must be receiving a
High Definition signal (such as an over-the-air High Definition TV
Owner’s Record
broadcast, a High Definition digital cable program, or a High Definition
The model number and serial number are
ページ2に含まれる内容の要旨
50HM67_EN.book Page 2 Thursday, March 29, 2007 11:28 AM Dear Customer, CAUTION: This television is for use only with the Toshiba stand indicated below. Use with other Thank you for purchasing this Toshiba TV. This manual will carts or stands is capable of resulting in help you use the many exciting features of your new TV. Before instability, causing possible injury. operating the TV, please read this manual completely, and Television Stand Model keep it nearby for future referenc
