ページ1に含まれる内容の要旨
DLPTV
INSTRUCTION MANUAL
SP-50L7HR/SP-56L7HR
This device is a Class B digital apparatus.
ページ2に含まれる内容の要旨
Table of Contents Your New Wide TV ............................................................................................6 List of Features.......................................................................................................6 Accessories ...........................................................................................................6 Front Panel Buttons.................................................................................................7 Front Panel
ページ3に含まれる内容の要旨
Special Features ...............................................................................................44 Customizing Your Remote Control ..........................................................................44 Remote Control Codes..........................................................................................45 Fine Tuning Channels ...........................................................................................46 LNA (Low Noise Amplifier).......................
ページ4に含まれる内容の要旨
SAMSUNG
ページ5に含まれる内容の要旨
Your New Wide TV
ページ6に含まれる内容の要旨
Your New Wide TV List of Features Your TV was designed and engineered using the latest technology. It is a full-featured, high-performance unit that exceeds industry standards. In addition, it has these special features: • Easy-to-operate remote control • Easy-to-use on-screen menu system you can access from the side panel or remote control • Automatic timer to turn the TV on and off at any time you choose • Adjustable picture and sound settings and the ability to memorize your favorite settings
ページ7に含まれる内容の要旨
Front Panel Buttons The buttons on the front panel control your TV’s basic features, including the on-screen menu system. To use the more advanced features, you must use the remote control. Standby state. Auto timer on has been set. (Standby indicator; Red) (Timer indicator) Press and hold the POWER button for a few seconds to Press to switch between viewing TV programs and turn the TV on or off. signals from connected components. Press to lower or raise the volume and to select items Press to c
ページ8に含まれる内容の要旨
Your New Wide TV Front Panel Information Window The Information window appears as illustrated above while the TV is turning on. (Refer to the TV set’s display for animation details.) When successfully turned on, an animated “Smile” figure appears and then fades out slowly. Appears while the TV is turning off. When these indicators appear, there is a possible problem with the TV. Lamp or other component may be defective. Please contact a certified technician. Check if the ventilation hole on the
ページ9に含まれる内容の要旨
Rear Panel Jacks Use the rear panel jacks to connect components such as a VCR. You can connect different components such as VCRs, Set-Top Box and a DVD player etc., because there are two sets of video input jacks and three set of component video input jacks on the rear panel of your TV. For more information, please see “Connections”. Œ ANTENNA terminals Two independent cables or antennas can be connected to these terminals. Use “ANT 1 IN” and “ANT 2 IN” terminals to receive a signal from VHF/UHF
ページ10に含まれる内容の要旨
Your New Wide TV Remote Control You can use the remote control up to about 23 feet from the TV. When using the remote control, always point it directly at the TV. You can also use your remote control to operate your VCR, Cable box, DVD player or Samsung Set-Top box. See pages 44~45 for details. 1. POWER 16. MODE Turns the TV on and off. Selects a target device to be controlled by the Samsung remote control (i.e., TV, STB, VCR, 2. S.MODE CABLE, or DVD). Adjust the TV sound by selecting one of the
ページ11に含まれる内容の要旨
Installing Batteries in the Remote Control With normal use, the batteries in the remote control should last about a year. If you notice a performance degradation while using the remote, the batteries may need to be replaced. Make sure you replace both batteries and do not mix old and new batteries in the remote control. If you won’t be using the remote control for a long time, remove the batteries and store them in a cool dry place. Slide the back cover all the way out to open the battery compar
ページ12に含まれる内容の要旨
SAMSUNG
ページ13に含まれる内容の要旨
Connections
ページ14に含まれる内容の要旨
Connections Connecting VHF and UHF Antennas If you do not have a cable system, you will need to connect an antenna to your TV. Antennas with 300-ohm Flat Twin Leads If your antenna looks like this: it has 300-ohm flat twin leads. Place the wires from the twin leads under the screws on the 1 300-75 ohm adaptor (not supplied). Use a screwdriver to tighten the screws. Plug the adapter into the “ANT 1 IN” terminal on the 2 rear panel. Antennas with 75-ohm Round Leads If
ページ15に含まれる内容の要旨
Separate VHF and UHF Antennas If you have two separate antennas for your TV (one VHF and one UHF), you must combine the two antenna signals before connecting the antennas to the TV. This procedure requires an optional combiner-adaptor (available at most electronics shops). Connect both antenna leads to the combiner. 1 Plug the combiner into the “ANT 1 IN” terminal on 2 the rear panel. English - 15
ページ16に含まれる内容の要旨
Connections Connecting Cable TV and VCR You can connect different cable systems to your TV, including cable without a cable box, and cable with a cable box that descrambles some or all channels. Cable without a Cable Box If you want to connect cable, and you do not need to use a cable box: Plug the incoming cable into the “ANT 1 IN” 1 terminal on the rear panel. Cable with a Cable Box that Descrambles All Channels Find the cable that is connected to the 1 ANTENNA OUT terminal on your cable box.
ページ17に含まれる内容の要旨
Connecting a Cable Converter Box This connection allows you to watch cable and premium channels. You should keep your TV selected to “ANT 1 IN” so that you can use the TV features. When viewing premium channels, select “ANT 2 IN” and tune the TV to channel 3 or 4 (whichever channel is vacant in your area), then use the converter box to change channels. You will need two coaxial cables. NOTES From Cable • When you use a converter box with your TV, there may be features that you can not program us
ページ18に含まれる内容の要旨
Connections Connecting a Camcorder The rear panel jacks on your TV make it easy to connect a camcorder to your TV. You can use your camcorder to view tapes without using a VCR. Camcorder Locate the A/V output jacks on the camcorder. They are usually found on 1 the side or back of the camcorder. TV Rear Panel Connect a set of audio cables between Camcorder Output Jacks the AV (1 or 2) AUDIO (L,R) IN jacks 2 on the TV and the AUDIO OUT jacks on the camcorder. If you have a mono camcorder, connec
ページ19に含まれる内容の要旨
Connecting a DVD Player The rear panel jacks on your TV make it easy to connect a DVD player to your TV. Connecting to Y,PB,PR Connect a set of audio cables between the COMPONENT (1 or 2) 1 AUDIO (L,R) IN jacks on the TV and the AUDIO OUT jacks on the DVD player. To enable Component video viewing, connect a set of video 2 DVD Player cables between the COMPONENT B R (1 or 2) VIDEO (Y, P , P ) IN jacks B R on the TV and VIDEO (Y/P /P or B R Y/C /C ) OUT jacks on the DVD TV Rear Panel player. Note:
ページ20に含まれる内容の要旨
Connections Connecting a DTV Set-Top Box Connecting to Y,PB,PR Connect a set of audio cables between the 1 COMPONENT (1 or 2) AUDIO (L,R) IN jacks on the Incoming Cable TV and the AUDIO OUT or Antenna jacks on the Set-Top Box. Connect a set of video cables between the 2 COMPONENT (1 or 2) B R VIDEO (Y, P , P ) IN jacks on the TV and VIDEO TV Rear Panel DTV Set-Top Box B R B R (Y/P /P or Y/C /C ) OUT jacks on the Set-Top Box. Note: For an explanation of Component video, see your Set Top Box owne
