ページ1に含まれる内容の要旨
OPERATING MANUAL
MODE D’EMPLOI
MANUAL DE FUNCIONAMIENTO
COOLING MODEL
ROOM AIR CONDITIONER
WALL MOUNTED TYPE
Indoor Unit
ASU30CLX1
ASU36CLX1
Outdoor Unit
AOU30CLX1
AOU36CLX1
P/N9315345363
FUJITSU GENERAL LIMITED
9315345363_OM.indb 1 9315345363_OM.indb 1 9 9/16/2010 2:48:16 PM /16/2010 2:48:16 PM
Español Français English
ページ2に含まれる内容の要旨
CONTENTS SAFETY PRECAUTIONS ......................................En-1 ADJUSTING THE DIRECTION OF AIR FEATURES AND FUNCTIONS .............................En-2 CIRCULATION ....................................................En-10 NAME OF PARTS .................................................En-3 SWING OPERATION .......................................... En-11 PREP ARA TION ...................................................... En-5 CLEANING AND CARE ......................................En-12 O
ページ3に含まれる内容の要旨
FEATURES AND FUNCTIONS INVERTER REMOVABLE OPEN PANEL At the start of operation, a large power is used to bring the The indoor unit’s Open Panel can be removed for easy clean- room quickly to the desired temperature. Afterwards, the unit ing and maintenance. automatically switches to a low power setting for economic and comfortable operation. MILDEW-RESISTANT FILTER AUTO CHANGEOVER The AIR FILTER has been treated to resist mildew growth, thus allowing cleaner use and easier care. The operation
ページ4に含まれる内容の要旨
NAME OF PARTS 1 E Fig. 1 8 MANUAL AUTO 9 2 Fig. 2 1 3 3 OPERATION 5 D TIMER 6 SUPER QUIET 7 = A BC Fig. 5 4 Fig. 3 F 8 H G I Fig. 4 Fig. 6 M X ^ Y [ ] K P b Q R L \ a S Z J T N Fig. 7 U W To facilitate explanation, the accompanying illustra- O tion has been drawn to show all possible indicators; V in actual operation, however, the display will only show those indicators appropriate to the current operation. En-3 9315345363_OM.indb Sec1:3 9315345363_OM.indb Sec1:3 9/16/2010 2:48:46 PM 9/
ページ5に含まれる内容の要旨
Fig. 6 Remote Controller Fig. 1 Indoor Unit J SLEEP button 1 Operating Control Panel (Fig. 2) K MASTER CONTROL button 2 MANUAL AUTO button L SET TEMP. button ( / ) ● When kept on pressing the MANUAL AUTO button for more than 10 seconds, M Signal Transmitter the forced cooling operation will start. N TIMER MODE button ● The forced cooling operation is used at the O TIMER SET ( / ) button time of installation. P FAN CONTROL button Only for authorized service personnel’s use. Q START/STOP
ページ6に含まれる内容の要旨
PREPARATION CAUTION! Load Batteries (AAA/R03/LR03 × 2) ● Take care to prevent infants from ac- cidentally swallowing batteries. Press and slide the battery compartment lid on the ● When not using the Remote Control- 1 reverse side to open it. ler for an extended period, remove the Slide in the direction of the arrow while pressing the mark. batteries to avoid possible leakage and damage to the unit. ● If leaking battery fl uid comes in contact with your skin, eyes, or mouth, imme- diatel
ページ7に含まれる内容の要旨
▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ OPERATION To Select Mode Operation Press the START/STOP button (Fig.6 Q). 1 The indoor unit’s OPERATION Indicator Lamp (red) (Fig. 3 5) will light. The air conditioner will start operating. Press the MASTER CONTROL button (Fig.6 K) to select 2 the desired mode. Each time the button is pressed, the mode will change in the following order. AUTO COOL DRY FAN About three seconds later, the entire display will reappear. Example: When set to COOL. To Set the Ther
ページ8に含まれる内容の要旨
To Stop Operation Press the START/STOP button (Fig. 6 Q). The OPERATION Indicator Lamp (red) (Fig. 3 5) will go out. About AUTO CHANGEOVER Operation AUTO: ● When AUTO CHANGEOVER operation fi rst selected, the fan will oper- ate at very low speed for about one minute, during which time the unit detects the room conditions and selects the proper operating mode. If the difference between thermostat setting and actual room tempera- ture is more than +4 °F → Cooling or dry operation If the diffe
ページ9に含まれる内容の要旨
▲ ▲ ▲ ▲ TIMER OPERATION Before using the timer function, be sure that the Remote Controller is set to the correct current time (☞ P. 5). To Use the ON timer or OFF timer To Cancel the Timer Press the START/STOP button (Fig. 6 Q) 1 Use the TIMER button to select “CANCEL”. (if the unit is already operating, proceed to step 2). The air conditioner will return to normal 5 The indoor unit’s OPERATION Indicator Lamp (red) (Fig. 3 ) will light. operation. To Change the Timer Settings Press the TIM
ページ10に含まれる内容の要旨
SLEEP TIMER OPERATION Unlike other timer functions, the SLEEP timer is used to set the length of time until air conditioner operate is stopped. To Use the SLEEP Timer To Cancel the Timer: While the air conditioner is operating or stopped, press the Use the TIMER MODE button to select “CANCEL”. SLEEP button (Fig. 6 J). The air conditioner will return to normal The indoor unit’s OPERATION Indicator Lamp (red) (Fig. 3 5) lights and the TIMER operation. Indicator Lamp (green) (Fig. 3 6) light. T
ページ11に含まれる内容の要旨
ADJUSTING THE DIRECTION OF AIR CIRCULATION ● Adjust the up, down, left, and right AIR directions with the AIR DIRECTION buttons on the Remote Controller. ● Use the AIR DIRECTION buttons after the Indoor Unit has started operating and the airfl ow-direction louvers have stopped moving. DANGER! Vertical Air Direction Adjustment ● Never place fingers or foreign objects inside the outlet ports, since the internal Press the SET button (Vertical) (Fig. 6 R). fan operates at high speed and could
ページ12に含まれる内容の要旨
SWING OPERATION Begin air conditioner operation before performing this procedure. To select SWING Operation Press the SWING button (Fig. 6 T). The SWING Display (Fig. 7 b) will light. Each time the SWING button is pressed, the swing operation will change in the following order. Up/down swing operation Left/right swing operation Swing operation stops Up/down/left/right swing operation To stop SWING Operation Press the SWING button and select STOP. Airfl ow direction will return to the setting bef
ページ13に含まれる内容の要旨
CLEANING AND CARE ● Before cleaning the air conditioner, be sure to turn it off and disconnect the Power Supply CAUTION! Cord. ● Be sure the Intake Grille (Fig. 1 8) is installed securely. ● When removing and replacing the air fi lters, be sure not to touch the heat exchanger, as personal injury may result. Cleaning the Intake Grille Cleaning the Air Filter 1. Remove the Intake Grille. 1. Open the Intake Grille, and remove the air 1 Place your fi ngers at both lower ends of the grille fi lter.
ページ14に含まれる内容の要旨
CLEANING AND CARE Air Cleaning Filter Installation Replacing dirty Air cleaning fi lters Replace fi lters with the following components (purchased 1. Open the Intake Grille and remove the Air separately). fi lters. ● POLYPHENOL CATECHIN AIR CLEANING FILTER : UTR-FA13-1 ● Negative air ions deodorizing fi lter: UTR-FA13-2 1. Open the Intake Grille and remove the Air fi lters. Air Filter (Right & Left) Air Filter 2. Install the Air cleaning fi lter set (set of 2). (Right & Left) 1 Set the air cleaning
ページ15に含まれる内容の要旨
TROUBLESHOOTING In the event of a malfunction (burning smell, etc.), immediately stop operation, turn off the electri- WARNING! cal breaker or disconnect the power supply plug, and consult authorized service personnel. Merely turning off the unit’s power switch will not completely disconnect the unit from the power source. Always be sure to turn off the electrical breaker or disconnect the power supply plug to ensure that power is completely off. Before requesting service, perform the followin
ページ16に含まれる内容の要旨
TROUBLESHOOTING Symptom Items to check See Page ● Is the Power Supply Plug disconnected its outlet? CHECK ONCE Doesn’t operate at all: MORE ● Has there been a power failure? — ● Has a fuse blown out, or a circuit breaker been tripped? ● Is the timer operating? 8 - 9 ● Is the Air Filter dirty? ● Air the air conditioner’s intake grille or outlet port blocked? Poor Cooling performance: ● Did you adjust the room temperature settings (thermostat) cor- rectly? ● Is there a window or door open? — ● In
ページ17に含まれる内容の要旨
OPERATING TIPS Temperature and Humidity Range Cooling Mode Dry Mode Outdoor temperature About 14 to 115 °F About 14 to 115 °F Indoor temperature About 64 to 90 °F About 64 to 90 °F ● If the air conditioner is used under higher temperature conditioner than those listed, the built-in protection circuit may op- erate to prevent internal circuit damage. Also, during Cooling and Dry modes, if the unit is used under conditions of lower temperature than those listed above, the heat-exchanger may freez
ページ18に含まれる内容の要旨
SOMMAIRE PRÉCAUTIONS DE SÉCURITÉ ............................. Fr-1 FONCTIONNEMENT CARACTÉRISTIQUES ET FONCTIONS ................ Fr-2 MANUEL-AUTOMATIQUE .................................... Fr-9 NOMENCLATURE DES ORGANES ...................... Fr-3 RÉGLAGE DE LA DIRECTION DU FLUX D’AIR ...... Fr -1 0 PRÉPARATIFS ........................................................ Fr-5 FONCTIONNEMENT OSCILLANT .......................Fr-11 FONCTIONNEMENT ............................................. Fr-6 NET
ページ19に含まれる内容の要旨
CARACTÉRISTIQUES ET FONCTIONS INVERSEUR PANNEAU D’ACCÈS AMOVIBLE Lors de la mise en fonctionnement, une grande quantité de La Panneau d’accès de l’unité intérieur peut être retirée courant est nécessaire pour amener rapidement la tempé- pour faciliter le nettoyage et l’entretien. rature de la pièce à la température souhaitée. Pour des rai- sons de confort et d’économie d’énergie, la consommation de l’appareil diminue ensuite automatiquement. FILTRE RÉSISTANT ÀUX MOISISSURE Le Filtre à air a re
ページ20に含まれる内容の要旨
NOMENCLATURE DES ORGANES 1 E Fig. 1 MANUAL 8 AUTO 9 2 Fig. 2 1 3 3 OPERATION 5 D TIMER 6 SUPER QUIET 7 = A BC Fig. 5 4 Fig. 3 F 8 H G I Fig. 4 Fig. 6 M X ^ Y [ ] K P b Q R L \ a S Z T J N Fig. 7 W U Afi n de faciliter l’explication, l’illustration fournie O montre tous les témoins possibles ; cependant, en V fonctionnement réel, l’affi chage ne montre que ceux relatifs au fonctionnement en cours. Fr-3 9 9315345363_OM.indb 3 315345363_OM.indb 3 9/16/2010 2:48:52 PM 9/16/2010 2:48:52 PM
