ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Do not make copies of anything which is prohibited from copying by law. The following items are normally prohibited from copying by national law. Other items may be prohibited by local law. Money Stamps Bonds Stocks Bank drafts Checks Passports Driver’s licenses In some areas, the "POWER" switch positions are marked "I" and " " on the copier instead of "ON" and "OFF". If your copier is so marked, please read "I" for "ON" and " " for "OFF". Caution! For a complete electrical disc
ページ4に含まれる内容の要旨
User safety This Toshiba digital plain paper copier does not produce laser radiation hazardous to the user. It is certified as a Class 1 laser product under the U.S.Department of Health and Human Services (DHHS) Radiation Performance Standard according to the Radiation Control Health and Safety Act of 1968. Protective housing and external covers completely confine the laser light emitted inside the plain paper copier. The laser beam cannot escape from the machine during any phase of user oper
ページ5に含まれる内容の要旨
ページ6に含まれる内容の要旨
DISCLAIMER NOTICE The following notice sets out the exclusions and limitations of liability of TOSHIBA TEC CORPORATION (including its employees, agents and sub-contractors) to any purchaser or user ("User") of the e-STUDIO161, including its accessories, options and bundled software ("Product"). 1. The exclusions and limitations of liability referred to in this notice shall be effective to the fullest extent permissible at law. For the avoidance of doubt, nothing in this notice shall be taken
ページ7に含まれる内容の要旨
CONTENTS CAUTIONS................................................................................................................................................. 3 ● CAUTIONS ON USING..................................................................................................................................... 3 ● IMPORTANT POINTS WHEN SELECTING AN INSTALLATION SITE ........................................................... 3 ● CAUTIONS ON HANDLING ........................................
ページ8に含まれる内容の要旨
6 ROUTINE MAINTENANCE CHECKING THE TOTAL OUTPUT COUNT AND TONER LEVEL ................................................ 55 ● CHECKING THE TOTAL OUTPUT COUNT...55 ROUTINE MAINTENANCE.............................. 56 ● CLEANING THE DOCUMENT GLASS AND ADF/ DOCUMENT COVER ............................56 ● CLEANING THE BYPASS TRAY PAPER FEED ROLLER ...............................................56 ● CLEANING THE TRANSFER CHARGER ......57 7 PERIPHERAL DEVICES AND SUPPLIES PERIPHERAL DEVICES..........
ページ9に含まれる内容の要旨
CAUTIONS Follow the cautions below when using this machine. CAUTIONS ON USING Warning: • The fusing area is hot. Exercise care in this area when removing misfed paper. • Do not look directly at the light source. Doing so may damage your eyes. Caution: • Do not switch the machine rapidly on and off. After turning the machine off, wait 10 to 15 seconds before turning it back on. • Machine power must be turned off before installing any supplies. • Place the machine on a firm, level surface. • Do n
ページ10に含まれる内容の要旨
The machine should be installed near an accessible power outlet for easy connection and disconnection. Be sure to connect the power cord only to a power outlet that meets the specified voltage and current requirements. Also make certain the outlet is properly grounded. Connect the machine to a power outlet which is not used for other electric appliances. If a lighting fixture is Note connected to the same outlet, the light may flicker. Be sure to allow the required space around the machine 2
ページ11に含まれる内容の要旨
USING THE MANUAL This machine has been designed to provide convenient copying features in a minimum amount of office space and with maximum operational ease. To get full use of all machine features, be sure to familiarise yourself with this manual and the machine. For quick reference during machine use, keep this manual in a handy location. ABOUT THE OPERATION MANUALS The operation manuals for the machine are as follows: Operation Manual (Multifunctional Digital System) (this manual) This manu
ページ12に含まれる内容の要旨
AB series (metric) and inch series references Both specifications are quoted where applicable. For example: Page 15, step 1....................B4 and A3 (LG and LD) Page 60................................50%, 71%, 82%, 86%, 100%, 115%, 122%, 141%, 200% (50%, 65%, 78%, 95%, 100%, 121%, 129%, 141%, 200%) Although AB series size indications are shown on the operation panel of this manual, inch series indications are displayed on the inch series machines. 6
ページ13に含まれる内容の要旨
MAIN FEATURES High-speed laser copying 1 2 • First-copy time* at 300 dpi* is only 7.2 seconds. • Copying speed is 16 copies per minute. This is ideal for business use and provides a big boost to workplace productivity. 1 * First-Copy time may vary depending on the power-supply voltage, ambient temperature, and other operating conditions. 2 * "dpi" ("dots per inch") is unit that is used to measure resolution. Resolution indicates how much detail can be reproduced in a printed or scanned image.
ページ14に含まれる内容の要旨
Chapter 1 BEFORE USING THE MACHINE 1 This chapter contains basic information that should be read before using the machine. PART NAMES AND FUNCTIONS Document feeder cover (when the ADF is Paper trays installed) /document cover Each tray holds 250 sheets of paper. (p.14) Open to make copies from the document glass. Side cover (p.18) Open to remove paper misfeeds and perform Document glass machine maintenance. (p.48, p.56) Place an original that you wish to copy face down Side cover handle here.
ページ15に含まれる内容の要旨
BEFORE USING THE MACHINE 1 Parallel connector Roller rotating knob Connect to your computer to use the printer Turn to remove misfed paper. (p.47, p.48) function. (Printer Driver Setup Guide) Fusing unit release levers Document feeder tray (when the ADF is To remove a paper misfeed from the fusing unit, installed) push down on these levers and remove the paper. Place the original(s) that you wish to scan face up (p.50) here. Holds up to 40 originals. The fusing unit is hot. Do not touch Orig
ページ16に含まれる内容の要旨
BEFORE USING THE MACHINE OPERATION PANEL AUDIT CLEAR key ( ) ZOOM indicator Closes an open account. (p.39) Lights up when a zoom ratio is set. (p.24) INTERRUPT key ( ) / indicator POWER SAVE indicator ( ) Interrupts a copy run. (p.28) Lights up when the machine is in a power save mode. (p.12) ORIGINAL SIZE ENTER key ( ) / ORIGINAL SIZE indicators Display Use to enter the original size. (p.16) The selected Shows the set number of copies, as well as the original size will light up. copy ratio,
ページ17に含まれる内容の要旨
BEFORE USING THE MACHINE RESET key ( ) CLEAR key ( ) Clears all selected settings and returns the Clears the copy quantity display or terminates a machine to the initial settings. (p.12) copy run. ON LINE key ( ) / indicator Use to check the total number of copies made. Press to toggle the machine between online and 1 (p.55) off-line. The indicator lights up when the machine is online, and goes off when the machine is off-line. START key ( ) /indicator The indicator blinks while the machine
ページ18に含まれる内容の要旨
POWER ON AND OFF The power switch is located on the left side of the machine. POWER ON POWER OFF Turn the power switch to the "ON" Make sure that the machine is not in position. operation and then turn the power switch to the "OFF" position. It will take about 45 seconds for the machine If the power switch is to warm up. While the turned off while the machine is warming up, machine is in operation, a the POWER SAVE misfeed may occur and indicator ( ) will blink. the job that was in
ページ19に含まれる内容の要旨
LOADING PAPER The paper required indicator ( ) will light up when there is no copy paper in the selected paper feed tray, or when the selected paper tray is not installed or is improperly installed. PAPER For best results, use only TOSHIBA recommended paper. Paper tray type Paper type Size Weight Capacity 1 2 2 2 Paper tray Standard paper A5* 56 g/m to 90 g/m * 250 sheets 2 Recycled paper A4 (15 lbs. to 24 lbs. * ) (Load paper lower than B4 the line on the tray) A3 1 ST* LT 8-1/2" x 13" LD 2 2
ページ20に含まれる内容の要旨
BEFORE USING THE MACHINE LOADING PAPER Make sure that the machine is not copying or printing, and then follow these steps to load paper. Loading the paper tray Gently lift and pull out the paper tray Gently push the paper tray into the 1 5 until it stops. machine. If you loaded a different size of paper than Push the pressure plate down until it 2 was loaded previously in the tray, go to Note locks in place. "CHANGING A TRAY’S PAPER SIZE Push the center of the SETTING" (p.16). pressure pla
