Monarch Renegade 9491の取扱説明書

ページ1に含まれる内容の要旨

USING THE 9491™ BOOT KIT
The Monarch® Renegade® 4 printer’s boot protects it if you accidentally
drop it, hit it against something, or jar it in some other manner. Following
is an illustration of the boot on the printer.

Contents of the Boot Kit
The boot kit comes with:
♦ the boot.
♦ two knobs.
♦ two white spacers to use with the knobs.
♦ two black spacers and two screws (industrial version printer only).
TC9491BT Rev. AC 11/00 ©

ページ2に含まれる内容の要旨

Putting the Boot on the Printer To put the boot on the printer: 1. Industrial Version Only. Remove the cable from the side of the printer. Save the cable’s screws for when you want to use the printer without the boot. 2. Unscrew the screw assemblies at the top of the printer (either shoulder strap is optional), and take them off. Save them for when you want to use the printer without the boot. 3. Pull on the boot and fit it around the printer. 4. With Shoulder Strap Only. For both

ページ3に含まれる内容の要旨

6. Industrial Version Only. Put together screw assemblies using the longer screws. Then, replace the cable. Black Spacers Taking the Boot off the Printer To take the boot off the printer: 1. Industrial Version Only. Remove the cable from the side of the printer. Save the spacers and longer screws for when you want to use the printer with the boot. 2. With Shoulder Strap Only. Unscrew the knob assemblies on both sides of the printer (including the shoulder strap, if used), and tak

ページ4に含まれる内容の要旨

For supplies, service, or assistance, call toll-free: 1-800-543-6650 (In the U.S.A.) or 1-800-263-4650 (In Canada) www.monarch.com