ページ1に含まれる内容の要旨
5350 Monochrome Laser Printer
Quick Start Guide
ページ2に含まれる内容の要旨
■ ■ ■ ■ ■ ■ ■ ■ Important Information This device fulfils the European standards requirements by complying with the Direc- This equipment generates and uses radio frequency energy tive of the Commission dated May 3, 1989 (89/336/EEC) relating to electromagnetic and if not installed and used properly, that is, in accordance compatibility and the Directive dated February 19, 1973 (73/23/EEC) relating to low- with the manufacturer's instructions, may cause interference voltage electrical equipm
ページ3に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite i Donnerstag, 9. November 2006 3:12 15 Quick Start Guide Table of contents Table of contents Chapter 1 Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 About this manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Conventions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 General Safety Guidelines . . . .
ページ4に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite ii Donnerstag, 9. November 2006 3:12 15 Table of contents Quick Start Guide Chapter 3 Installing Printer Drivers. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 Driver Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 TGNet Admin administration program . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 Chapter 4 Specifications. . . . . . . . . . . . . . . . . . . . .
ページ5に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite 1 Donnerstag, 9. November 2006 3:12 15 Quick Start Guide Chapter 1 Introduction Chapter 1 Introduction About this manual This quick start guide is intended to provide guidance for the proper installation of your printer. If you require more information to install your printer, consult the User Guide located on the CD-ROM. For further help, please contact your dealer or responsible representative (see addresses at the rear cover page of this manual).
ページ6に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite 2 Donnerstag, 9. November 2006 3:12 15 Chapter 1 Introduction Quick Start Guide General Safety Guidelines Before operating the printer, read the following instructions carefully: Follow all the operating procedures provided in this manual. Follow all the hazard warnings on the printer and in the manual. Failure to do so can cause injury to yourself or damage to the printer. Do not make perform any operation or action in any way other than provided
ページ7に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite 3 Donnerstag, 9. November 2006 3:12 15 Quick Start Guide Chapter 1 Introduction Printer Components 12 8 7 3 6 5 4 No. Name Description 1 Center output tray Print jobs are output with the printed side facing down. 2 Control panel Consists of operation buttons, indicators, and the display. 3 Ventilation hole Releases heat to prevent the interior of the printer from heating up. 4 Paper meter Indicates the amount of paper remaining. 5 Paper tray (A4/150 sheet
ページ8に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite 4 Donnerstag, 9. November 2006 3:12 15 Chapter 1 Introduction Quick Start Guide 1 4 5 6 1 23 No. Name Description 1 Ventilation hole Releases heat to prevent the interior of the printer from heating up. 2 Duplex module connector Connect the optional duplex module here. 3 Power cord connector Connect the power cord here. 4 USB port Connect the USB cable here. 5 Ethernet 10/100 port Connect the Ethernet cable here. 6 Parallel port Connect the parallel cable
ページ9に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite 5 Donnerstag, 9. November 2006 3:12 15 Quick Start Guide Chapter 1 Introduction 1 2 4 35 No. Name Description 1 Paper stopper Raise this when printing on paper larger than A4 size. 2 Toner Cartridge Contains the toner and the photosensitive drum. 3 Top cover Open this when replacing the Toner Cartridge and removing jammed paper. 4 Fuser unit Fixes the toner on the paper. Do not touch this when using the printer as it is hot. 5 Transfer roll cartridge Tr
ページ10に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite 6 Donnerstag, 9. November 2006 3:12 15 Chapter 2 Setting Up Your Printer Quick Start Guide Chapter 2 Setting Up Your Printer Checking Your Package Before installing the printer, check that all the items are contained in the package. Should any components be missing or damaged, contact your dealer. Toner Cartridge Power cord Printer Quick Start Guide and CD-ROM Paper tray (A4/150 sheets), paper tray (A4/550 sheets) 6
ページ11に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite 7 Donnerstag, 9. November 2006 3:12 15 Quick Start Guide Chapter 2 Setting Up Your Printer Preparing a Location for the Printer Dimensions Printer Height: 404 mm (15.9 in) Printer Width (left to right): 422 mm (16.6 in) Printer Depth (front to back): 465 mm (18.3 in) Installation Before unpacking your laser printer, it is recommended that you read the Precautions following to assist locating a suitable spot for your new laser printer. To make op
ページ12に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite 8 Donnerstag, 9. November 2006 3:12 15 Chapter 2 Setting Up Your Printer Quick Start Guide Never block the ventilation openings of the printer, otherwise the internal tem- perature will build up and cause a fire hazard. Do not place the printer near alcohol, benzine, or other volatile and flammable materials, or a fire hazard may result. Space A certain amount of space is required for proper operation of the printer and also Requirements for performing
ページ13に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite 9 Donnerstag, 9. November 2006 3:12 15 Quick Start Guide Chapter 2 Setting Up Your Printer Installation procedure Removing When the printer is first taken out of the packaging box, the covers of the printer the Tape are taped as shown in the diagram. Remove the tapes. Installing If you have purchased any optional accessories, please refer to the User Guide on Options the CD ROM. If there are no optional accessories to install, proceed to the next section
ページ14に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite 10 Donnerstag, 9. November 2006 3:12 15 Chapter 2 Setting Up Your Printer Quick Start Guide Installing the When installing the Toner Cartridge, take note of the following points: Toner Cartridge Never throw an Toner Cartridge into an open flame. It can cause an explosion and you can get STOP burned. Do not subject it to direct sunlight or strong light. When installing the Toner cartridge, select a location not subject to strong light and try to fi
ページ15に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite 11 Donnerstag, 9. November 2006 3:12 15 Quick Start Guide Chapter 2 Setting Up Your Printer 2 Take the Toner Cartridge out of the box and shake it 7 to 8 times as shown in the diagram. 3 Place the Toner Cartridge on a flat surface and pull the seal out horizontally. When pulling out the seal, pull it out horizontally. The tape might break if it is pulled out diagonally. After the seal has been pulled out, do not shake or bump the Toner Cartridge. 4
ページ16に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite 12 Donnerstag, 9. November 2006 3:12 15 Chapter 2 Setting Up Your Printer Quick Start Guide Do not touch any parts inside the printer. Ensure that the Toner Cartridge is firmly set. 5 Close the top cover securely. When printing text at 5% coverage, you can expect a toner cartridge life of approxi- mately 17,000 pages (10,000 pages for the toner cartridge that is shipped with the printer). 12
ページ17に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite 13 Donnerstag, 9. November 2006 3:12 15 Quick Start Guide Chapter 2 Setting Up Your Printer Loading Paper See the User Guide on CD-ROM for details on the type and size of paper that can be loaded in the paper tray. 1 Place the paper tray on a flat sur- face. 2 Remove the lid of the tray. 3 If the base plate of the paper tray is raised, push it down. 13 ENGLISH
ページ18に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite 14 Donnerstag, 9. November 2006 3:12 15 Chapter 2 Setting Up Your Printer Quick Start Guide 4 Squeeze the length guide and slide it to the desired paper size. 5 Squeeze the right width guide and slide it to the desired paper size. 6 Load the paper with the side to be printed facing up and with all 4 corners aligned. Make sure that the right width guide is correctly aligned with the paper size. Do not place paper over the right width guide. Do no
ページ19に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite 15 Donnerstag, 9. November 2006 3:12 15 Quick Start Guide Chapter 2 Setting Up Your Printer 7 Close the lid of the paper tray. 8 The lid of the tray must be firmly closed. If not, the paper might be misaligned. 15 ENGLISH
ページ20に含まれる内容の要旨
9035 Quick Start Guide-en.book Seite 16 Donnerstag, 9. November 2006 3:12 15 Chapter 2 Setting Up Your Printer Quick Start Guide Connecting the 1 Connect the power cord to the Power Cord power cord connector at the back of the printer. 2 Make sure that the power switch has been firmly pushed to the position and then insert the other end of the power cord to a correctly rated power outlet. If the power cord has an earth wire, connect it as well. Turning the 1 Press the power swi
