ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
Stylus CX Parts edge guide sheet feeder paper support feeder guard output extension tray scanner unit document table document control panel cover (See “Control Panel Functions” on page 11.) memory card slot USB cable connector adjust lever ink cartridge clamps
ページ3に含まれる内容の要旨
All in One Product All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. The information contained herein is designed only for use with this product. Epson is not responsible for any use of this information as applied to other printers. Neither Seiko Epson Corporation nor its aff
ページ4に含まれる内容の要旨
General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners. Epson disclaims any and all rights in those marks. Copyright © 2004 by Seiko Epson Corporation, Nagano, Japan. 2
ページ5に含まれる内容の要旨
Contents Safety Instructions Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Warnings, Cautions, and Notes. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Using the Control Panel Control Panel Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 LCD panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Buttons . . . . . . . . . . . . . .
ページ6に含まれる内容の要旨
Printing Directly from a Memory Card Printing Using an Index Form . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34 Printing an Index Form . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35 Printing photos by filling in the Index Form. . . . . . . . . . . . . . . . . 36 Printing one photo from an Index Form . . . . . . . . . . . . . . . . . . . . 37 Printing multiple photos from an Index Form . . . . . . . . . . . . . . . 38 Printing All Photos on a Memory
ページ7に含まれる内容の要旨
Transporting This Product . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 64 Troubleshooting Error Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 67 The Copied Image is Improperly Sized . . . . . . . . . . . . . . . . . . . . . . . . . 70 Clearing the Jammed Paper . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 71 Memory Card Caught Between the Memory Card Slot and the Memory Card Cover . . . . .
ページ8に含まれる内容の要旨
Safety Instructions Safety Instructions Read all of the instructions in this section when setting up and using this product. When placing this product ❏ Avoid places subject to rapid changes in temperature and humidity. Also, keep this product away from direct sunlight, strong light, and heat sources. ❏ Avoid places subject to dust, shocks, and vibrations. ❏ Leave enough room around this product for sufficient ventilation. ❏ Place this product near a wall outlet where you can easily plug i
ページ9に含まれる内容の要旨
When choosing a power source ❏ Use only the type of power source indicated on the label on the back of this product. ❏ Use only the power cord that comes with this product. Use of another cord may cause fire or electric shock. ❏ This product’s power cord is for use with this product only. Use with other equipment may cause fire or electric shock. ❏ Be sure your AC power cord meets the relevant local safety standards. ❏ Do not use a damaged or frayed power cord. ❏ If you use an extension cord
ページ10に含まれる内容の要旨
When handling ink cartridges ❏ Do not open the ink cartridge packages until just before you install them. ❏ When installing the new ink cartridge, shake it four to five times before opening its package. ❏ Do not shake the ink cartridge after removing from the package; this can cause leakage. ❏ Be careful not to break the hooks on the side of the ink cartridge when you remove it from its package. ❏ Keep the ink cartridge out of the reach of children. Do not allow children to handle it, or dr
ページ11に含まれる内容の要旨
When using this product ❏ Do not put your hand inside this product or touch the ink cartridges during printing. ❏ Do not block or cover the openings on this product. ❏ Do not attempt to service this product by yourself. ❏ Unplug this product and refer servicing to qualified service personnel under the following conditions: The power cord or plug is damaged; liquid has entered into this product; this product has been dropped or the cover damaged; this product does not operate normally or exhi
ページ12に含まれる内容の要旨
Warnings, Cautions, and Notes Warnings must be followed carefully to avoid bodily injury. w Cautions must be observed to avoid damage to your equipment. c Notes contain important information and useful tips on the operation of your product. Safety Instructions 10
ページ13に含まれる内容の要旨
Using the Control Panel Control Panel Functions LCD panel The LCD panel shows the current status of this product and helps you make various settings. The upper left area of the LCD panel shows the result of pressing the A button, the upper right for the B, the lower left for the C, and the lower right for the D button. When you turn on this product, it enters the mode selected the last time this product was turned off. The example below shows the state when this product is in the Copy Mode
ページ14に含まれる内容の要旨
Buttons Buttons Function P On Turns this product on and off. Copy Mode Enters the Copy Mode. Card Print Enters the Card Print Mode. Mode Scan Mode Enters the Scan Mode. Setup Mode Enters the Setup Mode. l Select/ Moves to the previous option. Save 3sec. When this product is in the Copy Mode, the current setting is saved by pressing and holding this button for 3 seconds. r Select/ Moves to the next setting. Recall 3sec. When this product is in the Copy Mode, the saved setting is recalled by pre
ページ15に含まれる内容の要旨
Lights Light Pattern Status ! Error On An error occurs. (For details, see “Troubleshooting” on page 67) Mode On Shows the mode this product is in. (Copy, Card Print, Scan, Setup) A, B, C, D On Indicates the button is valid. Adjusting the LCD panel density You can adjust the density of the LCD panel as follows. 1. Press the P On button to turn on this product. 2. Press the Setup Mode button to enter the Setup Mode. 3. Press the A or the l/r Select button repeatedly until 8.LCD Contrast appears
ページ16に含まれる内容の要旨
Copying This section describes how to make copies using the control panel. For information on making copies using a computer, see the Reference Guide. Note: When you make a copy using a control panel function, a moiré (cross-hatch) pattern may appear on your printout. To eliminate the moiré, change the reduce/enlarge ratio or shift the position of the original document. Overview of the Basic Procedure The instructions below provide an example on how to make copies in the Copy Mode. 1. Press
ページ17に含まれる内容の要旨
4. You can change the copy layout if necessary (see “Copying in Various Layouts” on page 20). Note: Be sure to change the copy layout first before changing the copy settings because all copy settings (paper type, print quality, number of copies, paper size) return to the default values when the copy layout changes. 5. You can change the copy settings, if necessary, by pressing the illuminating buttons. (When a button lights up, this indicates it valid.) To change each setting, see “Changing
ページ18に含まれる内容の要旨
Loading Paper Note: ❏ The print result is affected by the kind of paper you use. For the best quality, use the appropriate paper. ❏ To print on an envelope, refer to the Reference Guide. ❏ Keep enough space in front of this product for paper to be fully ejected. 1. Slide out the output extension tray. 2. Move the feeder guard towards you. Copying 16
ページ19に含まれる内容の要旨
3. Slide the left edge guide to the left so that the distance between the two edge guides is slightly wider than the paper you are going to load. 4. Fan the paper well, and then tap it on a flat surface to even the edges. 5. Load the paper in the sheet feeder with the face up, and the top edge down. Slide the edge guide to fit the width of the paper. Note: ❏ Make sure that the paper is loaded under the tabs inside the edge guides. 17 Copying
ページ20に含まれる内容の要旨
❏ Make sure that the paper stack is flush with or lower than the triangular load-limit mark on the edge guide. 6. Move the feeder guard back. Note: ❏ Always load paper before you start printing. ❏ The loading capacity differs depending on the following types of paper. Paper Type Loading Capacity Plain Paper Up to 150 sheets Bright White Ink Jet Paper Up to 125 sheets Glossy Photo Paper Up to 20 sheets Photo Paper Premium Semigloss Photo Paper Matte Paper-HeavyWeight DURABrite Photo Paper Up to
