ページ1に含まれる内容の要旨
MPS2
POWER SUPPLY
OWNER’S MANUAL
For use with preamp models
BP26, BP26DA, BP26MC, BP26P & BP1.5
and 10B-EPS crossovers
ページ2に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of un-insulated “dangerous voltage “ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompan
ページ3に含まれる内容の要旨
INTRODUCTION REMOTE ACTIVATION of OTHER EQUIPMENT VIA THE MPS2 Thank you for choosing this Bryston product. Bryston To turn on a Bryston amplifier by turning on the MPS2: welcomes any suggestions or comments you may have 1st) Connect insulated wires from the 2 pin REMOTE about our products. We consider you, our customer, to TRIGGER connector on the rear panel of the MPS2 be Bryston’s most important resource, and your opinion to the two IN terminals on a Bryston power amplifier is
ページ4に含まれる内容の要旨
MPS2 POWER SUPPLY REMOTE TRIGGER OUTput PINS SWITCHED TRIGGER OUTPUTS POWER SUPPLY CORD A 12Vdc signal will be present Whenever a BP26, which is Use only power sup- on the OUT pins of the Remote connected to one of the 4 ply cords supplied by Trigger Connector whenever MPS2 outputs, is turned on Bryston Ltd. to connect the MPS2 is activated. This and NOT muted, a control sig- the MPS2 power supply control signal can be used nal of 12Vdc will be present to other Bryston equip- to operate other
ページ5に含まれる内容の要旨
The MPS2 power supply can power several different Bryston products. Different products, however, may require different power supply interconnect cables, such as those shown shown below. It is important to use the correct power supply cable. WARNING! The connector terminals of main outputs 1, 2, 3 & 4 on the MPS2 power supply rear panel are HAZARDOUS LIVE and present a risk of electric shock. Use only preassembled power inter- connect cables provided by Bryston for connection of these termin
ページ6に含まれる内容の要旨
REPLACING FUSES IN THE MPS2 POWER SUPPLY CAUTION: These service instructions are for use by qualified service personnel only. To reduce the risk of electric shock do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. All fuses are 5mm x 20mm, time lag type and are accessible only by removing the top cover. When replacing fuses, disconnect the power cord before opening the unit! Recommended replacement fuses: 100V~ models: T 2
