ページ1に含まれる内容の要旨
UH036SX
Operating
Guide
To bring outstanding wireless communication products
to people's lives throughout the world.
ページ2に含まれる内容の要旨
CONTROL & INDICATORS INCLUDED IN YOUR UH036SX PACKAGE UH036SX x 2 Operating Guide Belt Clips x 2 dup ch/ vol/ scan mon mic RX TX 1 Antenna 9 Volume down/mon (monitor) Key 2 PTT (Push-To-Talk) Button 10 Microphone 3 Channel/scan up Key 11 Battery Compartment Door 4 Channel/scan down Key 12 Channel Indicator 5 Duplex Key 13 Receive Indicator 6 Speaker 14 Battery Low Indicator 7 Power On/Off Key 15 Transmit Indicator 8 Volume up/mon (monitor) Key 1
ページ3に含まれる内容の要旨
GETTING STARTED BATTERY WARNING To retain the previous user settings, the UH036 will continue to use a small amount of battery power when switched off. To prevent the batteries from running down, remove them from the radio if the UH036SX will not be used for long periods. BATTERY INSTALLATION Your UH036SX radio uses 3 AAA ALKALINE batteries for power. Use only good quality alkaline batteries for maximum life and range. Note: Batteries are not supplied. To avoid damage to the unit do not mix old
ページ4に含まれる内容の要旨
WATER WARNING Uniden does not represent this product to be waterproof. Do not expose this product to Rain or Moisture. BELT CLIP To attach the belt clip: Slide the belt clip until it snaps into Pinch Belt Clip and Latch place. To remove the belt clip: To remove the belt clip. Pinch and hold belt clip and latch (see arrows indicated) and slide the belt clip in the direction shown. LOW BATTERY ALERT If the Battery level becomes low, the battery indicator icon will appear on the LCD and begin flash
ページ5に含まれる内容の要旨
OPERATION POWER ON/OFF Press and hold to turn the Radio ON. The channel number will appear on the display. Press and hold to turn the Radio OFF. VOLUME Press volume or to increase or decrease the volume level. The dup ch/ vol/ scan mon Channel indicator will flash when the mic volume is being adjusted. ADJUSTING THE KEY BEEPS Your radio emits a beep each time one of the keys (except for the PTT button and the Key) are pressed. dup To turn OFF the beep: Press and hold the Key while turning ON the
ページ6に含まれる内容の要旨
SELECTING A CHANNEL Press channel or to select the desired channel. dup ch/ vol/ scan mon mic TO TRANSMIT AND RECEIVE The UH036SX uses the 40 UHF-CB Channels. For your reference a list of the available channels and corresponding frequencies is printed on page 10. 1. The transmit power of the UH036SX is 500mW which will PTT provide a range of up to 3+Km. Switch dup ch/ vol/ scan mon mic 2. Before you transmit, listen for activity on the selected channel. PTT 3. When the channel is clear, press an
ページ7に含まれる内容の要旨
For maximum range and extended the life of the batteries, avoid touching the antenna with your hand when transmitting. RX TX RX TX dup dup channel/ volume/ channel/ volume/ scan mon scan mon RANGE Maximum Range Reduced Range 6
ページ8に含まれる内容の要旨
AUTOMATIC SQUELCH FEATURE The UH036SX is equipped with an Automatic Squelch system which shuts off weak transmissions and unwanted noise. MONITOR This feature enables users to listen in for weak signals on the current channel at the press of a button. RX To use monitor, Press and hold Volume or for 2 seconds. The RX icon will begin to flash. For continuous listening. The receiver circuit will stay open, letting in both the noise & weak signals. To return to normal receive mode press Volume
ページ9に含まれる内容の要旨
TO OPERATE IN DUPLEX MODE Eg. CH1 is being used in your area for repeater use. dup Press momentarily. The icon appears. dup Press again to deactivate the duplex operation. UH036SX will return to normal operation. SCANNING The scan function scans all channels and stops at an active channel. When the signal stops, scanning resumes. To initiate scanning, 1. Assuming the unit is on CH1 when switched on. 2. Press and hold Channel or for 3 seconds and scanning starts. 3. Press Channel or ; dup ch/ vol
ページ10に含まれる内容の要旨
DROP-OUT DELAY While scanning, the UH036SX stops at a busy channel and receives the transmission. When the received signal is over, the unit will wait for 2 seconds for the return of the signal, otherwise, the radio resumes scanning. POWER SAVE Your UH036SX has a unique circuit designed to dramatically extend the life of the batteries. If there is no transmission nor an incoming call within 2 seconds, your Radio switches to the Power Save mode. The Radio is still able to receive transmissions in
ページ11に含まれる内容の要旨
UHF CHANNELS & FREQUENCIES Simplex Mode Duplex Mode Simplex Mode CH No. Transmit / Receive Transmit CH No. Transmit / Receive Frequency (MHz) Frequency (MHz) Frequency (MHz) 1 476.425 477.175 CH31 21 476.925 2 476.450 477.200 CH32 22 476.950 3 476.475 477.225 CH33 23 476.975 4 476.500 477.250 CH34 24 477.000 5 476.525 477.275 CH35 25 477.025 6 476.550 477.300 CH36 26 477.050 7 476.575 477.325 CH37 27 477.075 8 476.600 477.350 CH38 28 477.100 9 476.625 29 477.125 10 476.650 30 477.150 11 476.675
ページ12に含まれる内容の要旨
WARRANTY UNIDEN UH036SX UHF CB RADIO Limited One Year Warranty Please keep your sales docket as it provides evidence of warranty. Warrantor: Uniden Australia Pty Limited ACN 001 865 498 Uniden New Zealand Limited Warranty only available in original country of purchase Elements of Warranty: Uniden warrants to the original retail owner for the duration of this warranty, its UH036SX UHF CB Transceiver Radio (hereinafter referred to as the Product) to be free from defects in materials and craftsmans
