ページ1に含まれる内容の要旨
R737 R737 R737
R737 R737
3 3 3 3 3 Band Band Band Band Band Digital Digital Digital Digital Digital Preset Preset Preset Preset Preset Portable Portable Portable Portable Portable Radio Radio Radio Radio Radio
Please read this manual before use
ROBERTS
Sound for Generations
ページ2に含まれる内容の要旨
Controls (top panel) 14 2 3 5 6 7 8 9 10 11 12 13 FM ST MHz STANDBY 21 20 19 18 17 16 15 14 1. Headphone socket 6. Mono button 11. Liquid crystal display 16. FM button 2. Volume control 7. Sleep button 12. Tuning up button 17. MW button 3. Tone control 8. Memory button 13. Telescopic aerial 18. LW button 4. Standby button 9. Light button 14. Power button 19. Preset buttons 5. Mode button 10. Tuning indicator 15. Tuning down button 20. + 5 button 21. Standby switch 1
ページ3に含まれる内容の要旨
Controls (LH end) Liquid crystal display bc a FM MW LW ST M d MHz kHz STANDBY DC 9V PIN -ve f e PU9-B INPUT 240V 50Hz OUTPUT 9V 300mA 22 + - 22.DC Socket a. Waveband indicator b. Stereo indicator c. Memory indicator d. Low battery indicator e. Sleep time indicator f. Standby indicator 2
ページ4に含まれる内容の要旨
General Headphones Do not allow this unit to be exposed to water, steam or sand. Do not leave A 3.5mm socket (1) is provided for use with either stereo headphones or an the unit where excessive heat could cause damage such as in a parked car earpiece. Inserting a plug into this socket automatically mutes the internal where the heat from the sun can build up even though the outside loudspeaker. temperature may not seem too high. It is recommended that the FM band be used were ever possible as bet
ページ5に含まれる内容の要旨
Setting the clock Ensure the batteries are fitted and the power switch (14) is off. Press and hold the mode button (5) until the display starts to flash. Release the mode button. You now have 5 seconds to start the next procedure otherwise the display will stop flashing and return to showing normal time. Whilst the display is flashing use the tuning up button (12) to adjust the minutes and the tuning down button (15) to adjust the hours. After approx. 5 seconds the display will stop flashing and
ページ6に含まれる内容の要旨
Memory tuning You may store up to 25 stations in memory. 10 on FM, 10 on medium wave and 5 on long wave. Tune in the desired station as previously described. Press the memory button (8) to open the memory a flashing 'M' will appear in the display. While the 'M' is flashing press one of the preset buttons on which you want to store the station. Press the memory button (8) to store FM the station and close the memory. Repeat this procedure for the other 4 M presets. Note memory tuning can only be
ページ7に含まれる内容の要旨
Setting the standby time Ensure that the receiver is switched off. Press the mode button (5) once, the STANDBY symbol in the display will start to flash. STANDBY Press and hold down the mode button (5) until the symbol and the time shown in the display begin to flash. Release the mode button. You now have 5 seconds to start the next procedure otherwise the display will stop flashing and return to showing normal time. While the display is flashing use the tuning up button (12) to adjust the minu
ページ8に含まれる内容の要旨
Sleep timer The R737 has a built in sleep timer which will automatically switch off the receiver after the preset time has elapsed. Switch on the receiver and select the required station. Press and hold down the sleep button (7) the timer will count down from 90 minutes in 10 minute steps. Release the sleep button when the desired sleep time is reached. Sleep timer operation is shown by the symbol in the display. A further press of the sleep button will cancel the sleep timer. Low battery indica
ページ9に含まれる内容の要旨
Displaying the time Specifications While the radio is playing the time may be displayed by pressing the mode Power Requirements 9.0V button (5) once. After approximately 5 seconds the display will revert to Batteries 6 x IEC R14 (C size) showing frequency. Battery Life Approx. 60 hrs. of listening for 4 hours a day at Displaying the standby time normal volume using alkaline cells. While the radio is playing the standby time may be displayed by pressing Frequency Coverage the mode button (5) twi
ページ10に含まれる内容の要旨
Notes: 9
ページ11に含まれる内容の要旨
Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge. The guarantee does not cover: 1. Damage resulting from incorrect use. 2. Consequential damage. 3. Receivers with removed or defaced serial numbers. N.B. Damaged or broken telesco
ページ12に含まれる内容の要旨
ROBERTS RADIO TECHNICAL SERVICES DEPARTMENT 97-99 Worton Road Isleworth Middlesex TW7 6EG Technical Helpline:- 020 8758 0338 (Mon-Fri during office hours) Issue 5
